- Holder
- Helitec Corporation
- Revision
- 1
- Revised
- January 24, 2005
- Status
- Current
- Product
- Aircraft · Rotorcraft
- Certification basis
- Part 21
- Models
- 1
The release keeps the latest revision of each data sheet. Model names are as the data sheet lists them.
On this page
Models · 1
| Model | Also known as | Note |
|---|---|---|
| H-S-1N |
Airworthiness directives · 0
ADs whose products are models on this data sheet, matched by model and maker.
No ADs matched this data sheet’s models
STCs approved under this data sheet · 4
STC SH3319NMInstallation of Precise Flight Pulselite Control Unit in the
Landing /Taxi Recognition Visual Control Light system,STC SA00068SEInstallation of fuel flow/pressure instruments. (W/TSIO-360-MB1)STC SA4005NMPrecise Flight Inc. Pulselite Control SystemSTC SA4302NMInstallation of Electronics Int'l digital automatic engine analyzer.
What the data sheet says
From the PDF’s text layer, line by line: tables lose their columns. The PDF is the record.
DEPARTMENT OF TRANSPORTATION
FEDERAL AVIATION ADMINISTRATION
H12WE
Revision 1
Helitec Corporation
H-S-1N
Revised January 24, 2005
TYPE CERTIFICATE DATA SHEET NO. H12WE
This data sheet which is a part of type certificate No. H12WE prescribes conditions and limitations under which the product for
which the type certificate was issued meets the airworthiness requirements of the Federal Aviation Regulations.
Type Certificate Holder: This Type Certificate (TC) has been designated as ABANDONED (See Note 6)
Type Certificate Holder Record: Helitec Corporation
4930 E. Falcon Dr.
Mesa, Arizona 85205
I. Model H-S-1N (Restricted Category) approved April 28, 1980
Engine Wright Cyclone, R-1820-84A/84C
Fuel 100/130 or 115/145 min. grade aviation gasoline
Engine limits HP RPM M.P. IN.HG. ALT.
Fuel Grade 115/145
Maximum continuous 1275 2500 47.5 S.L.
Maximum continuous 1275 2500 46.0 3500 ft.
Takeoff 1525 2800 56.5 S.L.
Takeoff 1525 2800 55.5 700 ft.
(Straight Line Manifold Pressure variation with altitudes shown)
Fuel Grade 100/130
Maximum continuous 1275 2500 47.5 S.L.
Maximum continuous 1275 2500 46.0 3500 ft.
Takeoff 1325 2800 50.0 S.L.
Takeoff 1325 2800 49.5 2000 ft.
(Straight Line Manifold Pressure variation with altitudes shown)
Rotor Limits Maximum 258 r.p.m.
Minimum 170 r.p.m.
Airspeed limits Vne (Never exceed) 120 CAS
(See Note 2 for required placard)
C.G. range (+130.7) to (+146.7)
Datum 137.7 inches forward of main rotor centroid
Leveling means Plumb bob from top of cabin door frame to scale on lower door sill
Maximum weight 12,700
Minimum Crew 1 (pilot) (See note 2)
Fuel capacity Location Volume (Gal.) Arm (Inches)
Fwd. Tank 100.5 +121
Center Tank 70.0 +184
Aft Tank 92.0 +223
Page No. 1 2 3
Rev. No. 1 1 1
H12WE Page 2 of 3 Revision 1
Oil capacity 12.4 gals. (+75)
Rotor Blade &
Control Movements For rigging information refer to Maintenance Manual SA4045-15
Other Operating
Limitations See Flight Manual NAVWEP-01-230-HLAA-1, TO1H-34H(J)-15-16, dated 6/6/73.
Serial Nos. Eligible All Navy serial numbers
DATA PERTINENT TO ALL MODELS:
Certification Basis FAR 21.25(a)(2) effective February 1, 1965.
Type Certificate No. H12WE issued April 28, 1980 for the purpose of:
Carriage of external loads, per FAR 133 Date of application for Type Certificate
was February 8, 1980
The military helicopters certificated restricted category under Type Certificate No.
H12WE with aluminum engine mount fittings P/N 1620-61435-series are not eligible for
standard category S-58 configuration. Prior to standard airworthiness certification,
information regarding eligibility and modification to be accomplished should be obtained
from Sikorsky Aircraft.
Production Basis None. Prior to original airworthiness certification of each aircraft, FAA personnel must
perform an airworthiness inspection determining condition for safe operation and
determine the applicant has conducted a satisfactory flight test. See NOTE 4 for data on
Service Bulletins and ADs.
Equipment: The basic required equipment as prescribed for the special purpose operation and as
necessary for safe operation must be installed in each helicopter.
NOTE 1. Current weight and balance report including list of equipment included in certificated empty weight, and
loading instructions, when necessary, must be in each helicopter at the time of original airworthiness
certification and at all times thereafter.
NOTE 2. The following placard must be prominently displayed in the cockpit in full view of the pilot (On Instrument
Panel):
(a) "Avoid fast turns, 15 sec. minimum for 360 degrees."
(b) "During extended hovering, close windows and doors and turn vent system on. Close left windows
during starting and taxiing."
(c) "Avoid taxi turns below 2400 engine r.p.m."
(d) "Never exceed speeds. Variation on Vne with altitude, engine r.p.m. and manifold pressure."
2200 r.p.m. 2300 r.p. m. 2400 r.p.m. 2500 r.p.m.
Alt. IAS M.P. IAS M.P. IAS M.P. IAS M.P.
S.L. 72 35.5 87 38.7 103 42.3 117 47.5
5,000 - - - - 60 37.0 76 41.0 90 F.T.
10,000 - - - - - - - - - - - - 63 F.T.
(e) "Maximum Approved Gross Weight 12,700 lbs."
(f) "This helicopter must be operated in compliance with the operating limitations specified in the Navy
Flight Handbook, NAVWEP 01-230-HLAA-1, TO1H-34H(J)-15-16, dated June 6, 1973."
Revision 1 Page 3 of 3 H12WE
(g) "This helicopter has been certified in the rest ricted category for External-Load Operations only."
NOTE 3. Replacement times for life-limited parts are specified in Sikorsky S-58 Maintenance Manual Publication No.
SA4045-15 Part IV, Section IV, revised March 1, 1971, unless superseded by appropriate Airworthiness
Directives. The replacement period can not be extended without FAA approval.
NOTE 4. Prior to civil airworthiness certifi cation, the following must be accomplished:
(a) The provisions of the following ADs and all subsequent applicable ADs.
ADs 57-19-02, 59-16-04, 60-17-03, 60-24-04, 61-01-03, 64-02-06, 66-19-04, 74-15-06, 75-07-07,
75-07-08 and 75-13-01.
(b) The provisions of the following Sikorsky Servi ce Bulletins 58B: General-1, General-2, 10-2, 10-3,
10-5, 10-7, 10-10A, 15-1F, 15-2B, 15-3, 15-4H , 15-5C, 15-6A, 15-8, 15-14A, 20-10, 20-2, 20-6B,
20-7A, 20-9A, 20-10, 20-11, 20-12H, 20-14B, 20-15, 25-1, 30-1, 30-4, 35-1A, 35-2, 35-3B, 35-5A,
35-6, 35-7A, 35-8B, 35-9, 35-11, 35-16C, 35-17B , 35-18B, 35-19, 40-1, 40-2, 40-4, 65-1, 65-2A,
65-3B and 65-4A.
(c) Deactivate Automatic Flight Control System if installed.
NOTE 5. Maintenance will be accomplished in acco rdance to the S-58 Maintenance Manual SA4045-15.
Component overhaul intervals shall be in accordance with "Sikorsky Aircraft Engineering Recommended
and Customer Approved Component Overhaul Intervals and Replacement Times," Parts I and II, dated 5
September 1956.
NOTE 6. This Type Certificate (TC) has been designated "ABANDONED". A “Notice of Intent To Designate as
Abandoned Certain Type Certificates Issued in the Restricted Category,” was published by the Federal
Aviation Administration (FAA) in the Federal Register on August 8, 2003 (68 FR 47379). That Notice listed
this TC. The FAA received no comments on the published Notice. The FAA has been unable to contact this
TC holder. Hence, the FAA has determined that this TC holder is not complying with its Continued
Operational Safety (COS) responsibilities. Therefore, no additional aircraft will be added to this TC and no
additional original airworthiness certificates will be issued based on this TC. The effectiveness of this TC is
limited to those aircraft that received original airworthiness certification prior to the incorporation of this
note (Date of Incorporation, January 24, 2005). Subsequently, if the TC holder is located and assumes their
COS responsibilities, the restriction(s) imposed by this note may be lifted.
...END...