STC SA4529NM-D

FAA Form 8110-2 (8/13) Page 1

Part of the Federal A viation Regulations.

Original Product – Type Certificate Number: MDNH:

MRGHO:

Signature

Title

SA4529NM-D Hartzell Propeller Inc One Propeller Place Piqua, Ohio 45356 CAR3 2A3 Mooney International Corporation M20C, M20D, M20E, M20F, M20G, M20J Installation of Hartzell propeller model HC-C3YR-1RF/F7282 in accordance with Hartzell STC Installation Instruction INST_011810 Revision A dated February 10, 2015 or later FAA Approved revisions. Airplane Flight Manual Supplement AFMS_011810 is required. Instructions for Continued Airworthiness ICA_011810 Revision A are applicable.

1. The installer must determine whether this change is compatible with previously approved modifications.

2. If the holder agrees to permit another person to use this certificate to alter a product, the holder must give the other person written evidence of that permission.

(See Continuation Sheet 3 of 3 pages) 9/7/1988 1/26/1989 December 21, 1992 9/22/89; 2/9/90; 7/24/96; 3/31/10; 9/21/15 Brian E. Meyer STC ODA administrator Hartzell ODA-100082-CE

FAA Form 8110-2 (8/13) Page 2

To (Name and address of transferee) From (Name and address of grantor) Extent of Authority (if licensing agreement):

SA4529NM-D

FAA Form 8110-2 (8/13) Page 3

SA4529NM-D Hartzell Propeller Inc Date of amendment September 21, 2015

3. Revised Type Certificate Data Sheet information:

Propeller and Propeller Limits:

Hartzell constant speed model HC-C3YR-1RF/F7282

Diameter: Maximum 74 in.

Minimum 73 in.

Pitch setting at 30-inch radius: Low: M20C, M20D, M20G: 11.8+/-0.1 degrees M20E, M20F, M20J: 12.5+/-0.1 degrees High: 30.0+/-0.5 degrees

Spinners:

M20C, M20D, M20E, M20F, M20G: Assembly 835-47(P) or 103629( ) M20J: Assembly 2295-1(P) or 2295-4(P)

4. The original aircraft certification basis was used for this STC, except for the inclusion of 23.1529 Amendment 23-26 Instructions for Continued Airworthiness. This modification did not increase the noise level and was not considered an acoustical change as defined in 14 CFR 21.93(b).

END