Copy · U.S. DOT/FAA - SB F10-318 IR · 8 pages

© Dassault Aviation. Filed by the FAA in regulations.gov docket FAA-2013-0979; AD 2013-25-01 incorporates this document by reference. Not covered by OpenAirDocs’ CC0 dedication.

TextPartly OCR

Some pages are OCR from a scan. OCR can misread letters and numbers.

Query with SQL
duckdb -csv -c "SELECT p.page, p.text_source, p.text, f.rights_holder, f.license
  FROM 'https://openairdocs.org/data/latest/service_document_file_page.parquet' p JOIN 'https://openairdocs.org/data/latest/service_document_file.parquet' f USING (file_sha256)
  WHERE p.file_sha256 = '2b7fd804a476dca51ff5d50a72b2f5d8e7aa5f90d0bb19b31a504004aca52cd7'
  ORDER BY p.page"

Prints the whole list as CSV. It reads the release’s Parquet files over HTTPS, so there’s nothing to download first. Install DuckDB to run it.

FALCON 10 No 318 OCTOBER 30, 2013

MANDATORY ATA 27-35

FLIGHT CONTROLS FLAPS

INSPECTION OF INBOARD FLAPS

FALCON SERVICE BULLETIN Copyright © 2013 by Dassault Aviation All rights reserved. No part of this work may be reproduced or copied in any form or by any means without written permission of Dassault Aviation.

FLIGHT CONTROLS FLAPS

INSPECTION OF INBOARD FLAPS Initial issuance October 30, 2013 List of effective pages :

1 to 4 FALCON 10 F10 -318 F10 -27-35

FLIGHT CONTROLS FLAPS

INSPECTION OF INBOARD FLAPS

1. PLANNING INFORMATION A. EFFECTIVITY This Service Bulletin is applicable to all FALCON 10 aircraft.

B. REASON During a regular maintenance action, a crack was found on two aircraft on the inboard end-plate (rib) of the right-hand inboard flap. On both aircraft, the crack had initiated in the same area of the rib.

If left undisclosed and untreated, such a crack may evolve into a plain fracture of the rib and a loss of aircraft integrity.

The purpose of this Service Bulletin is to inspect the LH and RH flaps for cracks to address this potential unsafe condition.

C. DESCRIPTION The operation consists in inspecting the LH and RH inboard flaps for cracks.

D. COMPLIANCE Mandatory:

• This Service Bulletin is rendered mandatory by EASA Airworthiness Directive No 2013-0262.

• As prescribed by the Airworthiness Authorities of the country of registration of the aircraft.

E. APPROVAL The technical content of this document is approved under the authority of DOA nr. EASA.21J.051.

F. LABOR Estimated labor-hours: Refer to Service Bulletin Commercial Summary.

NOTE: These labor-hours only concern the work described in this Service Bulletin and do not include other maintenance work which may be performed on this occasion.

G. MATERIAL - PRICE AND AVAILABILITY The spare part(s) can be obtained from either address listed below:

FALCON 10 F10 -318 October 30, 2013 F10 -27-35 Initial issuance Page 1 / 4 DASSAULT AVIATION Proprietary Data

Western hemisphere: DASSAULT FALCON JET CORP.

SPARES DISTRIBUTION CENTER 200 RISER ROAD LITTLE FERRY, NJ 07643 U.S.A.

Telephone:

• CANADA and U.S.A.: 1-800-800-4036

• MEXICO: 001-800-800-4036

• Other countries: 1-201-541-4809 Fax:

• CANADA and U.S.A.: 1-800-800-4817

• MEXICO: 001-800-800-4817

• Other countries: 1-201-440-7021 Other continents: DASSAULT AVIATION Falcon Spares BOITE POSTALE N°101

AEROPORT DU BOURGET 93350 - LE BOURGET Cedex (FRANCE) Please contact your Dassault Aviation Account Representative Telephone: 33 (0)1.48.35.56.78 Fax: 33 (0)1.48.35.56.00 E/H dafsorder@dassault-aviation.com Price and availability on request.

H. TOOLING - PRICE AND AVAILABILITY Normal maintenance tooling.

I. WEIGHT AND BALANCE Change in weight: None.

Change in balance with respect to 25% MAC: None.

J. REFERENCES Aircraft Maintenance Manual:

• Summary of mandatory precautions to be taken during Aircraft Maintenance Operations (procedure 20-00-05-2)

• Removal/Installation of inboard and outboard flaps (procedure 27-81-01-6) K. OTHER PUBLICATIONS AFFECTED The following publications will be revised at a later date to account for the changes introduced by this Service Bulletin:

• Maintenance Manual Chapter 5,

• Maintenance manual.

FALCON 10 F10 -318 October 30, 2013 F10 -27-35 Initial issuance Page 2 / 4 DASSAULT AVIATION Proprietary Data

2. ACCOMPLISHMENT INSTRUCTIONS A. PRELIMINARY STEPS

(1) The aircraft must be in the maintenance configuration (procedure 20-00-05-2).

(2) Connect the electrical Ground Power Unit (GPU).

(3) Energize the aircraft systems.

(4) Pressurize hydraulic system No 1 using the electropump.

(5) Extend the flaps to 52°.

B. PROCEDURE

(1) Perform a visual check of ribs 1 and 3 of the inboard flaps for cracks (refer to fig. 1):

(a) If no crack is found, no further action is required.

(b) If crack(s) is found, replace the flap (procedure 27-81-01-6).

NOTE: The flap(s) removed may be sent to one of the addresses listed in paragraph 1.G.

of this Service Bulletin.

C. FINAL STEPS

(1) De-energize the aircraft systems.

(2) Disconnect the Ground Power Unit (GPU).

D. RECORDING Record compliance with this Service Bulletin in the appropriate aircraft documents.

Fill out the card located at the end of the Service Bulletin and mail or fax it to Dassault Aviation or Dassault Falcon Jet, or fill out the electronic Service Bulletin reply form located in the ”Service Bulletin" page on the Falcon portal.

FALCON 10 F10 -318 October 30, 2013 F10 -27-35 Initial issuance Page 3 / 4 DASSAULT AVIATION Proprietary Data

Page 6OCROpen in PDF

DASSAULT SERVICE BULLETIN

AVIATION FALCON 10 F10 -318 RH side Inboard flap extended to 52° Example of crack Fiqure 1: INSPECTION OF THE INBOARD FLAPS October 30, 2013 F10-27-35

END OF DOCUMENT Initial issuance Page 4 / 4

Page 7OCROpen in PDF

NO POSTAGE

NECESSARY

FROM IF MAILED IN THE

UNITED STATES

ZIP CODE

BUSINESS REPLY MAIL FIRST CLASS MAIL PERMIT NO. 3306 HACKENSACK, NJ 07602 POSTAGE WILL BE PAID BY ADDRESSEE:

DASSAULT FALCON JET CORP.

PO BOX 1946 SO HACKENSACK NJ 07606-9946 ATTENTION:

FIELD SERVICE DEPARTMENT

DASSAULT AVIATION 78, Quai Marcel Dassault Cedex 300 92552 SAINT-CLOUD Cedex FRANCE A l'attention de DSC

SERVICE BULLETINS COMPLIANCE FALCON 10 A/C S/N DASSAULT AVIATION Number ATA Number F10 318 F10 27 35

Coding: C complete compliance

T partial compliance

Performed by:

Remarks: Initial issuance Date: Signature:

SERVICE BULLETINS COMPLIANCE Would you be kind enough to inform us that this Service Bulletin is complied with:

- For "Western Hemisphere", mail upper card (No postage necessary if mailed in the U.S.A.) or fax to Dassault Falcon Jet: 1-201-541-4700.

- For "Other Continents", mail card herebelow or fax to Dassault Aviation: 33 (0)1.47.11.65.21.

On the occasion, if other Service Bulletins have been simultaneously complied with could you complete the blank spaces provided for this purpose.

APPLICATION DE BULLETINS DE SERVICE Lorsque vous aurez applique ce Bulletin de Service sur votre avion, veuillez avoir l'amabilite de nous en informer:

- Utiliser la carte reponse superieure pour continent americain (Dispensee de timbrage pour postage depuis les U.S.A.) ou le fax pour Dassault Falcon Jet : 1-201-541-4700.

- Ou la carte reponse inferieure pour autres continents ou le fax pour Dassault Aviation : 33 (0)1.47.11.65.21.

Eventuellement, si d'autres Bulletins de Service ont ete appliques simultanement, vous pouvez les mentionner dans les cases vierges prevues a cet effet.

APPLICATION DES BULLETINS DE SERVICE SERVICE BULLETINS COMPLIANCE FALCON 10 A/C S/N DASSAULT AVIATION Number Numero DASSAULT AVIATION ATA Number Numero ATA F10 318 F10 27 35

Coding: C complete complianceapplication totale

T partial complianceapplication partielle

Performed by:

Fait par:

Remarks: Initial issuance Date: Signature:

Remarques: Edition originale