AD 2017-10-19

This AD becomes effective July 20, 2017.

The Director of the Federal Register approved the incorporation by reference of certain publications listed in this AD as of July 20, 2017.

We must receive comments on this AD by August 21, 2017.

You may send comments by any of the following methods:

• Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.

• Mail: U.S. Department of Transportation, 1200 New Jersey Avenue SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-0001.

• Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

• Fax: 202-493-2251.

For service information identified in this AD, contact Rolls-Royce plc, Corporate Communications, P.O. Box 31, Derby, England, DE24 8BJ; phone: 011-44-1332-242424; fax: 011-44-1332-249936; email: http://www.rolls-royce.com/contact/civil_team.jsp; Internet: https://customers.rolls-royce.com/public/rollsroycecare. You may view this service information at the FAA, Engine & Propeller Directorate, 1200 District Avenue, Burlington, MA 01803. For information on the availability of this material at the FAA, call 781-238-7125. It is also available on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-0187.

Robert Green, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 1200 District Avenue, Burlington, MA 01803; phone: 781-238-7754; fax: 781-238-7199; email: robert.green@faa.gov.

This AD is a final rule that involves requirements affecting flight safety, and we did not precede it by notice and opportunity for public comment. We invite you to send any written relevant data, views, or arguments about this AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2017-0187; Directorate Identifier 2017-NE-08-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this AD. We will consider all comments received by the closing date and may amend this AD because of those comments.

We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this AD.

The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA AD 2017-0017, dated February 1, 2017 (referred to hereinafter as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:

Recently, a low speed abort (60 to 65 knots) occurred on take-off on a Trent 1000-powered Boeing 787 aeroplane. The pilot performed a commanded engine shutdown and the aeroplane safely returned to the gate. Following investigation, failure and release of the intermediate pressure compressor (IPC) rotor seal was confirmed as having caused this event. RR have confirmed that other IPC rotor seals, Part Number (P/N) KH19098, have been found with cracking at the seal head. This condition, if not detected and corrected, could lead to engine power loss, possibly resulting in reduced control of the aeroplane.

You may obtain further information by examining the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-0187.

RR has issued Alert Non-Modification Service Bulletin (NMSB) Trent 1000 72-AJ467, Revision 1, dated February 13, 2017; and NMSB Trent 1000 72-J353, Revision 1, dated November 24, 2016. The Alert NMSB describes procedures for initial and repetitive inspections of affected IPC rotor seal. The NMSB describes procedures for in-shop inspections of affected IPC rotor seals. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

This product has been approved by EASA, and is approved for operation in the United States. Pursuant to our bilateral agreement with the European Community, EASA has notified us of the unsafe condition described in the MCAI and service information referenced above. We are issuing this AD because we evaluated all information provided by EASA and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design. This AD requires initial and repetitive inspections of affected IPC rotor seal for cracks.

No domestic operators use this product. Therefore, we find that notice and opportunity for prior public comment are impracticable and that good cause exists for making this amendment effective in less than 30 days.

We estimate that this AD affects 0 engines installed on airplanes of U.S. registry.

We estimate the following costs to comply with this AD:

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this AD:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),

(3) Will not affect intrastate aviation in Alaska to the extent that it justifies making a regulatory distinction, and

(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

1. The authority citation for part 39 continues to read as follows:

2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):