STC SA2383WE

SA2383WE TALCO Aviation 3015 E. New York St, STE A2-270 Aurora, IL 60504 Part 3 the Civil Air Regulations (See Type Certificate Data Sheet No. 3A10) 3A10 Cessna 310C, 310D, 310E, 310F, 310G Installation of turbocharged Continental IO-470-D engine in accordance with FAA Sealed Roto-Master (Rajay) Drawing List No. RJ1200, or later FAA approved revision.

(See continuation sheet 3 of 4) April 12, 1971 February 10, 1982; October 30, 1987; September 22, 1995; December 19, 2003;

July 3, 2006; March 16, 2007; March 5, 2018; February 2, 2021; August 31, 2023 August 18, 1971 March 21, 1985 for Paul (Vu) Nguyen Manager, Central Certification Branch Compliance & Airworthiness Division Aircraft Certification Service 4

SA2383WE 4

SA2383WE Date of Issuance: August 18, 1971 Date Amended: March 21, 1985 Date of Reissuance: August 31, 2023

The limitations and conditions of Type Certificate Data Sheet No. 3A10 apply except as outlined below.

1. The engines must incorporate turbochargers in accordance with STC No. SE96SO.

2. The following placards must be installed in full view of the pilot unless noted otherwise:

10,000 3 MIN - 27.5 MAP @2625 RPM, MAX CONT. TO 25,000 - 26.5 MAP @ 2625 RPM.

b. "REDUCE NEVER EXCEED SPEED (Vne) 6 MPH (5 KNOTS) PER 1000 FEET ABOVE 20,000 FEET MSL."

c. FOR EMERGENCY DESCENT-IDLE POWER, GEAR, AND FLAPS UP-OBTAIN AND MAINTAIN 210 MPH CAS (Vc) TO 15,000 FEET."

d. "FLIGHT OPERATION OVER 25,000 FEET IS PROHIBITED."

e. FUEL BOOST PUMPS ON ABOVE 15,000 MSL."

f. "WIDE OPEN THROTTLE BEFORE ENGAGING TURBOCHARGER."

g. Adjacent to each fuel filler opening: "100/130 MIN. GRADE AVIATION GASOLINE."

SA2383WE Date of Issuance: August 18, 1971 Date Amended: March 21, 1985 Date of Reissuance: August 31, 2023

3. This approval of change in type design applies to the basic Cessna 310 series models noted on page 1 of this STC only. The installer must determine whether this design change is compatible with previously approved modifications. If the holder agrees to permit another person to use this certificate to alter a product, the holder must give the other person written evidence of that permission.

-END- 4 4