NYC94FA040

NTSB accident investigation · Aero Commander 500A · White Mills, PA · December 16, 1993

Accident · FatalField investigationFinal report
Date
December 16, 1993, 15:15 local (20:15 UTC)
Place
White Mills, PA
Injuries
2 fatal
Damage
Destroyed
Phase of flight
Maneuvering
Aircraft
N9379RAero Commander 500A
Weather
Visual (VMC) · Day
Status
Completed · report September 13, 1994
Report
Approved by Office Director
FAA report
19931216047309A
Case key
38666

From the NTSB’s public API. By law, NTSB reports can’t be used as evidence in lawsuits over the accident.

On this page

Probable cause

was the fracture and separation of the airplane wing, and the subsequent loss of control and collision with trees, as a result of the pilot's repeated performance of acrobatic maneuvers, which exceeded the design limits of the airplane.

Sequence of events

NTSB’s coding before 2008: each occurrence and phase of flight, and the causes and factors under it. The codes are defined in NTSB’s coding manual.

Abrupt maneuverManeuvering
Overconfidence in personal abilityPilot in command
Overconfidence in aircraft's abilityPilot in command
Aerobatics - performedPilot in commandCause
Airframe/component/system failure/malfunctionManeuvering
Design stress limits of aircraft - exceededPilot in commandCause
Wing - fracturedCause
Wing - separationCause
Loss of control - in flightDescent - uncontrolled
In flight collision with objectDescent - uncontrolled
Object - tree(s)

Analysis

The airplane was observed by witnesses in a rolling maneuver, followed by the separation of the left wing and collision with trees. Witnesses stated that the pilot had preformed acrobatics in this airplane on other occasions. The airplane flight manual prohibits intentional acrobatics. No evidence of corrosion or fatigue in the wing spar or support structures was observed.

Factual narrative

History of flight

On Thursday, December 16, 1993, at 1515 eastern standard time, an Aero Commander 500A, N9379R, piloted by Jerry L. Raff, was destroyed by impact with the terrain, while maneuvering, near White Mills, Pennsylvania. The pilot and pilot/passenger were fatally injured. Visual meteorological conditions prevailed, and no flight plan was filed. The flight was being conducted under 14 CFR 91.

The airplane departed the Cherry Ridge Airport, Honesdale, Pennsylvania, at 1445, for a local flight. About 1513, witnesses observed the airplane flying east of the airport in a southerly direction.

One witness, stated:

I heard the airplane (pitch of the motors) get loud and saw the plane roll. While he was upside down and starting to descend his plane lost a piece. I could not at that point tell for sure if it was wing, tail or parts. Then he went what appeared to be straight down.

Another witness stated:

Airplane was flying as if normal then maneuvered into an inverted position by going in a clockwise turn and was headed in a south east direction. The plane disappeared over the tree line from my sight in a southerly direction.

A Certified Flight Instructor at the Cherry Ridge Airport, said:

[I] saw aircraft flying south at approximately 5000 ft msl. Aircraft then pulled a nose high attitude and bank sharply into a slow barrel roll. It then looked to go straight down from inverted flight position. Lost sight of aircraft. Heard engines go to full throttle then heard impact...

The accident occurred during the hours of daylight, at about 41 degrees, 31 minutes North; 75 degrees, 15 minutes West.

Personnel information

The pilot, Mr. Jerry L. Raff, held a Private Pilot Certificate, with single engine and multi-engine land ratings. He did not have an instrument rating. The pilot's flight time log book was not located during the investigation. On the pilot's application for an FAA Second Class Medical Certificate, on November 23, 1993, he indicated a total of 585 flight hours.

The other occupant of the airplane, Mr. Allan Landers, held a Private Pilot Certificate, with a single engine rating. According to witnesses, Mr. Landers was flying in N9379R as a passenger and not as a second pilot.

Aircraft information

The aircraft and engine maintenance log books were not located during the investigation. According to Federal Aviation Administration records, N9379R was delivered from the manufacturer on August 31, 1960. Mr. Raff purchased N9379R on September 21, 1992.

Wreckage

The airplane wreckage was examined at the accident site on December 17, 1993. The main wreckage, except for portions of the left wing, left aileron and the top of the vertical stabilizer, was in a wooded area, 25 feet from a dirt road. It came to rest inverted and in a hole approximately 4 feet deep. Several trees 14 inches in diameter were cut and knocked down. One tree was under the wreckage. Both engines were buried in this hole. The landing gears were in the UP position. All cockpit switches and instruments were destroyed. Flight control continuity could not be established, because of impact damage. The right wing was with the main wreckage and was crushed. Both wing flaps were in the UP position.

The outer 12.5 feet of the left wing was located 440 feet from the main wreckage on an approximate magnetic heading of 035 degrees. There was no evidence of corrosion or fatigue on the wing spar or other surfaces. The fracture surfaces were inclined approximately 45 degrees. The wing aluminum skin at the fracture point, both the upper and lower portions, was bent in an upward direction. There was no evidence of rubbing.

The left aileron was located approximately 290 feet from the main wreckage on a magnetic heading of 350 degrees. There was no visual evidence of fatigue or corrosion on the fracture surfaces of the hinges.

The tip of the vertical stabilizer, approximately 3 feet long, was found in a tree 105 feet from the main wreckage, on a magnetic heading of approximately 035 degrees. The top 8 inches of the leading edge of the stabilizer were crushed and fractured. No evidence of corrosion was observed on the support structures.

Four propeller blades were located with the main wreckage. They were separated from the propeller hubs, and each had chordwise scratches on the forward-facing surface of the blade. The blades were bent aft and twisted. There were gauges on the leading edges of each blade, and the tip of one blade was fractured.

Medical and toxicological information

Post-mortem examinations, including autopsies and toxicological tests, were not performed due to extensive injuries sustained by the occupants.

Additional information

Richard W. Enger was interviewed at the Cherry Ridge Airport on the day after the accident. A summary of this interview stated:

...Mr. Enger stated that when he observed the Aero Commander flying in a southerly direction, he had a "feeling" that the pilot, Jerry Raff, would roll the airplane...Mr. Enger said that he had known about Mr. Raff's acrobatic flying from previous conversations. He had even told Mr. Raff to not do such maneuvers in that airplane, because it was not designed for acrobatics.

On January 12, 1994, Dr. Charles G. Kalko was interviewed by telephone by a Safety Board Investigator. In a summary of this interview it stated:

...Dr. Charles G. Kalko...knew Jerry Raff...both through a business relationship and personally. Dr. Kalko described himself as an experienced acrobatic pilot. He said that he had received instruction in acrobatics and owned airplanes... certified for acrobatics. Dr. Kalko stated that he had discussed acrobatics with Jerry Raff several times. According to Dr. Kalko, Mr. Raff had been performing acrobatic maneuvers in the Aero Commander 500A, which he owned. Dr. Kalko said that he strongly advised Mr. Raff to not perform these maneuvers in that airplane, because it was not certified for acrobatics.

In addition, Dr. Kalko stated that he advised Mr. Raff to obtain some acrobatic training, and he provided him with the name of a well known acrobatic instructor. He said that Mr. Raff did not obtain the training prior to the accident.

Dr. Kalko mentioned that Mr. Raff had performed rolling maneuvers over Dr. Kalko's airport on one occasion....Mr. Raff told Dr. Kalko that he had been rolling the airplane previously. Mr. Raff told Dr. Kalko that he had seen Aero Commanders flown in air shows.

In the book, The Basic Aerobatic Manual, written by William K. Kershner, it stated:

While we're on the subject of your instructor, it should be noted that self-taught aerobatics is not the way to go. That method is certainly very inefficient- and can be dangerous.

The limit load factors (sometimes called flight load factors) are the number of g's (positive and negative) that can been imposed on an airplane without permanent deformation of structure occurring. The ultimate load factors (sometimes called design load factors) are the number of g's that can be imposed on an airplane without destruction of major components (wings, tail, etc.) occurrin

Aircraft

Registration
N9379R
Reported as
Aero Commander 500A
Category
Airplane
Serial number
500-A-897-6
Engine
Continental IO-470-M, 260 horsepower, reciprocating
Damage
Destroyed
Flight
Personal · Part 91
Registered owner
Raff Aviation, Inc.
Airworthiness certificate
Standard, Normal
Departed
N30 · Honesdale, PA
Destination
N30

Matched to the registry by N-number and the event date; the registry’s history has gaps, so older matches can be wrong. Compare the reported make and model.

Flight crew

As NTSB recorded them. NTSB leaves out names.

Role
Pilot
Age
44
Certificate
Private
Airplane ratings
Single-engine land, Multi-engine land
Medical
Class 2, Valid Medical--w/ waivers/lim
Seat
Left
Flight hours
585 total

Weather

Conditions
Visual (VMC) · Day
Wind
330° at 15 knots
Visibility
15 statute miles
Lowest ceiling
None
Temperature
36 °F
Observed at
AVP, 28 nm away

FAA reports on this event · 1

The FAA’s own accident and incident reports, matched to the aircraft by N-number and date.