- Holder
- Consolidated Vultee Aircraft Corporation Stinson Division
- Revision
- 0
- Revised
- May 13, 1949
- Status
- Current
- Product
- Aircraft · Small Airplane
- Certification basis
- CAR 4a
- Models
- 2
- Registered
- 61 aircraft
The release keeps the latest revision of each data sheet. Model names are as the data sheet lists them.
On this page
Models · 2
| Model | Also known as | Note |
|---|---|---|
| 10B | ||
| 10A |
Airworthiness directives · 0
ADs whose products are models on this data sheet, matched by model and maker.
No ADs matched this data sheet’s models
Registered aircraft
Registry models that point at this data sheet, with their registered aircraft.
STCs approved under this data sheet · 27
STC SA04652CHTo allow use of 100R grade aviation fuel meeting Swift Fuel, LLC specificationSTC SA01757WITo allow the use of UL91 or UL94 (minimum) grade aviation fuelSTC SA04568CHInstallation of the uAvionix tailBeaconX, a tail mounted position light with integrated Automatic Dependent Surveillance - Broadcast (ADS-B) Out and 1090MHz Mode-S transponder functionality
See all 27 STCsWhat the data sheet says
From the PDF’s text layer, line by line: tables lose their columns. The PDF is the record.
Page No. 1 2 3 4
Rev. No. - - - -
DEPARTMENT OF COMMERCE
CIVIL AERONAUTICS ADMINISTRATION
A-738
STINSON
10A (Army L-9B)
10B
May 13. 1949
AIRCRAFT SPECIFICATION NO. A-738
Manufacturer Consolidated Vultee Aircraft Corp.
Stinson Division
Wayne, Michigan
I - Model 10A (Army L-9B), 3 PCLM, Approved March 3, 1941
Engine Franklin 4AC-199-E3 (See Item 305a for optional engine).
Fuel 80 min. octane aviation gasoline
Engine limits For all operations, 2500 rpm (90 hp)
Airspeed limits Level flight or climb 120 mph True Ind.
Glide or dive 144 mph True Ind.
Flaps extended 85 mph True Ind.
Propeller limits Static rpm at maximum permissible throttle setting:
Not over 2275, not under 2175. No additional tolerance permitted.
Diameter: Not over 78 in., not under 70 in.
(See NOTE 3 for Propeller limits with maximum weight of 1680 lbs.).
C.G. range (+14.7) to (+19.0)
Empty weight C.G. range (+14.6) to (+15.7) with standard fuel only.
(+14.6) to (+15.3) when extra fuel tank (Item 205) is installed.
Ranges are valid for either 1650 or 1680 lbs. maximum weight but not for
non-standard arrangements except as noted.
When empty weight C.G. falls within the pertinent range, computation of critical
fore and aft C.G. positions is unnecessary.
Maximum weight 1650 lbs. (See NOTE 3 regarding 1680 lbs.)
No. seats 3 (two at +16 and one at +39)
Maximum baggage 24 lbs. (+39). Baggage may be increased to 194 lbs. when rear passenger is not carried.
Fuel capacity 20 gals. (right wing tank at +22). See Item 205 for auxiliary fuel tank.
Oil capacity 5 qts. (-41). See Item 206a for larger capacity.
Control surface movements Not available.
Serial Nos. eligible 7761 and up and all AF nos. Use manufacturer's number when available.
Required equipment Items 101, 102, 103, 104 and 105.
A-738 2
II - Model 10B, 3 PCLM, Approved March 3, 1941
Engine Lycoming GO-145-C3 (See Item 305b for optional engine).
Fuel 73 min. octane aviation gasoline
Engine limits For all operations, 3200 rpm (75 hp)
Airspeed limits Level flight or climb 120 mph True Ind.
Glide or dive 144 mph True Ind.
Flaps extended 85 mph True Ind.
Propeller limits Static rpm at maximum permissible throttle setting:
Not over 2950, not under 2850. No additional tolerance permitted.
Diameter: Not over 78 in., not under 76 in.
C.G. range (+14.7) to (+19.0)
Empty weight C.G. range (+14.6) to (+15.7) with standard fuel only.
(+14.6) to (+15.3) when extra fuel tank (Item 205) is installed. Ranges are valid for
non-standard arrangements except as noted. When empty weight C.G. falls within
the pertinent range, computation of critical fore and aft C.G. positions is unnecessary.
Maximum weight 1600 lbs.
No. seats 3 (two at +16 and one at +39)
Maximum baggage 24 lbs. (+39). Baggage may be increased to 194 lbs. when rear passenger is not carried.
Fuel capacity 20 gals. (right wing tank at +22). See Item 205 for auxiliary fuel tank.
Oil capacity 4 qts. (-34). See Item 206b for larger capacity.
Control surface movements Not available.
Serial Nos. eligible 7761 and up.
Required equipment Items 101, 102, 103, 104 and 105.
SPECIFICATIONS PERTINENT TO ALL MODELS
Datum Wing leading edge
Leveling means Top of door frame
Certification basis Type Certificate No. 738 (CAR 4a)
Production basis None. Each aircraft manufactured for civil use subsequent to January 2, 1945, must,
prior to original certification, satisfactorily pass:
(a) An inspection for workmanship, materials and conformity before any covering,
metal priming or final finish is applied. All woodwork may be varnished.
(b) A final inspection of the completed aircraft.
(c) A check of the flight characteristics.
3 A-738
Export eligibility Eligible for export to all countries except as follows, subject to the provisions of
ASR 312 (MOP 2-4 contains the same information):
(a) Canada - Landplane -eligible
Skiplane - not eligible. However, structure complies with
Canadian requirements for ski installation
with a maximum ski height of 8-11/16 in. and a
tread of 6 ft. 11-5/8 in. (center-line of ski 3-11/16 in.
out from edge of torque plate).
Equipment: A plus (+) or minus (-) sign preceding the weight of an item indicates net weight change when that item
is installed.
Propellers and Propeller Accessories 10A 10B
101. Propeller - wood (fixed pitch) with hub 12 lbs. (-53) (-57)
Engines and Engine Accessories - Fuel and Oil System
105. Carburetor air heater 3 lbs. (-35) (-35)
106. AC air filter 1529265 (Aircooled Motors Dwg. SK-534-2) 1 lb. (-41) -----
107. Oil Filter, Fram PB-5, Kit No. 501 (Model 10A only)
Weight includes one qt. of oil 4 lbs. (-25) -----
(a) Fram installation dwg. 61068
(Oil return to fuel pump pad).
(b) Fram installation dwg. 61566
(Oil return to drain plug)
202. Starter, including wiring and switch
(Item 203(a) or 301 required)
(a) Autolite, less solenoid 21 lbs. (-22) -----
(b) Eclipse 22 lbs. ----- (-24)
(c) Delco-Remy 21 lbs. (-22) -----
205. Fuel tank - 20 gal. (in left wing)
(Item 206(a) or (b) required) 15 lbs. (+22) (+22)
206. Oil pans
(a) Franklin - 8 qt. +2 lbs. (-41) -----
(b) Lycoming - 8 qt. +5 lbs. ----- (-34)
216. Shielding 4 lbs. (-32) -----
305. Engines
(a) Model 10A
(1) Franklin 4AC-199E2 -7 lbs. (-40) -----
(b) Model 10B
(1) Lycoming GO-145-C2 -2 lbs. ----- (-41)
Landing Gear
102. 6.00-6 wheels with brakes (Hayes 600M) and 4 ply tires
(wheels must be placarded for these tires) 28 lbs. (+1) (+1)
103. 6x2.00 solid tail wheel 2 lbs. (+168) (+168)
204. Wheel streamlines 6 lbs. (+1) (+1)
211. Puncture seal tubes +1 lb.ea. (+1) (+1)
212. Steerable tail wheel unit +1 lb. (+155) (+155)
214. Skis (Eligible provided the propeller installation meets
the minimum 9 in. ground clearance. The maximum weight for
the skiplane will be the same as for the corresponding
landplane or that shown in parenthesis after each ski model,
whichever is less) Use actual weight change
(a) Federal SC-2 (Maximum 1650 lbs.)
215. Dual brakes +2 lbs. (-6) (-6)
216. Steerable tail wheel (Mack SFS-1) 5 lbs. (+168) (+168)
installed per wheel manufacturer's instructions
303. Parking brake 3 lbs. (+14) (+14)
306. 8.00-4 wheels with brakes (Hayes 841) and 4 ply tires Neglect weight change
(Wheels must be placarded for these tires)
A-738 4
Electrical Equipment 10A 10B
104. Battery - 6 volt, with box 14 lbs. (+14) (+14)
201. Generator
(a) Engine driven (Autolite 12 volts) 12 lbs. (-28) -----
(b) Wind driven (Air Associates GE-20) (6 or 12 volts) 8 lbs. (+12) (+12)
203. Battery - 12 volt, with box and wiring, Dwg. No. 10-64111 40 lbs. (+29) (+29)
209. Landing lights (Grimes ST-250) - one or two 5 lbs.ea. (+14) (+14)
301. Battery - 12 volt with box and wiring (Dwg. No. 10-64111) 40 lbs. (+15) (+15)
Interior Equipment
207. Cabin heater 2 lbs. (-32) (-32)
208. Additional instruments 15 lbs. (-4) (-4)
213. Flares - three 1-minute (International) 8 lbs. (+34) (+34)
302. Carpet5 lbs. (+17) (+17)
NOTE 1. Weight and balance report, together with list of equipment included in certificated weight empty, must be submitted
for each aircraft with original agent's report and each subsequent report showing changes in equipment.
NOTE 2. The following placard is to be conspicuously posted at each filler cap for Model 10A:
"Fill with 80 octane minimum."
NOTE 3. Model 10A also eligible at maximum weight of 1680 lbs. provided the propeller installed falls within the following
limits:
Propeller Static rpm at maximum permissible throttle setting:
Not over 2350, not under 2250. No additional tolerance permitted.
Diameter: Not over 72 in., not under 70 in.
.....END.....