AD 85-22-51

Airworthiness directive · APU Cables and Feeder Cable Insp. · Lockheed Martin L-1011-385-1, L-1011-385-1-14, L-1011-385-1-15 and 1 more

Effective
January 10, 1986
Models
L-1011-385-1, L-1011-385-1-14, L-1011-385-1-15, L-1011-385-3
Data sheet
TCDSA23WE
Registered aircraft
4 matched by model
Product
Aircraft · Large airplane
Amendment
39-5199

Unofficial copy of the text in the FAA’s Dynamic Regulatory System. The FAA’s own copy is the authoritative one. DRS record last changed May 30, 2024.

On this page

The airworthiness directive

85-22-51 LOCKHEED CALIFORNIA COMPANY: Amendment 39-5199. Applies to Lockheed Model L-1011-385 series airplanes certificated in any category.

To prevent fires which may be ignited by damaged electrical wires, accomplish the following, unless previously accomplished:

A. Within ten (10) days after the effective date of this AD, using the procedure described in Lockheed Service Bulletin 093-24-A127 dated October 29, 1985, inspect the auxiliary power unit (APU) cables and the No. 2 engine generator feeder cables located on the left side, between the second frame forward of pressure bulkhead and the pressure bulkhead, at approximately Waterline (WL) 179, for a minimum clearance of one-half inch between the cables and the closest part of the bleed air duct insulated cover.

If the clearance is less than one-half inch, before further flight, adjust the cables to provide adequate clearance in accordance with Lockheed Service Bulletin 093-24-A127, dated October 29, 1985.B. Within ten (10) days after the effective date of this AD, inspect the APU cables and No. 2 engine generator feeder cables located on left side between the second frame forward of pressure bulkhead and the pressure bulkhead at approximately WL 179, which are routed adjacent to the bleed air duct, for proper clamping and condition of insulation. If insulation damage is found, check closely for wire damage. If damage to insulation or wires is found, before further flight, repair in accordance with FAA-approved maintenance procedures.

C. Alternate means of compliance which provide an equivalent level of safety may be used when approved by the Manager, Los Angeles Aircraft Certification Office, FAA, Northwest Mountain Region.

D. Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a base in order to comply with the requirements of this AD.

All persons affected by this directive who have not already received these documentsfrom the manufacturer may obtain copies upon request to Lockheed-California Company, P.O. Box 551, Burbank, California 91520, Attention: Commercial Support Contracts, Dept. 63-11, U-33, B-1. These documents also may be examined at the FAA, Northwest Mountain Region, 17900 Pacific Highway South, Seattle, Washington, or the Los Angeles Aircraft Certification Office, 4344 Donald Douglas Drive, Long Beach, California.

This amendment becomes effective January 10, 1986, as to all persons, except those persons to whom it was made immediately effective by telegraphic AD T85-22-51, issued October 30, 1985.

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 4

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Lockheed4 aircraft

By model

Aircraft