- Date
- June 1, 1992, 16:30 local (20:30 UTC)
- Place
- Weeksville, NC
- Injuries
- 5 uninjured
- Damage
- Substantial damage
- Phase of flight
- Takeoff
- Aircraft
- N600LPAirship Industries Airship 600
- Weather
- Visual (VMC) · Day
- Status
- Completed · report June 11, 1993
- Report
- Approved by Office Director
- FAA report
- 19920601053679A
- Case key
- 8615
From the NTSB’s public API. By law, NTSB reports can’t be used as evidence in lawsuits over the accident.
On this page
Probable cause
The improper installation of the elevator control cables by repair facility maintenance personnel, the inspector's inadequate inspection of the maintenance accomplished, and his failure to follow delineated procedures. An additional cause was the inadequate preflight inspection by the pilot in command, in that he failed to confirm correct control surface movement as required by the pre-unmasting checklist.
Sequence of events
NTSB’s coding before 2008: each occurrence and phase of flight, and the causes and factors under it. The codes are defined in NTSB’s coding manual.
Analysis
The airship was being flown on a post maintenance inspection flight following an annual inspection. After release from the mooring truck the airship rose about 150 feet then pitched over. Full aft movement of the control yoke for nose pitch up was ineffective. The airship then collided with the vehicle mounted mooring mast which punctured the air bag. Examination of the airship revealed that the elevator control cables were rigged backwards. During the annual inspection the elevator had been removed & re-installed. The inspector who signed off the inspection papers demonstrated, & stated, that his inspection procedure was accomplished alone. He pushed on the elevator with his hand to check elevator deflection. He did not have a second person activate the cockpit control, to ensure elevator movement in the proper direction, as required by the maintenance manual. The flight crew pre-unmasting procedure required that a ground crew man be used to confirm correct control surface movement.
Aircraft
- Registration
- N600LP
- Reported as
- Airship Industries Airship 600 (AIRSHIP 60)
- Category
- Blimp
- Serial number
- 1215-05
- Airframe hours
- 5,827
- Engine
- Porsche 930/67, 255 horsepower, reciprocating
- Damage
- Substantial damage
- Flight
- Part 91
- Operator
- Airship International
- Registered owner
- Orix USA Corp.
- Airworthiness certificate
- Standard, Normal
- Last inspection
- Annual · June 1, 1992 · 1 hours before
- Departed
- ECG
- Airport
- NONE · Airship Industries
Flight crew
As NTSB recorded them. NTSB leaves out names.
- Role
- Pilot
- Age
- 45
- Certificate
- Airline transport
- Airplane ratings
- Single-engine land, Multi-engine land
- Instrument ratings
- Airplane
- Medical
- Class 1, Valid Medical--w/ waivers/lim
- Seat
- Left
- Flight hours
- 9,500 total · 1,800 in this make and model · 9,100 as pilot in command · 100 in the last 90 days · 25 in the last 30 days
Weather
- Conditions
- Visual (VMC) · Day
- Wind
- 320° at 10 knots
- Visibility
- 10 statute miles
- Lowest ceiling
- 25,000 ft overcast
- Temperature
- 70 °F
- Observed at
- ECG, 1 nm away
FAA reports on this event · 1
The FAA’s own accident and incident reports, matched to the aircraft by N-number and date.