- Date
- May 16, 2003, 16:30 local (22:30 UTC)
- Place
- Fabens, TX
- Injuries
- 1 uninjured
- Damage
- Substantial damage
- Phase of flight
- Approach
- Aircraft
- N478RDCessna A188B
- Weather
- Visual (VMC) · Day
- Status
- Completed · report December 30, 2003
- Report
- Approved by Office Director
- Parties
- FAA Flight Standards
- FAA report
- 20030516011329A
- Case key
- 57000
From the NTSB’s public API. By law, NTSB reports can’t be used as evidence in lawsuits over the accident.
On this page
Probable cause
The pilot's failure to maintain terrain clearance. The pilot's attempt to avoid an obstacle was a contributing factor.
Sequence of events
NTSB’s coding before 2008: each occurrence and phase of flight, and the causes and factors under it. The codes are defined in NTSB’s coding manual.
Analysis
The tailwheel-equipped airplane drifted off the right side of the 4,200 feet long, 60 feet wide asphalt runway during the landing roll. The 1,100-hour pilot attempted to go around. During the attempt to go around, the airplane struck the top of a sand dune with the main landing gear. The pilot attempted to avoid a hill directly in front of him and attempted to turn the airplane to the left. Subsequently, the airplane struck a second sand dune with the main landing gear and tailwheel and landed hard coming to rest upright. The pilot reported the wind was from approximately 340 degrees at 5 knots at the time of the accident.
Factual narrative
On May 16, 2003, at 1630 mountain daylight time, a Cessna A188B tailwheel-equipped agricultural airplane, N478RD, registered to and operated by C&D Aerial Applications of Clint, Texas, sustained substantial damage during landing roll following a loss of directional control at Fabens Airport (E35), Fabens, Texas. The commercial pilot, who was the sole occupant of the airplane, was not injured. Visual meteorological conditions prevailed, and a flight plan was not filed for the 14 Code of Federal Regulations Part 91 personal flight. The local flight departed from E35 at 1430.
The 1,100-hour pilot reported in the Pilot/Operator Aircraft Accident Report (NTSB Form 6120.1/2) that he was on final approach for runway 26, a 4,200 foot long, 60 foot wide asphalt runway, with two notches of flaps set. While on final, he noted a slight right crosswind was present. At approximately 70 knots, the airplane set down on the runway with its main landing gears. As the airplane started to slow and the tail of the airplane started to settle at approximately 60 knots, "a sudden abrupt drift to the right was experienced." He then made control movements as the "drift became more abrupt." The pilot stated, as the edge of the runway was eminent, full power was applied for "go-around procedures" and before he could remove one notch of flaps, the airplanes main landing gear struck a sand dune.
The pilot further stated that he attempted to turn the airplane to the left and avoid a hill directly in front of him. He made control movements, and reduced the power to idle. Nearing a second sand dune, he added full power and back pressure on the control stick "to keep a nose high attitude on impact." Subsequently, the airplane impacted the sand dune with the main landing gear and tailwheel. The airplane started "fish hooking" to the right coming to rest upright.
The FAA inspector, who responded to the accident site, reported that the right main landing gear was sheared off. The right wing was bent and partially separated from the fuselage. The right horizontal stabilizer and elevator were partially separated and bent.
El Paso International Airport (ELP), near El Paso, Texas, located 21 miles north of the accident site was the nearest weather reporting station. At 1651, ELP was reporting wind from 280 degrees at 9 knots, few clouds at 9,000 msl, with a visibility of 10 statue miles. The temperature was 33 degrees Celsius, and the dew point was 2 degree Celsius.
The pilot reported that the wind was from 340 degrees, at approximately 5 knots at the time of the accident.
Aircraft
- Registration
- N478RD
- Reported as
- Cessna A188B
- Category
- Airplane
- Serial number
- 18802609
- Airframe hours
- 6,766.8
- Engine
- Continental IO-520-D, 300 horsepower, reciprocating
- Damage
- Substantial damage
- Flight
- Personal · Part 91
- Registered owner
- David Armstrong
- Airworthiness certificate
- Special, Restricted (Special)
- Last inspection
- Annual · May 5, 2003 · 10 hours before
- Departed
- E35 · Fabens, TX
- Destination
- E35 · Fabens, TX
- Airport
- E35 · Fabens, runway 26, 4,200 × 60 ft, asphalt
Matched to the registry by N-number and the event date; the registry’s history has gaps, so older matches can be wrong. Compare the reported make and model.
Flight crew
As NTSB recorded them. NTSB leaves out names.
- Role
- Pilot
- Age
- 35
- Injuries
- None
- Certificate
- Commercial
- Airplane ratings
- Single-engine land
- Medical
- Class 2, Valid Medical--no waivers/lim.
- Last flight review
- April 11, 2003
- Seat
- Center
- Flight hours
- 1,100 total · 200 in this make and model · 980 as pilot in command · 350 in the last 90 days · 100 in the last 30 days · 5 in the last 24 hours
Weather
- Conditions
- Visual (VMC) · Day
- Wind
- 280° at 9 knots
- Visibility
- 10 statute miles
- Lowest ceiling
- None
- Temperature
- 91 °F, dew point 36 °F
- Altimeter
- 30.03 inHg
- Observed at
- ELP, 21 nm away
FAA reports on this event · 1
The FAA’s own accident and incident reports, matched to the aircraft by N-number and date.