AD 2003-06-03

Effective April 24, 2003. The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of April 24, 2003.

The service information referenced in this AD may be obtained from General Electric Aircraft Engines CT7 Series Turboprop Engines, 1000 Western Ave, Lynn, MA 01910; telephone (781) 594-3140, fax (781) 594-4805. This information may be examined, by appointment, at the Federal Aviation Administration (FAA), New England Region, Office of the Regional Counsel, 12 New England Executive Park, Burlington, MA; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

Barbara Caufield, Aerospace Engineer, Engine Certification Office, FAA, Engine and Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803-5299; telephone (781) 238-7146; fax (781) 238-7199.

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an AD that is applicable to certain GEAE CT7 series turboprop engines was published in the Federal Register on June 13, 2002 (67 FR 40623). That action proposed to require initial and repetitive inspections of the PGB oil filter IBB for extension (popping), follow-on inspections, maintenance, and replacement actions if the PGB oil filter IBB is popped, and if necessary, replacement of the PGB with a serviceable PGB. In addition, that action proposed to require replacement of certain left-hand and right-hand idler gears at time of overhaul of PGBs, and the replacement of certain SN PGBs before accumulating 2,000 flight hours in accordance with GEAE CT7 Turboprop Service Bulletin CT7-TP S/B 72-0453, dated July 27, 2001 and GEAE CT7 Turboprop Service Bulletin CT7-TP S/B 72-0452, dated July 27, 2001.

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were received on the proposal or the FAA's determination of the cost to the public. The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

There are approximately 150 engines of the affected design installed on airplanes of U.S. registry that would be affected by this AD. The FAA estimates that each IBB inspection would take approximately 0.25 work hours per engine, and the average labor rate is $60 per work hour. Inspection and replacement of idler gears would take approximately four work hours per engine at time of PGB overhaul. Replacement cost for idler gears per PGB is estimated to be $140,670. Replacement of a PGB would take approximately 48 hours. Therefore, the total cost of the AD to U.S. operators would be approximately $21,138,750.

This final rule does not have federalism implications, as defined in Executive Order 13132, because it would not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Accordingly, the FAA has not consulted with state authorities prior to publication of this final rule.

For the reasons discussed above, I certify that this action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES.

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

1. The authority citation for part 39 continues to read as follows:

2. Section 39.13 is amended by adding a new airworthiness directive to read as follows:

2003-06-03 General Electric Aircraft Engines: Amendment 39-13090. Docket No. 99-NE-48-AD.

Applicability: This airworthiness directive (AD) is applicable to General Electric Aircraft Engines (GEAE) CT7 series turboprop engines, with propeller gearboxes (PGBs) identified by serial number (SN) in Table 1 of GEAE CT7 Turboprop Service Bulletin CT7-TP S/B 72-0452, dated July 27, 2001. These engines are installed on but not limited to SAAB 340 series airplanes.

Note 1:

This AD applies to each engine identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For engines that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (f) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Compliance with this AD is required as indicated, unless already done.

To prevent separation of PGB left-hand and right-hand idler gears, which could result in uncontained PGB failure and internal bulkhead damage, possibly prohibiting the auxiliary feathering system from fully feathering the propeller on certain PGBs, do the following:

(a) Inspect the PGB oil filter impending bypass button (IBB) for extension in accordance with the following schedule:

(1) Initially inspect within 50 hours time-in-service (TIS) after the effective date of this AD.

(2) Thereafter, inspect each operational day.

(b) If the PGB oil filter IBB is extended, replace the oil filter and perform follow-on inspections in accordance with 3.A of the Accomplishment Instructions of GEAE CT7 Turboprop Service Bulletin CT7-TP S/B 72-0453, dated July 27, 2001.

(c) At the next return of the PGB to a CT7 turboprop overhaul facility after the effective date of this AD, replace left-hand and right-hand idler gears in accordance with the Accomplishment Instructions of GEAE CT7 Turboprop Service Bulletin CT7-TP S/B 72-0452, dated July 27, 2001.

(d) If the PGB is mated to a Hamilton Standard propeller and the left-hand and right-hand idler gears have not been replaced in accordance with the Accomplishment Instructions of GEAE CT7 Turboprop Service Bulletin CT7-TP S/B 72-0452, dated July 27, 2001, replace the PGB before accumulating an additional 2,000 engine flight hours after the effective date of this AD.