AD 2008-23-13

Airworthiness directive · Hydraulic pump case drain check valve · Textron 390

Effective
December 22, 2008
Published
November 17, 2008 · 73 FR 67714–67716
Issued
November 5, 2008
Model
390
Data sheet
TCDSA00010WI
Registered aircraft
196 matched by model
Product
Aircraft · Small airplane
Amendment
39-15734
Docket
FAA-2008-0492
Project
2008-CE-023-AD
Issued as
Final rule

Unofficial copy from the Federal Register XML, document E8-26879. Only the govinfo PDF is the legal edition. DRS record last changed January 21, 2026.

On this page

Summary

We are adopting a new airworthiness directive (AD) for certain Hawker Beechcraft Corporation (HBC) Model 390 airplanes. This AD requires you to remove the current preformed packing, elbow fitting, and jam nut from the left and right hydraulic pump pressure output port and replace with new parts. This AD also requires you to install a hydraulic pump case drain check valve. This AD results from nine occurrences of hydraulic fluid leaking from the engine hydraulic pump output fitting as a result of an improperly installed elbow connecting the output port to the pulse dampener hose. We are issuing this AD to prevent hydraulic fluid leaks from the left and right hydraulic fluid pump and to prevent the flow of hydraulic fluid into the engine compartment. The loss of hydraulic fluid can result in loss of airplane hydraulic system pressure and the consequent loss of hydraulic system functions including gear extension/retraction, spoiler functions, and anti-skid braking system actuation. The inability of the hydraulic installation to isolate flow of hydraulic fluid could result in a hazardous amount of flammable fluid in the corresponding engine compartment. These conditions, if not corrected, could result in loss of system functions and/or fire in the engine compartment.

The airworthiness directive

2008-23-13 Hawker Beechcraft Corporation: Amendment 39-15734; Docket No. FAA-2008-0492; Directorate Identifier 2008-CE-023-AD.

(a) Effective Date

PDF page 2

(a) This AD becomes effective on December 22, 2008.

(b) Affected ADs

PDF page 2

(b) None.

(c) Applicability

PDF page 2

(c) This AD applies to Model 390 airplanes, serial numbers RB-4 through RB-224, that are certificated in any category.

(d) Unsafe Condition

PDF page 2

(d) This AD results from nine occurrences of hydraulic fluid leaking from the engine hydraulic pump output fitting as a result of an improperly installed elbow connecting the output port to the pulse dampener hose. We are issuing this AD to prevent hydraulic fluid leaking from the left and right hydraulic fluid pump and to prevent the flow of hydraulic fluid into the engine compartment. The loss of hydraulic fluid can result in loss of airplane hydraulic system pressure and the consequent loss of hydraulic system functions including gear extension/retraction, spoiler functions, and anti-skid braking system actuation. The inability of the hydraulic installation to isolate flow of hydraulic fluid could result in a hazardous amount of flammable fluid in the corresponding engine compartment. These conditions, if not corrected, could result in loss of system functions and/or fire in the engine compartment.

(e) Compliance

PDF page 2

(e) To address this problem, you must do the following, unless already done:

ActionsComplianceProcedures
(1) Remove current preformed packing (part number (P/N) MS28778-6), elbow fitting (P/N MS21908J6), and jam nut (P/N AN924-6J) from the left and right hydraulic pump pressure output port and install new preformed packing (P/N MS28778-6), union (P/N MS21902J6), and swivel fitting (P/N NAS1762J0606) in the left and right hydraulic pressure pump output portWithin the next 200 hours time-in-service (TIS) after December 22, 2008 (the effective date of this AD) or within the next 6 months after December 22, 2008 (the effective date of this AD), whichever occurs firstFollow Hawker Beechcraft Mandatory Service Bulletin SB 29-3869, dated January 2008.
(2) Install hydraulic pump case drain check valve Kit No. 390-5803-0001Within the next 200 hours TIS after December 22, 2008 (the effective date of this AD) or within the next 6 months after December 22, 2008 (the effective date of this AD), whichever occurs firstHawker Beechcraft Mandatory Service Bulletin SB 29-3851, dated January 2008.

(f) Alternative Methods of Compliance (AMOCs)

PDF page 3

(f) The Manager, Wichita Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Aaron Waters, Aerospace Engineer, Wichita ACO, 1801 Airport Road, Room 100, Wichita, Kansas 67209; telephone: (316) 946-4174; fax: (316) 946-4107. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.

(g) Material Incorporated by Reference

PDF page 3

(g) You must use Hawker Beechcraft Mandatory Service Bulletin SB 29-3869, dated January 2008; and Hawker Beechcraft Mandatory Service Bulletin SB 29-3851, dated January 2008, to do the actions required by this AD, unless the AD specifies otherwise.

(1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) For service information identified in this AD, contact Hawker Beechcraft Corporation, 9709 East Central, Wichita, Kansas 67201; telephone: (316) 676-5034; fax: (316) 676-6614; Internet: https://www.hawkerbeechcraft.com/service_support/pubs/.

(3) You may review copies at the FAA, Central Region, Office of the Regional Counsel, 901 Locust, Kansas City, Missouri 64106; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.

Rule preamble

The FAA’s background, reasoning and cost estimate, published with the AD.

DatesPage 1

This AD becomes effective on December 22, 2008.

On December 22, 2008, the Director of the Federal Register approved the incorporation by reference of certain publications listed in this AD.

AddressesPage 1

For service information identified in this AD, contact Hawker Beechcraft Corporation, 9709 East Central, Wichita, Kansas 67201; telephone: (316) 676-5034; fax: (316) 676-6614; Internet: https://www.hawkerbeechcraft.com/service_support/pubs/.

To view the AD docket, go to U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590, or on the Internet at http://www.regulations.gov. The docket number is FAA-2008-0492; Directorate Identifier 2008-CE-023-AD.

For further information contactPage 1

Aaron Waters, Aerospace Engineer, 1801 Airport Road, Room 100, Wichita, Kansas 67209; telephone: (316) 946-4174; fax: (316) 946-4107.

DiscussionPage 1

On April 24, 2008, we issued a proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an AD that would apply to certain Model 390 airplanes. This proposal was published in the Federal Register as a notice of proposed rulemaking (NPRM) on May 1, 2008 (73 FR 23988). The NPRM proposed to require you to remove the current preformed packing, elbow fitting, and jam nut from the left and right hydraulic pump pressure output port and replace with new parts. The NPRM also proposed to require you to install a hydraulic pump case drain check valve.

CommentsPage 1

We provided the public the opportunity to participate in developing this AD. We received no comments on the proposal or on the determination of the cost to the public.

ConclusionPage 1

We have carefully reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed except for minor editorial corrections. We have determined that these minor corrections:

• Are consistent with the intent that was proposed in the NPRM for correcting the unsafe condition; and

• Do not add any additional burden upon the public than was already proposed in the NPRM.

Costs of CompliancePage 1

We estimate that this AD affects 182 airplanes in the U.S. registry.

We estimate the following costs to do the modifications:

Labor costParts costTotal cost per airplaneTotal cost on U.S. operators
Hydraulic pressure output fitting assembly: 8 work-hours × $80 per hour = $640$100$740$134,680
Hydraulic pump case drain check valve: 16 work-hours × $80 per hour = $1,2804,3535,6331,025,206

HBC will provide warranty credit as specified in Hawker Beechcraft Mandatory Service Bulletin SB 29-3869, dated January 2008; and Hawker Beechcraft Mandatory Service Bulletin SB 29-3851, dated January 2008.

Authority for This RulemakingPage 2

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106 describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this AD.

Regulatory findingsPage 2

We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

1. Is not a “significant regulatory action” under Executive Order 12866;

2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a summary of the costs to comply with this AD (and other information as included in the Regulatory Evaluation) and placed it in the AD Docket. You may get a copy of this summary by sending a request to us at the address listed under ADDRESSES. Include “Docket No. FAA-2008-0492; Directorate Identifier 2008-CE-023-AD” in your request.

Adoption of the amendmentPage 2

Accordingly, under the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

1. The authority citation for part 39 continues to read as follows:

2. FAA amends § 39.13 by adding the following new AD:

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 196

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Raytheon130 aircraft
  • Hawker Beechcraft66 aircraft
By year built
20012012
Registered aircraft by year built: 118 aircraft
20019
200214
20036
20047
20057
20065
200731
200821
200910
20103
20114
20121

78 with no year recorded

By model

Aircraft

See all 196 aircraft