STC SR01296NY

FAA Form 8110-2 (5/14) Page 1 of

Part of the

Signature

Title SR01296NY HAS Corporation P.O. Box 1117 Mt. Pleasant, PA 15666 Federal Aviation Regulations.

1. Installation of Electronic News Gathering System in accordance with HAS Master Drawing List 4275302- MDL01, Rev. A, dated December 1, 2000, and HAS Installation Instructions Report No. 4275302 - IN001, dated December 4, 2000.

2. HAS Corporation Rotorcraft Flight manual Supplement 4275302-FMS01, dated March 7, 2001, is required with this installation.

3. HAS Corporation Instructions for Continued Airworthiness 4275302-ICA 01, dated December 6, 2000, and accepted by the FAA on March 1, 2001, is required with this installation.

1. This Supplemental Type Certificate provides for installation of system sensor and antenna mounting provisions only. Electrical and electronic system components must be installed under separate modification approval. See Note 5 of Type Certificate Data Sheet R00001RC for Limitations of electronics systems modifications.

(See Limitation and Conditions Continued on Page 3 of 3) Gaetano Sciortino Manager New York Aircraft Certification Office Bell Helicopter Textron (Canada) 427 May 20, 2015 May 17, 2000 March 7, 2001 R00001RC 3 "Reissued on May 20, 2015, to supersede the original STC, which has been lost or misplaced."

FAA Form 8110-2 (5/14) Page 2 of

To (Name and address of transferee)

From (Name and address of grantor)

3 SR01296NY

FAA Form 8110-2 (5/14) Page 3 of

3 Date Reissued: May 20, 2015

2. Compliance with FAR 27 has been demonstrated for equipment mounted in accordance with HAS drawing No.

4275302 - 02000, Rev. A, dated September 27, 2000, including 2 Tokimek ADS antennae mounted symmetrically at STA. 238 at both left and right side B.L. 67, each with diameter of 15.3 inches and weight of 17.4lbs.

Deviations from these parameters will require additional demonstration of compliance.

3. The following Bell Helicopter Textron Kits are required with this installation:

a. High Skid Gear, BHT 427-706-010-101, and

b. Cargo Hook Provisions, BHT 427-706-900-103, or Partial Cargo Hook Provisions, BHT 427-899-005-101

4. Flight with both Tokimek ADS antennae (only) removed is permitted.

5. The installer must determine whether this design change is compatible with previously approved modifications.

6. If the holder agrees to permit another person to use the certification to alter the product, the holder must give the other person written evidence of that permission.

---------END--------- SR01296NY