AD 2014-12-03

This AD becomes effective July 17, 2014.

For service information identified in this AD, contact Rolls-Royce Deutschland Ltd & Co KG, Eschenweg 11, Dahlewitz, 15827 Blankenfelde-Mahlow, Germany; phone: 49 0 33-7086-1883; fax: 49 0 33-7086-3276. You may view this service information at the FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803. For information on the availability of this material at the FAA, call 781-238-7125.

Michael Davison, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; phone: (781) 238-7156; fax: (781) 238-7199; email: michael.davison@faa.gov.

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to the specified products. The NPRM was published in the Federal Register on February 14, 2014 (79 FR 8905). The NPRM proposed to correct an unsafe condition for the specified products. The MCAI states:

Occurrences have been reported of finding wear on the receptors of the double-ended unions in the Fuel Metering Unit (FMU) housing on BR700-725A1-12 engines.

This condition, if not corrected, could lead to fuel leak resulting in engine in-flight shutdown and consequent reduced control of the aeroplane.

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM (79 FR 8905, February 14, 2014).

We reviewed the available data and determined that air safety and the public interest require adopting this AD as proposed.

We estimate that this AD affects 24 RRD turbofan engines installed on aircraft of U.S. registry. We also estimate that it would take about 6 hours per engine to comply with this AD. The average labor rate is $85 per hour. Required parts cost about $293,960 per engine. Based on these figures, we estimate the cost of this AD on U.S. operators to be $7,067,280.

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this AD:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),

(3) Will not affect intrastate aviation in Alaska to the extent that it justifies making a regulatory distinction, and

(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

1. The authority citation for part 39 continues to read as follows:

2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):