- Date
- December 16, 2017, 12:30 local (17:30 UTC)
- Place
- Burlington, NC
- Injuries
- 3 uninjured
- Phase of flight
- Enroute
- Defining events
- Enroute-cruise: Midair collisionManeuvering: Midair collision
- Weather
- Visual (VMC) · Day
- Status
- Completed · report July 23, 2019
- Report
- Approved by Office Director
- NTSB office
- Eastern Region Aviation
- Parties
- FAA/FSDO
- FAA report
- 20171216023182A
- Case key
- 96526
From the NTSB’s public API. By law, NTSB reports can’t be used as evidence in lawsuits over the accident.
On this page
Probable cause
The pilot's failure to maintain adequate clearance from another airplane before beginning an inverted flight maneuver, which resulted in a collision with the airplane when he rolled his airplane upright.
The other pilot's failure to maintain adequate clearance from the airplane before beginning an inverted flight maneuver, which resulted in a collision with the airplane when he rolled his airplane upright.
Findings · 4
NTSB’s coded findings. Those marked are part of the probable cause; the rest are factors or other findings. Under each, the cases with the same finding.
N199RN · Cessna 182
N25786 · Piper J3C
Sequence of events
The events NTSB coded, in order, by phase of flight. The defining event is the one that best describes the accident. Under each, the cases with the same event anywhere in their sequence.
N199RN · Cessna 182
N25786 · Piper J3C
Analysis
The commercial pilot of the Piper airplane reported that he had recently performed maintenance on the smoke generator. Before the flight, the Piper pilot coordinated with the pilot of a Cessna to fly adjacent to his airplane to verify whether the Piper's smoke system was operating. After departure, the Piper pilot flew on the right side of and parallel to the Cessna, and both pilots acknowledged each other visually. The Cessna pilot subsequently verified that the Piper's smoke system was operating normally with a "thumbs up" signal, and the Piper pilot then broke off to the right, and the Cessna pilot continued straight ahead. After clearing for traffic, the Piper pilot then performed a check of the oil system and mixture control, which required inverted flight. He rolled the airplane inverted, verified the system operation, and then rolled the airplane upright, at which point its right wing collided with the Cessna's left wing. The Cessna pilot saw the Piper strike his airplane while in a descent. The Piper pilot stated that he never saw the Cessna and thought he was experiencing a flight control problem after the collision. Both airplanes returned to the departure airport and landed without further incident. The Piper's right wing and aileron and the Cessna's left wing were structurally damaged. The Cessna pilot was flying straight ahead, and the Piper pilot was maneuvering; therefore, the Piper pilot was responsible for ensuring that the area was clear before initiating the inverted maneuver. Given the described geometry of the collision, the Piper pilot likely did not adequately clear for traffic before beginning the inverted flight maneuver, which he should have done, and failed to see the Cessna before impacting its left wing.
The commercial pilot of the Piper airplane reported that he had recently performed maintenance on the smoke generator. Before the flight, the Piper pilot coordinated with the pilot of a Cessna to fly adjacent to his airplane to verify whether the Piper's smoke system was operating. After departure, the Piper pilot flew on the right side of and parallel to the Cessna, and both pilots acknowledged each other visually. The Cessna pilot subsequently verified that the Piper's smoke system was operating normally with a "thumbs up" signal, and the Piper pilot then broke off to the right, and the Cessna pilot continued straight ahead. After clearing for traffic, the Piper pilot then performed a check of the oil system and mixture control, which required inverted flight. He rolled the airplane inverted, verified the system operation, and then rolled the airplane upright, at which point its right wing collided with the Cessna's left wing. The Cessna pilot saw the Piper strike his airplane while in a descent. The Piper pilot stated that he never saw the Cessna and thought he was experiencing a flight control problem after the collision. Both airplanes returned to the departure airport and landed without further incident. The Piper's right wing and aileron and the Cessna's left wing were structurally damaged. The Cessna pilot was flying straight ahead, and the Piper pilot was maneuvering; therefore, the Piper pilot was responsible for ensuring that the area was clear before initiating the inverted maneuver. Given the described geometry of the collision, the Piper pilot likely did not adequately clear for traffic before beginning the inverted flight maneuver, which he should have done, and failed to see the Cessna before impacting its left wing.
Factual narrative
On December 16, 2017, about 1230 eastern standard time, a Cessna 182Q, N199RN, and a Piper J3C-65, N25786, collided in midair near Burlington-Alamance Regional Airport (BUY), Burlington, North Carolina. The private pilot of the Cessna and the commercial pilot of the Piper were not injured. The Cessna and the Piper both sustained substantial damage. Both flights were conducted under the provisions of Title 14 Code of Federal Regulations part 91 as personal flights. Day, visual meteorological conditions prevailed, and no flight plans were filed for either flight. The flights originated at BUY about 1220.The Piper pilot reported that he had recently performed maintenance on the smoke generator system and installed a new fuel pump. Prior to the flight, he asked the Cessna pilot to fly adjacent to him to verify the smoke system operation. After departure, the Piper pilot flew on the right side of the Cessna and both pilots acknowledged each other visually. The Piper pilot turned on the smoke system and the Cessna pilot verified that it operated normally with a "thumbs up" signal. The Piper pilot then broke off to the right to leave the formation. The Piper pilot subsequently elected to fly inverted to check the oil system and mixture control. After clearing for traffic and tightening his harness, he rolled inverted. The systems operated normally, so he rolled again to level the airplane upright. During the return to level flight, he heard a loud noise and the airplane rolled to the right. He believed that he had experienced aileron flutter. He was able to control the airplane and returned to BUY and landed without further incident. It was after landing that he realized that he had collided with the Cessna. The Cessna pilot reported that, after checking the smoke system on the Piper and giving a thumbs up signal, the Cessna pilot climbed and disappeared from view due to the high wing on the Cessna. Subsequently, while still in straight and level flight, he observed a flash of yellow at his 9 o'clock position, which was the Piper in a descent. He reported that the Piper struck his left wing. He was able to maintain airplane control and returned to BUY for landing. An inspector with the Federal Aviation Administration examined both airplanes. The right wing and aileron of the Piper were structurally damaged, as was the outboard portion of the Cessna's left wing. Numerous paint transfer marks were noted on both airplanes. No other damage was noted.
On December 16, 2017, about 1230 eastern standard time, a Cessna 182Q, N199RN, and a Piper J3C-65, N25786, collided in midair near Burlington-Alamance Regional Airport (BUY), Burlington, North Carolina. The private pilot of the Cessna and the commercial pilot of the Piper were not injured. The Cessna and the Piper both sustained substantial damage. Both flights were conducted under the provisions of Title 14 Code of Federal Regulations part 91 as personal flights. Day, visual meteorological conditions prevailed, and no flight plans were filed for either flight. The flights originated at BUY about 1220.The Piper pilot reported that he had recently performed maintenance on the smoke generator system and installed a new fuel pump. Prior to the flight, he asked the Cessna pilot to fly adjacent to him to verify the smoke system operation. After departure, the Piper pilot flew on the right side of the Cessna and both pilots acknowledged each other visually. The Piper pilot turned on the smoke system and the Cessna pilot verified that it operated normally with a "thumbs up" signal. The Piper pilot then broke off to the right to leave the formation. The Piper pilot subsequently elected to fly inverted to check the oil system and mixture control. After clearing for traffic and tightening his harness, he rolled inverted. The systems operated normally, so he rolled again to level the airplane upright. During the return to level flight, he heard a loud noise and the airplane rolled to the right. He believed that he had experienced aileron flutter. He was able to control the airplane and returned to BUY and landed without further incident. It was after landing that he realized that he had collided with the Cessna. The Cessna pilot reported that, after checking the smoke system on the Piper and giving a thumbs up signal, the Cessna pilot climbed and disappeared from view due to the high wing on the Cessna. Subsequently, while still in straight and level flight, he observed a flash of yellow at his 9 o'clock position, which was the Piper in a descent. He reported that the Piper struck his left wing. He was able to maintain airplane control and returned to BUY for landing. An inspector with the Federal Aviation Administration examined both airplanes. The right wing and aileron of the Piper were structurally damaged, as was the outboard portion of the Cessna's left wing. Numerous paint transfer marks were noted on both airplanes. No other damage was noted.
Aircraft · 2
- Registration
- N199RN
- Reported as
- Cessna 182 (Q)
- Category
- Airplane
- Serial number
- 18266079
- Built
- 1977
- Engine
- Cont Motor O-470 SERIES, 230 horsepower, reciprocating
- Damage
- Substantial damage
- Flight
- Personal · Part 91
- Airworthiness certificate
- Standard, Normal
- Departed
- BUY · Burlington, NC
- Destination
- BUY · Burlington, NC
- Airport
- BUY · Burlington Alamance Regional
- Equipment
- Stall warning system, ADS-B, Auto-pilot, Electronic multifunction display, Electronic primary flight display
Matched to the registry by N-number and the event date; the registry’s history has gaps, so older matches can be wrong. Compare the reported make and model.
- Registration
- N25786
- Reported as
- Piper J3C (65)
- Category
- Airplane
- Serial number
- 3740
- Built
- 1939
- Airframe hours
- 2,096
- Engine
- Cont Motor O-200 Exp, 100 horsepower, reciprocating
- Damage
- Substantial damage
- Flight
- Personal · Part 91
- Airworthiness certificate
- Special, Experimental (Special)
- Last inspection
- Condition · July 20, 2017 · 45 hours before
- Departed
- BUY · Burlington, NC
- Destination
- BUY · Burlington, NC
- Airport
- BUY · Burlington Alamance Regional
- Equipment
- Unknown
Matched to the registry by N-number and the event date; the registry’s history has gaps, so older matches can be wrong. Compare the reported make and model.
Flight crew · 2
As NTSB recorded them. NTSB leaves out names.
- Role
- Pilot, aircraft N199RN
- Age
- 31
- Injuries
- None
- Certificate
- Private
- Airplane ratings
- Single-engine land
- Instrument ratings
- Airplane
- Medical
- Class 3, Without waivers/limitations
- Last flight review
- June 26, 2016
- Seat
- Left
- Restraint
- 3-point
- Flight hours
- 353 total · 11 in this make and model · 353 as pilot in command · 20 in the last 90 days · 5 in the last 30 days
- Role
- Pilot, aircraft N25786
- Age
- 45
- Injuries
- None
- Certificate
- Commercial
- Airplane ratings
- Single-engine land
- Instrument ratings
- Airplane
- Medical
- Class 2, With waivers/limitations
- Seat
- Rear
- Restraint
- 5-point
- Flight hours
- 2,500 total · 500 in this make and model
Weather
- Conditions
- Visual (VMC) · Day
- Wind
- 250° at 7 knots
- Visibility
- 10 statute miles
- Lowest ceiling
- None
- Temperature
- 48 °F, dew point 23 °F
- Altimeter
- 30.20 inHg
- Observed at
- BUY, 10 nm away
Docket · 8
The files NTSB released with the investigation on February 7, 2019, on NTSB’s docket system: statements, records, photos and specialists’ reports. 4.8 MB in all.
FAA reports on this event · 1
The FAA’s own accident and incident reports, matched to the aircraft by N-number and date.