STC SR00637LA

United States of America Department of Transportation Federal Aviation Administration Supplemental Type Certificate Number SRO0637LA This certificate issued to: Utah State University Research Foundation Business Service Center 1695 North Research Park Way North Logan, Utah 84341-1947 Certifies that the change in the type design for the following product with the limitations and conditions therefer as specified hereen meets the airworthiness requirement's of Part * of the * Regulations. * Original Product Type Certificate Number : ** See attached FAA Approved Model List (AML) Make: * No. SR00637LA for list of approve airplane models Model: * and applicable airworthiness regulations Description of Type Design Change: Installation of Inspect Imaging System "inert" configuration (no electronics installed) in accordance with Inspect Master Drawing List INS MDL-001 as listed on AML No. SR00637LA, dated June 5, 1998, or later FAA Approved revision.

Limitations and Conditions: Approval of this change in type design applies to the aircraft models listed on AML No. SR00637LA only. This approval should not be extended to aircraft of this model on which other previously approved modifications are incorporated, unless it is determined that the interrelationship between this change and any of those other previously approved modifications, including changes in type design, will introduce no adverse effect upon the airworthiness of that aircraft. If the holder agrees to permit another person to use this certificate to alter the product, the holder shall give the other person written evidence of that permission.

Date of Application: May 19, 1987 Date Reissued: December 30, 1999 Date of Issuance: June 5, 1998 Date Amended:

FEDERAL AVIATION By Direction of the Administrator * (Signature) TOMINSTRATO Manager, Technical & Administrativ Staff, Los Angeles Aircraft Certification Office (Title)

47.

United States of America Department of Transportation Federal Aviation Administration Supplemental Type Certificate (Continuation Sheet) Number SRO0637LA Date of Application: May 19, 1987 Date of Issuance: June 5, 1998 Date Reissued: December 30, 1999 Limitations and Conditions: (Continued) A copy of this Certificate and FAA Approved Model List (AML) No. SR00637LA, dated June 5, 1998, or later FAA Approved revision, must be maintained as part of the permanent records for the modified aircraft.

Note 1: Noise characteristics: This modification has been determined to be a no acoustical change" as defined in Section 21.93(b)(4)(ii), Amendment 21-73 of the Federal Aviation Regulations.

- END -

JUNE 5, 1998 AML DATE June 4, 1998 June 4, 1998 ISSUE DATE: RFM SUPPLEMENT NUMBER/ DATE INS - 001 INS-001 DRAWING LIST Rev. No. and Date Rev. NC May 18, 1998 REV. NC May 18, 1998 Manager, Airframe Branch Los Argeles Aircraft Certification Office INSPECT, LLC INSTALLATION OF INSPECT IMAGING SYSTEM INERT CONFIGURATION, NO ELECTRONICS INSTALLED INSPECT INSTALLATION INSTRUCTIONS Rev. No. Number and Date INS MDL-001 Rev. NC May 28, 1998 INS MDL-001 Rev. NC May 28, 1998 FAA Approved: PAGE 1 OF 1 Report Number 98002 98002 CERTIFICATION BASIS FOR ALTERATION CAR 6 and amendments and exemptions listed on TCDS H2SW CAR 6 and amendments and exemptions listed on TCDS H2SW

ORIGINAL TYPE CERTIFICATE H2SW H2SW AIRCRAFT MODEL 206 206A 206A-1 206B 206B-1 206B-111 206L 206L-1 206L-2 206L-3 206L-4

AIRCRAFT MAKE BELL BELL ITEM