AD 2012-26-14

Historical

Airworthiness directive · High-pressure (HP) compressor stages 1 to 6 rotor disc assembly · Rolls-Royce Deutschland BR700-715A1-30, BR700-715B1-30 and BR700-715C1-30

Effective
January 10, 2013
Published
January 10, 2013 · 78 FR 2195–2197
Issued
December 27, 2012
Superseded by
AD2014-07-02
Models
BR700-715A1-30, BR700-715B1-30, BR700-715C1-30
Data sheet
TCDSE00061EN
Registered aircraft
519 matched by model
Product
Engine
Amendment
39-17309
Docket
FAA-2012-1202
Project
2012-NE-38-AD
Issued as
Final rule; request for comments

Unofficial copy from the Federal Register XML, document 2012-31588. Only the govinfo PDF is the legal edition. DRS record last changed August 7, 2025.

On this page

Summary

We are adopting a new airworthiness directive (AD) for all Rolls-Royce Deutschland Ltd & Co KG BR700-715A1-30, BR700-715B1-30, and BR700-715C1-30 turbofan engines. This AD requires a one-time removal from service of the high-pressure (HP) compressor stages 1 to 6 rotor disc assembly before exceeding certain thresholds. This AD was prompted by a report of silver chloride-induced stress corrosion cracking of the HP compressor stages 1 to 6 rotor disc assembly, identified during overhaul. We are issuing this AD to prevent failure of the HP compressor stages 1 to 6 rotor disc assembly, which could result in uncontained failure of the engine and damage to the airplane.

The airworthiness directive

2012-26-14 Rolls-Royce Deutschland Ltd & Co KG (Formerly Rolls-Royce Deutschland GmbH, formerly BMW Rolls-Royce GmbH): Amendment 39-17309; Docket No. FAA-2012-1202; Directorate Identifier 2012-NE-38-AD.

(a) Effective Date

PDF page 2

This airworthiness directive (AD) becomes effective January 10, 2013.

(b) Affected ADs

PDF page 2

None.

(c) Applicability

PDF page 2

This AD applies to all Rolls-Royce Deutschland Ltd & Co KG BR700-715A1-30, BR700-715B1-30, and BR700-715C1-30 turbofan engines.

(d) Reason

PDF page 2

This AD was prompted by a report of silver chloride-induced stress corrosion cracking of the high-pressure (HP) compressor stages 1 to 6 rotor disc assembly, identified during overhaul. We are issuing this AD to prevent failure of the HP compressor stages 1 to 6 rotor disc assembly, which could result in uncontained failure of the engine and damage to the airplane.

(e) Actions and Compliance

PDF page 2

Unless already done, do the following actions.

(1) BR700-715A1-30 Turbofan Engines Operated Under the Hawaiian Flight Mission Only

PDF page 2

For BR700-715A1-30 turbofan engines operated under the Hawaiian Flight Mission only, do the following:

(1) If the HP compressor stages 1 to 6 rotor disc assembly has accumulated 15,700 flight cycles since new or fewer on the effective date of this AD, remove the rotor disc assembly from service before exceeding 16,000 flight cycles since new (CSN).

(2) If the HP compressor stages 1 to 6 rotor disc assembly has accumulated more than 15,700 flight CSN on the effective date of this AD, remove the rotor disc assembly from service within 300 flight cycles.

(2) BR700-715A1-30, BR700-715B1-30, and BR700-715C1-30 Turbofan Engines (All Flight Missions Except the Hawaiian Flight Mission)

PDF page 2

For BR700-715A1-30, BR700-715B1-30, and BR700-715C1-30 turbofan engines (all flight missions except the Hawaiian Flight Mission), do the following:

(1) If the HP compressor stages 1 to 6 rotor disc assembly has accumulated 13,700 flight CSN or fewer on the effective date of this AD, remove the rotor disc assembly from service before exceeding 14,000 flight CSN.

(2) If the HP compressor stages 1 to 6 rotor disc assembly has accumulated more than 13,700 flight cycles since new on the effective date of this AD, remove the rotor disc assembly from service within 300 flight cycles.

(f) Terminating Action

PDF page 2

Performing the one-time removal from service of the stages 1 to 6 rotor disc assembly, as specified in this AD, is terminating action to this AD.

(g) Definition

PDF page 2

For the purpose of this AD, flight cycles is the total flight CSN on the HP compressor stages 1 to 6 rotor disc assembly, without any pro-rated calculations applied for different flight missions. Guidance on calculating total flight cycles can be found in Rolls-Royce Deutschland Ltd & Co KG Notice to Operators BR715 engines NTO: No. 184, dated October 25, 2012.

(h) Alternative Methods of Compliance (AMOCs)

PDF page 2

The Manager, Engine Certification Office, may approve AMOCs for this AD. Use the procedures found in 14 CFR 39.19 to make your request.

(i) Related Information

PDF page 2

(1) For more information about this AD, contact Frederick Zink, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; phone: 781-238-7779; fax: 781-238-7199; email: frederick.zink@faa.gov.

(2) Refer to European Aviation Safety Agency AD 2012-0230, dated October 30, 2012, and Rolls-Royce Deutschland Ltd & Co KG Alert Service Bulletin No. SB-BR700-72-A900401, dated October 25, 2012, for related information.

(3) For service information identified in this AD, contact Rolls-Royce Deutschland Ltd & Co KG, Eschenweg 11, Dahlewitz, 15827 Blankenfelde-Mahlow, Germany; telephone: 49 0 33-7086-1883; fax: 49 0 33-7086-3276. You may view copies of the referenced service information at the FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA. For information on the availability of this material at the FAA, call 781-238-7125.

Rule preamble

The FAA’s background, reasoning and cost estimate, published with the AD.

DatesPage 1

This AD becomes effective January 10, 2013.

We must receive comments on this AD by February 25, 2013.

AddressesPage 1

You may send comments by any of the following methods:

• Federal eRulemaking Portal: Go to http://www.regulations.gov and follow the instructions for sending your comments electronically.

• Mail: U.S. Department of Transportation, 1200 New Jersey Avenue SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-0001.

• Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

• Fax: 202-493-2251.

For service information identified in this AD, contact Rolls-Royce Deutschland Ltd & Co KG, Eschenweg 11, Dahlewitz, 15827 Blankenfelde-Mahlow, Germany; telephone: 49 0 33-7086-1883; fax: 49 0 33-7086-3276. You may view copies of the referenced service information at the FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803. For information on the availability of this material at the FAA, call 781-238-7125.

For further information contactPage 1

Frederick Zink, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; phone: 781-238-7779; fax: 781-238-7199; email: frederick.zink@faa.gov.

DiscussionPage 1

The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA Airworthiness Directive 2012-0230, dated October 30, 2012 (referred to hereinafter as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:

Silver chloride-induced stress corrosion cracking was identified during overhaul of a BR700-715 engine, on the High Pressure Compressor (HPC) stages 1 to 6 rotor disc assembly. Subsequent evaluation concluded that the affected part life limitation values declared in the engine Time Limits Manual cannot be supported for high cyclic life HPC discs.

This condition, if not corrected, could lead to uncontained HPC disc failure, possibly resulting in damage to, and/or reduced control of the aeroplane.

You may obtain further information by examining the MCAI in the AD docket.

FAA's Determination and Requirements of This ADPage 1

This product has been approved by the aviation authority of Germany, and is approved for operation in the United States. Pursuant to our bilateral agreement with Germany, they have notified us of the unsafe condition described in the MCAI referenced above. We are issuing this AD because we evaluated all information provided by EASA and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design. This AD requires a one-time removal from service of the HP compressor stages 1 to 6 rotor disc assembly before exceeding certain thresholds.

FAA's Determination of the Effective DatePage 1

An unsafe condition exists that requires the immediate adoption of this AD. The FAA has found that the risk to the flying public justifies waiving notice and comment prior to adoption of this rule because of the short compliance times for HP compressor stages 1 to 6 rotor disc assemblies that are at or over the removal thresholds. Therefore, we determined that notice and opportunity for public comment before issuing this AD are impracticable and that good cause exists for making this amendment effective in fewer than 30 days.

Comments invitedPage 1

This AD is a final rule that involves requirements affecting flight safety, and we did not precede it by notice and opportunity for public comment. We invite you to send any written relevant data, views, or arguments about this AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2012-1202; Directorate Identifier 2012-NE-38-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this AD. We will consider all comments received by the closing date and may amend this AD because of those comments.

We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this AD. Using the search function of the Web site, anyone can find and read the comments in any of our dockets, including, if provided, the name of the individual who sent the comment (or signed the comment on behalf of an association, business, labor union, etc.). You may review the DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78).

Authority for This RulemakingPage 2

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory findingsPage 2

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this AD:

1. Is not a “significant regulatory action” under Executive Order 12866;

2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket.

Adoption of the AmendmentPage 2

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

Adoption of the amendmentPage 2

1. The authority citation for part 39 continues to read as follows:

2. The FAA amends § 39.13 by adding the following new AD:

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 519

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Gulfstream Aerospace322 aircraft
  • Boeing104 aircraft
  • Bombardier92 aircraft
  • Cessna1 aircraft
By year built
19962025
Registered aircraft by year built: 500 aircraft
19963
199718
199819
199940
200060
200156
200232
200320
200433
200528
20068
20076
20082
20092
20102
20112
20136
20149
201540
201643
201731
201826
20192
20207
20212
20253

19 with no year recorded

By model

Aircraft

See all 519 aircraft