TCDS G37EU

Page No. 1 2 3 4 5 Rev. No. 4 3 4 3 4 DEPARTMENT OF TRANSPORTATION FEDERAL AVIATION ADMINISTRATION G37EU Revision 4 DG Aviation GmbH LS 3 LS 3-a February 7, 2023 TYPE CERTIFICATE DATA SHEET NO. G37EU This data sheet which is a part of type certificate No. G37EU prescribes conditions and limitations under which the product for which the type certificate was issued meets the airworthiness requirements of the Federal Aviation Regulations. Type Certificate Holder: DG Aviation GmbH Otto-Lilienthal-Weg 2 D 76646 Bruchsal Germany Type Certificate Holder Record: DG Flugzeugbau GmbH transferred TC G37EU to DG Aviation GmbH on August 10, 2022. Rolladen Schneider Flugzeugbau Gmbh transferred TC G37EU to DG Flugzeugbau GmbH on July 18, 2006. I. Model LS 3, Glider, Utility Category, approved January 6, 1978 Airspeed Limits (I.A.S.). Never Exceed (Vne) 0 - 9,800 ft. alt. 270 km/h 168 mph 146 kts 9,800 -19,700 ft. alt. 227 km/h 141 mph 123 kts 19,700 -32,800 ft. alt. 180 km/h 112 mph 97 kts In rough air (Vb) 190 km/h 118 mph 103 kts Maneuvering (Va) 190 km/h 118 mph 103 kts Flaps Down (Vfe) 190 km/h 118 mph 103 kts Aero-tow (Vt) 190 km/h 118 mph 103 kts Winch tow (Vw) 130 km/h 81 mph 70 kts Dive brakes 270 km/h 168 mph 146 kts Landing gear (Vl) 270 km/h 168 mph 146 kts Control Surface Movements. Elevator Up 2.20 + 0.2 in. (radius 5.71 in.) Down 2.20 + 0.2 in. (radius 5.71 in.) Aileron, at flap position + 10°, full down Up 2.17 + 0.2 in. (radius 10.94 in.) Down 1.57 + 0.2 in. (radius 10.94 in.) Flaps, initial position + 10°, full down Up 3.23 + 0.2 in. (radius 10.94 in.) Rudder Right 7.28 + 0.39 in. (radius 14.25 in.) Left 7.28 + 0.39 in. (radius 14.25 in.) Dive Brake, at inner lever Up 6.65 + 0.12 in. Radius measured as a chord at root with movement measured at trailing edge. (See Service Manual). G37EU 2 II. Model LS 3-a, Glider, Utility Category, approved March 13, 1980 Airspeed Limits (I.A.S.). Never Exceed (Vne) 0 - 9,800 ft. alt. 270 km/h 168 mph 146 kts 9,800 - 19,700 ft. alt. 219 km/h 136 mph 118 kts 19,700 - 32,800 ft. alt. 173 km/h 107 mph 93 kts In rough air (Vb) 190 km/h 118 mph 103 kts Maneuvering (Va) 190 km/h 118 mph 103 kts Flaps Down from 20° to 10° 160 km/h 99 mph 86 kts Flaps Down from 10° to 0° 190 km/h 118 mph 103 kts Flaps Down from 0° to -7° 270 km/h 168 mph 146 kts Aero-tow (Vt) 190 km/h 118 mph 103 kts Winch tow (Vw) 130 km/h 81 mph 70 kts Dive brakes 270 km/h 168 mph 146 kts Landing gear (Vl) 270 km/h 168 mph 146 kts Control Surface Movements. Elevator Up 350 + 5 mm (13.78 + 0.2 in.) Down 245 + 5 mm (9.65 + 0.2 in.) Radius 148 mm (5.83 + 0.2 in.), distance of reference point on fin 300 mm (11.81 in.) Rudder To both sides 6.89 + 0.39 in. Radius 12.20 in. Aileron Up 16° + 3° (at flap position + 10°) Down -13° + 3° Flaps Up 17° + 3° Down - 5° + 3° Further details regarding permissible deflections of ailerons and flaps are given in the LS 3-a Maintenance Manual. Dive Brake Up 160 + 10 mm (6.30 + 0.39 in) at inner lever. III. DATA PERTINENT TO ALL MODELS: C.G. Range. 250 mm (+9.85 in) to 400 mm (+15.75 in) aft of datum. Empty Weight C.G. See Service Manual Datum. Leading edge of wing at root Leveling Means. Under side of fuselage boom placed horizontal. Maximum Weight. 472 Kg (1040 lb) including water ballast. No. of Seats. 1, adjustable seat back, with seat location at station 590 mm (+23.23 in.) forward of datum. Water Ballast. 2 wing water bags, each 75 liters (75 kg) (166 lb.) at station 250 mm (+9.85 in.) aft of datum. Fixed Ballast. Fixture for 3 ballast weights of 2.45 kg. each (5.5 lb.) at station 1690 mm (+66.5 in.) forward of datum, compensating 5 kg. (11.3 lb.) each at seat position. Baggage. Maximum 11 lb. at station 200 mm (+7.87 in.) aft of datum. 3 G37EU Rated Load for Winch and Aero Tow. Maximum 600 kg (1325 lb.) Serial Numbers Eligible. See Import Requirements Certification Basis. FAR 21.23 and FAR 21.29 effective February 1, 1965. Airworthiness Requirements for sailplanes and powered sailplanes (LFSM). dated October 1975. Type Certificate No. G37EU, issued January 6, 1978. Date of Application for Type Certificate: April 15, 1977. The German Airworthiness Authori ty, the Luftfahrt-Bundesamt (LBA), originally type certificated this glider under its Type Certificate Number 317. The FAA validated this product under U.S. Type Certificate Number G37EU. Effective September 28, 2003, the European Union Aviation Safety Agency (EASA) began oversight of this product on behalf of Germany. The EASA TCDS number is EASA.A.095. Validation Basis. Type Certificate No. G37EU was issued in accordance to FAR 21.29(a)(1) in validation of LBA certification of compliance to the Federal Republic of Germany Sailplanes and Powered Sailplanes Airworthiness Requirements (LFSM) dated October 1975. Import Requirements. The FAA can issue a U.S. airworthiness certificate based on a German Export Certificate of Airworthiness (Export C of A) signed by a representative of the LBA. The Export C of A should contain the following statement: “The aircraft covered by this certificate has been examined, tested, and found to conform to the type design approved under U.S. Type Certificate No. G37EU and to be in a condition for safe operation.” All model LS 3 and LS 3-a gliders are eligible for a U.S. Standard Airworthiness Certificate, if all import requirements of this TCDS are satisfied. Refer to the applicable bilateral agreement to verify eligibility for import into the United States of both new and used aircraft based on the scope of the agreement, to identify any required statements by the exporting authority on the export certificate of airworthiness (or equivalent document), and for procedures for coordinating exceptions to conformity statements on these documents. Refer to FAA Order 8130.2, Airworthiness Certification of Aircraft, for requirements for issuance of an airworthiness ce rtificate for imported aircraft. Model LS 3 serial nos 3002 through 3319 are eligible for a U.S. Standard Airworthiness Certificate when all actions or modifications have been accomplished in accordance with LBA-approved Rolladen Schneider Technical Bulletin 3011. Model LS 3-a serial numbers 3259, 3274, 3280,3281, 3287, 3305, 3314, 3315, 3324 to 3328, 3332, 2249 to 3355, 3357, 3359, 3373 to 3378, 3398, 3399, 3401, 3422, 3423 are eligible for a U.S. Standard Airworthiness Certificate when all actions or modifications have been accomplished in accordance with LBA approved Rolladen-Schneider Technical Bulletin. Equipment. The basic required equipment as prescribed in the applicable airworthiness regulations (see Certification Basis) must be installed in the glider for certification. As listed in Service/Maintenance Manual the following equipment must be installed. 1. Non-cloud flying - Airspeed indicator - Altimeter - Magnetic compass 2. Cloud flying - Turn and slip - Variometer 3. LS 3/LS 3-a Flight and Service / Maintenance Manual approved by the LBA. Service Information. Each of the documents listed below must state that it is approved by the EASA or – for approvals made before September 28, 2003 – by the LBA. G37EU 4 • Service bulletins • Structural repair manuals • Vendor manuals • Aircraft flight manuals • Overhaul and maintenance manuals The FAA accepts such documents and considers them FAA-approved for type design data unless one of the following conditions exist: • The documents change the limitations, performance, or procedures of the FAA approved manuals. The FAA uses the post type validation procedures to approve these documents. The FAA may delegate case-by-case approval to EASA on behalf of the FAA for the U.S. type certificate. If this is the case it will be noted on the document. NOTES. NOTE 1. Current weight and balance report including list of equipment in certificated empty weight, and loading instructions, when necessary, must be provided for each glider at the time of original certification. NOTE 2. A. The following placard must be installed in full view of the pilot: 1. Airspeed Limits (I.A.S.) Never Exceed (Vne) 270 km/h 168 mph 146 kts In rough air (Vb) 190 km/h 118 mph 103 kts Maneuvering (Va) 190 km/h 118 mph 103 kts Flaps down(LS 3) (Vfe) 190 km/h 118 mph 103 kts 20° - 10° (LS 3-a) (Vfe) 160 km/h 99 mph 86 kts 10° - 0° 190 km/h 118 mph 103 kts Aero-tow (Vt) 190 km/h 118 mph 103 kts Winch tow (Vw) 130 km/h 81 mph 70 kts Dive brakes 270 km/h 168 mph 146 kts Landing gear (Vl) 270 km/h 168 mph 146 kts Airspeed Ind. (Vne) Vne up to 9,800 ft 168 mph 146 kts 19,700 ft (LS 3) 141 mph 123 kts 32,800 ft 112 mph 97 kts Vne up to 9,800 ft 168 mph 146 kts 19,700 ft (LS 3-a) 136 mph 118 kts 32,800 ft 107 mph 93 kts 2. Maximum weight 472 kg (1040 lb.) including water ballast. 3. LS 3/LS 3-a Checklist: This sailplane must be operated in compliance with operating limitations as stated in the form of markings, placards, and Flight Manual. LS 3 LS 3-a a. Lock main pins a. Lock main pins b. Lock horizontal tail b. Lock horizontal tail c. Connect chute static line c. Connect ailerons d. Lock dive brakes d. Test controls e. Flap positioning: Winch tow and e. Fasten seat belt harness Aero tow f. Connect chute static line around 0° g. lock dive brakes f. Test controls h. Flap positioning during takeoff: 0° g. Lock canopy i. Lock canopy h. Check release j. Check release 4. No aerobatic maneuvers approved. 5 G37EU 5. Minimum cockpit load...kg (without fixed ballast) (See Flight Manual page 1.6 and 1.7) B. Other markings and placards. 1. Cockpit signs (See Service/Maintenance Manual). NOTE 3. All external portions of the glider exposed to sunlight must be painted white except of wingtips, nose of fuselage and rudder. NOTE 4. Maintenance, Inspection and Repairs must be accomplished with the LS 3/LS 3-a Flight and Service / Maintenance Manual as applicable. NOTE 5. Major repairs must be accomplished at FAA certificated repair stations rated for composite aircraft structure work or by a certified mechanic, in accordance with DG Aviation GmbH (or DG Flugzeugbau GmbH or Rolladen-Schneider Flugzeugbau GmbH) repair methods approved by the FAA or by other methods approved by the FAA. ...END...