SEA94FA014

At the end of the cross-country flight, the pilot was cleared for the NDB approach. He later reported that he was on the missed approach and wanted to try the approach again. The controller cleared the pilot for the approach and asked the pilot to report the procedure turn inbound. The pilot's last transmission, 3 minutes after the missed approach, was that he was at 2,200 ft and climbing. The airplane was never re-established on radar. The wreckage was located east of the approach path, approx 5 miles northeast of the airport, at the 1,000 ft level of a 1,200 ft mountain. A king air pilot reported that the clouds were solid north & east of the airport, and extended to the surface. The NDB approach path was also solid to the ground with fog and clouds. The area south and west was under visual conditions.

History of flight

On October 14, 1993, at 0820 Pacific daylight time, a Cessna 172P, N115FR, collided with mountainous terrain approximately five miles north of Kelso, Washington. Instrument meteorological conditions prevailed at the time and an instrument flight rules flight plan was filed for the business flight that was being conducted under 14 CFR 91. The airplane was destroyed and the commercial pilot and his passenger were fatally injured. The flight originated from Seattle, Washington, on October 14, 1993, at 0709 and was en route to Kelso.

The pilot had been cleared for the Kelso NDB approach by Seattle Air Route Traffic Control. After completing the approach, the pilot reported to Seattle Center that he was on the missed approach and that he was going to perform the approach again. The pilot's last communication with air traffic control, three minutes after he reported the missed approach, was that he was at 2,200 feet and climbing.

The wreckage was not located until October 15, 1993. The accident site was located at the 1,000 foot level of a 1,200 foot mountain.

A pilot flying a King Air in the area reported that he had approached the airport from the south. The weather to the south and to the west were under visual conditions, however, the weather to the north, east over the mountains, and at the airport were rapidly deteriorating. The King Air pilot was maneuvering around the airport for landing when he heard the Cessna on the approach. The King Air pilot departed the airport environment to the west to wait for the Cessna to complete the approach and land. While the King Air pilot was maneuvering in the west, he heard the Cessna pilot make the missed approach announcement. The King Air pilot then headed toward the airport. At this time, the King Air pilot stated that the weather had deteriorated to the point that a visual approach was not possible. Before departing the area, the King Air pilot tried to contact the Cessna pilot for a weather update, however, the Cessna pilot did not respond.

Personnel information

The pilot held a commercial certificate for single engine and multi engine operations with an instrument rating. The pilot's flight logbook indicated he had accumulated a total flight time of 647 hours. Since July 13, 1990, the start of the reviewed logbook, the pilot had accumulated a total of 40 hours in the Cessna 172. A total of 45 hours had been logged in actual instrument flying, with three hours in the past 90 days.

The operator of the aircraft reported that the pilot had passed an instrument competency flight check on September 20, 1993.

Aircraft information

On May 21, 1993, a 2360.9 hour engine was installed in this airplane. At the time of the accident, the engine had accumulated a total time of 3732.4 hours. The engine was scheduled for an overhaul in November 1993.

The operator's mechanic reported that the engine had been inspected on October 1, 1993, after notifications of intermittent rough running engine conditions were noted by other pilots. The mechanic stated that an extensive inspection of the engine was performed and no abnormalities were noted during the inspection and subsequent test flight. The airplane was then returned to service.

Meteorological information

The 0815 Automated Weather Observing Service (AWOS) at Kelso was reporting 500 feet scattered with five miles visibility. The temperature was 54 degrees with 50 degrees dew point. The winds were calm and the altimeter was 29.99" Hg.

The King Air pilot reported that at the time the Cessna was flying the approach, the clouds were solid north and east of the airport and extended to the surface. The approach end of the runway and the NDB approach path were also solid to the ground with fog and clouds. The area to the south and the west was under visual conditions.

Communications

At 0736, the pilot made contact with Seattle Center and reported that he was level at 7,000 feet on Victor 23. One minute later, the pilot requested a frequency change to contact flight watch.

At 0749, the pilot confirmed that he would be initiating the approach into Kelso and at this time was cleared for the NDB approach.

At 0756, a King Air pilot repeated the weather conditions at the airport for the benefit of the Cessna pilot. The King Air pilot reported that the center of the airport was clear, however, the approach end of the runway and to the east was solid clouds at 4,000 to 5,000 feet.

At 0759, the pilot reported that he wanted to proceed to Kelso and hold. This request was approved by Seattle Center.

At 0801, the pilot reported that he wanted to amend the last request and perform the full procedure turn for the NDB approach. The controller approved this request and cleared the pilot for the NDB approach.

At 0806, Seattle Center confirmed for the pilot that the airplane was over the Kelso NDB at 3,600 feet.

At 0815, the pilot reported to Seattle Center that he wanted to return for another procedure turn. The Seattle Center controller asked if the pilot was on the missed approach and the pilot responded affirmative. The controller then cleared the pilot for another NDB approach.

At 0817, the pilot asked Seattle Center if he had the airplane's distance from Kelso. The controller responded that the flight was not in radar contact.

At 0818, the controller asked the pilot what his altitude was, and the pilot responded that he was 2,200 and climbing.

At 0822, Seattle Center asked the pilot to report when he was on the procedure turn inbound. The pilot did not respond.

Wreckage and impact information

The wreckage was located at the 1,000 foot level of a 1,200 foot mountain. The mountain was covered with dense trees measuring in height to approximately 100 feet. The soft moist ground was covered with dense vegetation. The terrain angle was measured at approximately 42 degrees. Several of the tree tops were broken off from trees that were approximately 150 feet away from the main wreckage. The bark of several trees, along the wreckage distribution path, showed evidence of impact damage. The distribution path through the trees was measured on a magnetic bearing of 210 degrees.

Small pieces of the fuselage were found throughout the distribution path that led to the main wreckage. The empennage was the first large piece of the aircraft that was found approximately 40 feet north of the main wreckage. The empennage had separated from the fuselage at an area just forward of the vertical stabilizer. The rudder remained attached to the vertical stabilizer and the elevators remained attached to the horizontal stabilizers. The right horizontal stabilizer displayed a circular impact signature along the leading edge. The left horizontal stabilizer displayed minor damage.

The main wreckage was positioned inverted with the nose of the airplane pointing uphill on a magnetic bearing of 120 degrees. The right wing was positioned against a tree and was partially torn away from the fuselage. The flap and aileron were in place, however, badly deformed. The wing strut remained attached at the wing attachment. The attachment to the fuselage had pulled away.

The fuel tank was ruptured.

The section of the left wing inboard of the wing strut attachment remained attached at the root. A circular indentation was noted along the leading edge. The flap remained attached at the hinges. The wing strut remained attached at both attachment ends. The outboard section of the wing was found a few feet away. The aileron remained attached by one hinge.

The flap motor, located in the right wing, was examined and noted that the flaps were in the retracted position. Control continuity was not established, as all the control cables had been stretched and broken.

A log measuring six inches in diameter was entangled in the under side of the airplane. The log was protrud