ATL00TA080

NTSB accident investigation · Bell OH-58C · Tampa, FL · August 8, 2000

Accident · No injuriesFinal report
Date
August 8, 2000, 18:30 local (22:30 UTC)
Place
Tampa, FL
Injuries
2 uninjured
Damage
Substantial damage
Phase of flight
Maneuvering
Aircraft
N9142SBell OH-58C
Weather
Visual (VMC) · Day
Status
Completed · report April 6, 2001
Report
Approved by Office Director
FAA report
20000808015389A
Case key
50022

From the NTSB’s public API. By law, NTSB reports can’t be used as evidence in lawsuits over the accident.

On this page

Probable cause

The NTSB’s determination of the probable cause, and any contributing factors.

The pilot's improper use of flight controls that resulted in low rotor induced oscillation during a practice autorotation.

Analysis

While attempting a practice 180-degree autorotative turn, an unusual vibration was felt in the airframe followed by a decrease in main rotor and engine rpm. The helicopter collided with the runway in a level attitude, bounced once, and then settled back onto the runway. The examination of the airframe disclosed that the tailboom was deformed and cracked but remained attached to the helicopter. The examination disclosed that the tailboom damage was associated with inflight low rotor induced oscillation and the airframe examination failed to disclose typical hard landing damage.

Factual narrative

The factual narrative409 words

On August 8, 2000, about 1830 eastern daylight time, a Bell OH-58C helicopter, N9142S, registered to and operated by the Hillsborough County Sheriffs Office, was substantially damaged when it collided with the ground during an attempted autorotation landing at Vandenberg Airport in Tampa, Florida. The helicopter-rated certified flight instructor (CFI) and one helicopter-rated commercial pilot were not injured. Visual meteorological conditions prevailed, and no flight plan was filed for the local instructional public use flight being conducted under Title 14 CFR Part 91. The flight originated from Tampa, Florida, at 1800.

According to the certified flight instructor, they were practicing 180-degree autorotation landings on runway 5 while performing a 90-day pilot competency ride as required by the Sheriff's Office. The maneuver was initiated from a left downwind for runway 5 from 600 feet above ground level (agl) at 60 knots of airspeed. The collective was lowered to the full down position and the throttle was rolled to the flight idle position and a left turn was initiated. Sixty knots of airspeed was maintained and at approximately one quarter of the way through the turn, the rotor speed began climbing out of the high side of the green arc. Collective pitch was adjusted to maintain rotor speed in the center of the green arch. At approximately 200 feet agl, full engine power restored and the rotor and turbine needles rejoined. After completing the 180-degree turn, an unusual vibration was felt and rotor and turbine RPM started to decay. The helicopter touched down on the runway in a level attitude, bounced once, then settled back onto the runway.

The examination of the helicopter disclosed that the tailboom was deformed and cracked but remained attached to the helicopter. Examination of the helicopter revealed no mechanical faults or failures. According to Bell Helicopter, the damage to the helicopter tailboom is normally associated to low rotor induced oscillation of the tail boom while the aircraft was still in flight. Examination of the helicopter failed to show structural damage associated with a hard landing.

An Operations Safety Notice, published by Bell Helicopter Textron on September 13, 1984, stated that tailboom and aft fuselage damage can occur during an autorotation landing if the main rotor RPM is allowed to decay below 70 percent. Applying collective pitch in excess of that required could result in excessive flapping of the main rotor during or after touch down. This can result in damage to the tailboom and/or aft fuselage.

Sequence of events

NTSB’s coding before 2008: each occurrence and phase of flight, and the causes and factors under it. The codes are defined in NTSB’s coding manual.

Loss of control - in flightManeuvering
Autorotation - initiatedPilot in command
Flight controls - improper use ofPilot in commandCause
In flight collision with terrain/waterLanding - flare/touchdown

Aircraft

Registration
N9142S
Reported as
Bell OH-58C
Category
Helicopter
Serial number
71-20670
Airframe hours
5,364
Engine
Allison T-63-A720, 420 horsepower, turbo shaft
Damage
Substantial damage
Flight
Public aircraft · Part 91
Registered owner
Hillsborough Cty Sheriffs Off.
Airworthiness certificate
Special, Special flight (Special)
Last inspection
100 hour · June 26, 2000 · 91 hours before
Departed
X16
Airport
X16 · Vandenberg, runway 5, 5,000 × 100 ft, asphalt

Matched to the registry by N-number and the event date; the registry’s history has gaps, so older matches can be wrong. Compare the reported make and model.

Flight crew

As NTSB recorded them. NTSB leaves out names.

Role
Pilot
Age
53
Certificates
Commercial, Private
Airplane ratings
Single-engine land, Multi-engine land
Instrument ratings
Airplane
Medical
Class 2, Valid Medical--w/ waivers/lim
Seat
Right
Flight hours
1,150 total · 392 in this make and model · 952 as pilot in command · 60 in the last 90 days · 20 in the last 30 days · 3 in the last 24 hours

Weather

Conditions
Visual (VMC) · Day
Wind
80° at 6 knots
Visibility
10 statute miles
Lowest ceiling
None
Temperature
91 °F, dew point 70 °F
Altimeter
30.00 inHg
Observed at
TPA, 11 nm away

FAA reports on this event · 1

The FAA’s own accident and incident reports, matched to the aircraft by N-number and date.