DEN01LA156

NTSB accident investigation · Aerospatiale AS350BA · Kemmerer, WY · September 6, 2001

Accident · No injuriesLimited investigationFinal report
Date
September 5, 2001, 18:30 local (Sep 6, 2001, 00:30 UTC)
Place
Kemmerer, WY
Injuries
1 uninjured
Damage
Substantial damage
Phase of flight
Taxi
Aircraft
N57843Aerospatiale AS350BA
Weather
Visual (VMC) · Day
Status
Completed · report February 20, 2002
Report
Approved by Office Director
Parties
FAA Flight Standards Field Office
FAA report
20010905025139A
Case key
53183

From the NTSB’s public API. By law, NTSB reports can’t be used as evidence in lawsuits over the accident.

On this page

Probable cause

the loss of tail rotor effectiveness while air taxiing. Contributing factors were the high winds and gusts, and the pilot's limited experience in aircraft make/model.

Sequence of events

NTSB’s coding before 2008: each occurrence and phase of flight, and the causes and factors under it. The codes are defined in NTSB’s coding manual.

Loss of control - in flightTaxi - aerial
Lack of total experience in type of aircraftPilot in commandFactor
Loss of tail rotor effectiveness - encounteredPilot in commandCause
Weather condition - high windFactor
Weather condition - gustsFactor
In flight collision with terrain/waterDescent - uncontrolled

Analysis

The pilot was aerial taxiing the helicopter to a parking area at 10 knots and into a slight quartering headwind. There was some thunderstorm activity west of the airport, and the nearest recorded winds were from 260 degrees at 20 knots, with gusts to 36 knots. As he turned towards the tie down area, there was a strong gust of wind from the left. The helicopter yawed to the left and full right pedal had no effect on arresting the spin. The helicopter struck the ground and rolled over. The pilot had 4,000 total flight hours in helicopters, but had recently transitioned to this make and model helicopter and had 8 hours in type.

Factual narrative

On September 5, 2001, at 1830 mountain daylight time, an Aerospatiale AS350BA, N57843, operated by Crew Concepts, Inc., of Boise, Idaho, was substantially damaged when it collided with terrain during aerial taxi at the Kemmerer Municipal Airport, Kemmerer, Wyoming. The commercial pilot, the sole occupant aboard, was not injured. Visual meteorological conditions prevailed, and no flight plan had been filed for the positioning flight being conducted under Title 14 CFR Part 91. The flight originated from Pocatello, Idaho, at an undetermined time.

In a telephone interview with the pilot, he said he was bringing the helicopter to Kemmerer for seismic survey support. He was aerial taxiing over the taxiway parallel to runway 16 when the helicopter started spinning. Opposite anti-torque pedal input had no effect in arresting the spin. The helicopter struck the ground, and rolled over on its side. The tail boom was severed and the main rotor system was torn from its mounts. Recorded winds at Evanston, Wyoming, located 52 miles southwest of Kemmerer, were from 260 degrees at 25 knots, gusting to 36 knots. The peak wind, recorded at 1929, was from 240 degrees at 47 knots.

Upon learning of the accident, the operator dispatched its investigator to the accident scene to conduct a company investigation. According to his report, the pilot said he was aerial taxiing at 10 knots into a slight quartering headwind. There was some thunderstorm activity west of the airport. As the pilot turned towards the tie down area, "a very strong gust of wind seemed to hit the aircraft on the left side." The helicopter yawed to the left and full right pedal had no effect on arresting the counterclockwise spin. The report stated that the pilot lost control "due to severe/weather conditions...The application of full right pedal to correct yaw with no effect precipitated the situation whereby the pilot lost tail rotor effectiveness once the counterclockwise spin began." The report noted that Eurocopter, the helicopter manufacturer, issued Service Letter 1518-67-01 in April 2001, that described three similar mishaps. The report concluded, "Pilots must ensure that the application of LEFT pedal inputs are very slight with immediate correction using right pedal. Additionally, pilots are not to apply LEFT pedal inputs while passing through 'translational lift.' This restriction is to preclude the possibility of 'tail rotor vortex ring state' which may result in a spin to the left from which recovery is not possible."

According to the operator, the pilot had 4,000 total flight hours in helicopters. He had recently transitioned to, and had 8 hours in, the AS350.

Aircraft

Registration
N57843
Reported as
Aerospatiale AS350BA
Category
Helicopter
Serial number
1430
Engine
Turbomeca Arriel 1B, 529 horsepower, turbo shaft
Damage
Substantial damage
Flight
Positioning · Part 91
Operator
Crew Concepts, Inc.
Registered owner
Roberts Aircraft Co.
Airworthiness certificate
Standard, Normal
Departed
PIH · Pocatello, ID
Destination
EMM · Kemmerer, WY
Airport
EMM · Kemmerer Municipal

Flight crew

As NTSB recorded them. NTSB leaves out names.

Role
Pilot
Age
41
Injuries
None
Certificates
Flight instructor, Commercial
Instrument ratings
Helicopter
Medical
Class 2, Valid Medical--no waivers/lim.
Last flight review
August 1, 2001
Seat
Right
Flight hours
3,900 total · 8 in this make and model · 3,600 as pilot in command · 45 in the last 90 days · 8 in the last 30 days · 3 in the last 24 hours

Weather

Conditions
Visual (VMC) · Day
Wind
260° at 25 knots, gusting 36
Visibility
10 statute miles
Lowest ceiling
11,000 ft broken
Temperature
64 °F, dew point 36 °F
Altimeter
30.00 inHg
Observed at
EVW, 52 nm away

FAA reports on this event · 1

The FAA’s own accident and incident reports, matched to the aircraft by N-number and date.