FTW99FA074

During the global positioning system (GPS) runway 5 approach to Hot Springs Memorial Airport, in instrument meteorological conditions, the twin-engine airplane impacted mountainous terrain at 1,020 feet msl, about one nautical mile (nm) right of the final approach course, and approximately 9 nm southwest of the airport. According to the approach plate, the airplane should have been at an altitude no lower than 2,300 feet on this segment of the approach. The last radar hit recorded was at 1622:44, as the airplane was descending through 2,800 feet, 14.2 nautical miles southwest of the airport. Two witnesses located near the accident site reported that about 1630 they heard a small aircraft coming from southwest of their farm, heading towards them at a 'very low' altitude. They heard the aircraft for about 10 seconds, then the sound of the engines was 'gone.' The witnesses also reported that the weather was 'extremely foggy,' and that they could not see the top of the mountain located behind their property. The missed approach procedure for the approach calls for a climbing right turn to 3,000 feet. Examination of the accident site indicated the airplane impacted trees while in a right turn. No anomalies were found with the airframe or engines that would have prevented normal operation.

History of flight

On January 29, 1999, approximately 1630 central standard time (CST), a Beech 95-B55 twin-engine airplane, N260LH, was destroyed upon impact with mountainous terrain near Pearcy, Arkansas. The instrument rated commercial pilot and his sole passenger sustained fatal injuries. The airplane was owned and operated by Hi Tech Engineering, Inc., of Hot Springs, Arkansas. Instrument meteorological conditions prevailed, and an instrument flight rules (IFR) flight plan was filed for the 14 Code of Federal Regulations Part 91 business flight. The cross-country flight originated from Hattiesburg, Mississippi, about 1417, and was en route to Hot Springs. At the time of the accident, the airplane was executing a global positioning system (GPS) instrument approach to runway 05 (Rwy 5) at the Hot Springs Memorial Airport.

Federal Aviation Administration records revealed that the pilot called the Greenwood Automated Flight Service Station (AFSS) by telephone at 1314, and obtained an abbreviated pilot weather briefing for an IFR flight from Hattiesburg, Mississippi, to Hot Springs, Arkansas. After receiving the weather briefing, the pilot filed an IFR flight plan from Hattiesburg to Hot Springs.

Following takeoff from Hattiesburg, the pilot established initial contact with Memphis Air Route Traffic Control Center (ARTCC) at 1426. At 1555, the pilot was advised to expect holding at Hot Springs. At 1557, the pilot was cleared to the Hot Springs VOR and instructed to maintain 6,000 feet msl. The pilot acknowledged the clearance. The pilot was then instructed to descend and maintain 5,000 feet. The pilot reported out of 6,000 for 5,000 feet and requested to proceed to Hossy (the final approach fix for the GPS Rwy 5 approach) and hold. Memphis Center cleared the aircraft to proceed to Hossy, hold as published, and maintain 5,000 feet. The pilot acknowledged the clearance.

At 1601, the pilot was given the Hot Springs weather as "... the wind zero seven zero at ten knots visibility one zero miles overcast four hundred..." The pilot requested to go to the Marki waypoint on the GPS Rwy 5 approach "and then turn inbound." The controller cleared the pilot to proceed direct to Marki and hold southwest. The pilot then requested to "hold between marki and skimp intersection." (Skimp waypoint is located between Marki and Hossy on the GPS Rwy 5 approach.) The controller replied "that's fine I don't have the approach plates sir you can hold at your discretion."

At 1602, the controller cleared the pilot "direct skimp and you can hold southwest on the ah two three zero radial ah southwest of skimp expect ah clearance expect further clearance two two one five [1615 CST]." The pilot did not acknowledge the clearance. After reestablishing radio communications with the airplane, the controller instructed the pilot to change to frequency 118.85. At 1604, the pilot was given the Hot Springs altimeter setting, and the controller reissued the holding instructions and the expect further clearance time. The pilot acknowledged, "two two one five and hold on the ah two three zero degree radial at skimp, zero lima hotel wilco and say altimeter sir."

At 1612, the pilot was instructed to maintain 3,000 feet until Skimp, and "cleared gps runway five approach to hot springs." The pilot replied, "I tell you what sir, why don't you go ahead and get some of that traffic off of hot springs if you can, and I'll just hold out here for a few more minutes, we're bout ah six miles out of skimp now at five, we'll start our descent down." The controller replied, "okay well maintain five for right now sir."

At 1617, the controller inquired if the pilot wanted to start the approach at the initial approach fix Hossy, or from Skimp. The pilot replied, "like to start at skimp, we'll just hold between skimp and marki as soon as you give me the clearance to get me down I'll turn in." The pilot offered to let a Lear Jet land first; however, the controller informed the pilot he would have to go ahead of the Lear Jet.

At 1619, the pilot was instructed to descend and maintain 3,500 feet. The pilot reported out of 5,000 for 3,500 feet. At 1620, the controller instructed the pilot to "maintain ah 3,000 until skimp, cleared ah gps approach to hot springs." The pilot acknowledged the clearance.

At 1622:05, the pilot reported, "established on the localizer inbound sir for the gps runway five." The controller replied "frequency change approved, report your arrival time on this freq or your ah arrival on this frequency." The pilot acknowledged. Memphis ARTCC had no further communications with the pilot. See the enclosed communication transcripts.

Radar data was obtained from Memphis ARTCC. A plot of the radar data showed the aircraft did not hold southwest of Skimp on the inbound course as instructed, but held south of Skimp using non-standard turns (left). At 1621:32, the radar data indicated the airplane was over Skimp at 3,300 feet, entered a turn to the right and continued on a northeast heading towards the airport. The last radar hit recorded was at 1622:44, as the airplane was descending through 2,800 feet, 14.2 nautical miles southwest of the airport. See the enclosed NTSB radar study.

According to the Director of the Hot Springs Memorial Airport, at approximately 1630, the pilot of a Big Sky Airlines airplane heard the accident pilot call "5 miles" on the airport's common traffic advisory frequency.

Two witnesses, located near the accident site, reported that about 1630, they were feeding their horses when they heard a small aircraft coming from southwest of their farm, heading toward them. "We could tell it was very low. It kept getting louder and closer to us. We thought it was coming on top of us." They heard the aircraft for about 10 seconds. "All of a sudden the sound of the engines [was] gone." They did not "hear a crash or [an] explosion, but became concerned about a crash since it appeared to be flying so low."

Personnel information

The flight logbook of the 47-year-old pilot was not located; therefore, instrument flight time and total flight time could not be determined. The date of the pilot's last biennial flight review also could not be determined. According to FAA records, the pilot was issued a commercial pilot certificate with an instrument rating on October 25, 1979. According to the pilot's most recent second class medical certificate application, dated June 1, 1998, he had accumulated a total of 2,500 civilian flight hours. According to data provided by the operator, the pilot had accumulated 170.5 hours in the year preceding the accident, of which 60 hours were accumulated in the previous 90 days, and 17.6 hours in the previous 30 days.

Aircraft information

Examination of the airplane's maintenance records, by the NTSB investigator-in-charge (IIC), revealed that the 1972 model Beech 95-B55's most recent annual inspection was completed on August 25, 1998, at an airframe total time of 3,753.6 hours. At the time of the annual inspection, the left engine had accumulated 987.7 hours since major overhaul (SMOH), and the right engine had accumulated 1,477.5 hours SMOH.

Review of the maintenance records revealed no evidence of any uncorrected maintenance discrepancies. The aircraft's maximum takeoff weight is 5,100 pounds, and an estimate of the aircraft's weight at the time of the accident placed it within weight and balance limits.

According to maintenance records, the airplane had been modified with a Colemill Conversion that replaced the two original Continental IO-470-L engines equipped with Hartzell PHC-C3YF-2F propellers with two Continental IO-520-E2B engines equipped with Hartzell ECH-A3VF-2B-V7636D propellers. According to the Major Repair And Alteration, FAA Form 337, dated January 9, 1978, this modification was applied utilizing the instructions contained within STC SA432SO.