STC SH163EA

Part 6 of the Civil Air R egulations.

(See page 3 for complete certification basis).

Original Product --Type Certificate N umber :

Installation of co-pilot seat assembly Carson Part No. 47-5000-R per Carson seat location drawing 47-1000-A1 with loading in accordance with revision No. 3 to Approved Flight Manual dated November 11, 1963.

This certificate and the supporting data, which is the basis for approval, shall remain in effect until surrendered, suspended, revoked or a termination date is otherwise established by the A dministrator of the Federal A viati on A dministration.

Scott’s-Bell 47, Inc.

100 Minnesota Avenue Le Sueur, MN 56058

H-1 M ake : Bell Helicopter Textron M odel : 47G, 47G-2 Date of application : November 07, 1963

Date of issuance : November 12, 1963 Date reissued : April 30, 2004; December 15, 2010;

August 7, 2014

B y direction of the A dministrator

Original Signed By:

Gregory J. Michalik for (Signature) Karol Mordasiewicz Manager, Airframe and Administrative Branch Chicago Aircraft Certification Office

(Title)

FAA FORM 8110-2-1(10-69) PAGE 2 of 3 PAGES

N umber SH163EA

FAA FORM 8110-2-1(10-69) PAGE 3 of 3 PAGES

Number SH163EA Date of Issuance: November, 12, 1963 Date of Reissuance: August 7, 2014 Limitations and Conditions (Continued):

Structural substantiation of the seat and method of attachment covered by Report B-AN-2 Supplement I dated November 5, 1963.

This report and Carson drawings 47-5000-R and 47-1000-A1 dated October 5, 1963 approved on Form FAA -1600 dated November 5, 1963 and signed by Clyde E. Heaton, DER 1-147. Conformity Inspection on seat conducted by Inspector J. M. Van Meter. Form FAA-1257 dated November 8-18, 1963.

Page I-3 revised and I-3A added to F.A.A. Approved Flight Manual November 11, 1963.

Approval Basis: CAR 6 Data located in Bell 47G STC file, Eastern Region.

Item 6 - Nature and Location of Data

Carson Helicopters Inc. Supplement dated 3/20/62 revised 6/28/62 approved by EA-216 based upon satisfactory flight test as indicated by memo dated 6/15/62.

Approval Basis: CAR 6 of 1/15/51 and Amendments 6-1 thru 6-3.

Data located in Bell 47G STC file, Eastern Region.

1. The installer must determine whether this design change is compatible with previously approved modifications

2. If the holder agrees to permit another person to use this certificate to alter a product, the holder must give the other person written evidence of that permission.

------------End-----------