Copy · SB F406-90 Rev 00 · 6 pages

© Textron Aviation Inc. Filed by the FAA in regulations.gov docket FAA-2021-0714, the docket of AD 2021-22-21. Not covered by OpenAirDocs’ CC0 dedication.

TextPartly OCR

Some pages are OCR from a scan. OCR can misread letters and numbers.

Query with SQL
duckdb -csv -c "SELECT p.page, p.text_source, p.text, f.rights_holder, f.license
  FROM 'https://openairdocs.org/data/latest/service_document_file_page.parquet' p JOIN 'https://openairdocs.org/data/latest/service_document_file.parquet' f USING (file_sha256)
  WHERE p.file_sha256 = 'b8c2c05b7f3d0cc8765e314cb4f0ceb61c3e1f0f4f243b42996274f11d9500fb'
  ORDER BY p.page"

Prints the whole list as CSV. It reads the release’s Parquet files over HTTPS, so there’s nothing to download first. Install DuckDB to run it.

ASI AVIATION 51360 PRUNAY - FRANCE Service Bulletin N° F406-90 December 14th 2018 Page 1/6 MANUFACTURER REFERENCE: N°F406-90 N° ATA: 24 Date: 14th December 2018 TITLE: Replacement of switch circuit breaker P/N CM3589-20 by the P/N 406E2450-00000-

100.

EFFECTIVITY Model Serial Number F406 001 & ON

PURPOSE In service reports of development of smoke and a burning smell in the cockpit have been recorded. Technical investigations revealed that these occurrences were induced by the failure of a circuit breaker switch P/N CM3589-20.

To address this issue, these circuit breaker switches must be imperatively replaced by the new circuit breaker switches reference P/N 406E2450-00000- 100 as described in this Service Bulletin, within the 200 hours of operation, or 12 months or the next programmed inspection, whichever occurs first. Non-compliance with this Service Bulletin may allow a de-ice propeller circuit breaker switch and/or a recognition light circuit breaker switch to fail in a manner that could result in noticeable smoke and a burning smell in the cockpit.

A life limit of 6 years is introduced for this new breaker. The standard aircraft maintenance manual chapter 05-11-00 has been updated.

COMPLIANCE: MANDATORY Shall be accomplished in the 200 hours of operation, or 12 months or the next programmed inspection.

Circuit breaker switches CM3589-20 must be replaced by circuit breaker switches P/N 406E2450-00000-100. The circuit breaker switches P/N 406E2450-00000-100 must be replaced every 6 years.

APPROBATION The technical content of this SB has been approved under EASA 21J.064.

It is expected this Service Bulletin will be the subject of an EASA Airworthiness Directive.

REFERENCE None SERVICE BULLETIN N° F406-90

Page 2OCROpen in PDF

ASI AVIATION ASI AVIATION 51360 PRUNAY - FRANCE

MAN-HOURS Approximately 7 man-hours.

MATERIAL Part Number Designation Quantity 406E2450-00000-100 Switch breaker 2* *if recognition light option is installed, quantity is 3 CREDIT Not applicable

OVERVIEW

LIGHT SCREW BRACKET

LEFT DIMMING

VERTICAL CONTROLS

CIRCUIT

PANEL BREAKER CIRCUIT BREAKER SWITCH CIRCUIT BRACKET 8800 BA99700000

BREAKER,

DETAIL A SCREW.

CIRCUIT FORWARD HORIZONTAL

BREAKER CIRCUIT BREAKER

AFT HORIZONTAL SIDE CONSOLE PANEL

CIRCUIT BREAKER SWITCH CIRCUIT BREAKER PANEL Switch circuit breakers highlighted in red will be replaced.

Service Bulletin N° F406-90 Page 2/6 December 14th 2018

ASI AVIATION 51360 PRUNAY - FRANCE Service Bulletin N° F406-90 December 14th 2018 Page 3/6

ACCOMPLISHMENT INSTRUCTIONS

WARNING: Electrically ground the airplane and turn all switches to the “OFF” position. If external power is connected to the airplane, disconnect external power from receptacle.

PART 1: De-ice propeller circuit breaker switch Instruction VISA INSPECTION 1 Disconnect the Airplane battery.

(Refer to the applicable sections of the F406 Maintenance manual).

2 Remove the pilot’s seat for access to remove the left circuit breaker console panel.

(Refer to the applicable sections of the F406 Maintenance manual).

3 Remove the pilot’s circuit breaker console side panel to get access to the switches SCB24 and SCB25 (CM3589-20).

(Refer to Maintenance Manual chapter 31-10-04).

4 Location of the breakers to be changed: forward horizontal C/B panel

The two breakers to be changed are the following breakers:

5 Remove the switches SCB24 and SCB25 (P/N CM3589-20).

ASI AVIATION 51360 PRUNAY - FRANCE Service Bulletin N° F406-90 December 14th 2018 Page 4/6

6 Rework the panel P/N 6018110-4 as follow:

7 Re-identify the forward horizontal circuit breaker panel (P/N 6018110-4) as 406-5311-18110-004 with permanent marker.

8 Install the new switches P/N 406E2450-00000-100.

9 Install the pilot’s circuit breaker side panel.

(Refer to the Maintenance Manual chapter 31-10-04).

10 If applicable (recognition light option installed) apply PART 2.

11 Install the pilot’s seat.

(Refer to the applicable sections of the F406 Maintenance manual).

12 Reconnect the airplane battery and verify correct operation of any new switches installed.

13 Apply the test procedure described in Figure 101, MM Chapter 30-60-00.

14 Make an entry in the airplane logbook stating compliance and method of compliance with this Service Bulletin and when replacement of any avionics bus switch is due.

Page 5OCROpen in PDF

ASI AVIATION ASI AVIATION 51360 PRUNAY - FRANCE PART 2: applicable only if recognition light option (5718714-14/20):

1 Location of the breakers to be changed: left forward vertical C/B panel

LIGHT SCREW BRACKET

LEFT DIMMING

VERTICAL CONTROLS

CIRCUIT SWITCH

BREAKER CIRCUIT

PANEL BREAKER

BRACKET

CIRCUIT

BREAKER

DETAIL A SCREW

CIRCUIT FORWARD HORIZONTAL

BREAKER CIRCUIT BREAKER PANEL

AFT HORIZONTAL SIDE CONSOLE

CIRCUIT BREAKER SWITCH CIRCUIT BREAKER PANEL 0000 The breaker to be changed is the following breaker:

888888÷100000 Service Bulletin N° F406-90 Page 5/6 December 14th 2018

ASI AVIATION 51360 PRUNAY - FRANCE Service Bulletin N° F406-90 December 14th 2018 Page 6/6

2 Rework the panel P/N 6018110-4 as follow:

3 Re-identify the forward vertical circuit breaker panel (P/N 6018110-7) as 406- 5311-18110-007 with permanent marker.

4 Install the new switch P/N 406E2450-00000-100.

5 Install the pilot’s circuit breaker side panel.

(Refer to the Maintenance Manual chapter 31-10-04).

6 Install the pilot’s seat.

(Refer to the applicable sections of the F406 Maintenance manual).

7 Reconnect the airplane battery and verify correct operation of any new switches installed.

8 Apply the test procedure described in Figure 101, MM Chapter 30-60-00.

9 Make an entry in the airplane logbook stating compliance and method of compliance with this Service Bulletin and when replacement of any avionics bus switch is due.

OWNER NOTIFICATION The Service Bulletin F406-90 dated 14th December 2018 will be addressed to the owners of the F406 airplanes. It is recommended to the customers to contact ASI AVIATION for any further information relating to the application of this Service Bulletin on your airplane.

ASI AVIATION Aérodrome de Reims- Prunay 51360 Prunay France Tel: (+33) 3.26.48.46.65

Customer Support Website: http://asi-aviation.fr/asi-aviation-support/1.html Up