AD 87-25-07

Airworthiness directive · Engine Support Structure · BAE Systems HS 748 Series 2A and HS 748 Series 2B

Effective
January 19, 1988
Models
HS 748 Series 2A, HS 748 Series 2B
Data sheet
TCDSA24EU
Registered aircraft
2 matched by model
Product
Aircraft · Large airplane
Amendment
39-5789

Unofficial copy of the text in the FAA’s Dynamic Regulatory System. The FAA’s own copy is the authoritative one. DRS record last changed May 30, 2024.

On this page

The airworthiness directive

87-25-07 BRITISH AEROSPACE: Amendment 39-5789. Applies to all Model H.S. 748 airplanes, certificated in any category. Compliance required as indicated, unless previously accomplished.

To prevent severe stress and damage to the engine support structure, accomplish the following:

A. Within the next 6 months after the effective date of this AD, or prior to accumulating 6,000 landings, whichever is later, and thereafter at intervals not to exceed 2,000 landings, perform a visual inspection of the engine subframe/wing attachment assemblies in accordance with paragraph 2A of British Aerospace Service Bulletin 54-29, dated October 1986. Any assembly found to exhibit excessive movement or wear must be repaired, prior to further flight, in a manner approved by the FAA.

B. No later than the next scheduled engine removal after the effective date of this AD or prior to accumulating 6,000 landings, whichever is later, and thereafter at intervals not to exceed 6,000 landings, perform a visual inspection of the engine subframe/wing attachment assemblies while trying to induce movement in accordance with paragraph 2C of British Aerospace Service Bulletin 54-29, dated October 1986. Any components found to be unserviceable must be repaired, prior to further flight, in a manner approved by the FAA.

C. Prior to the next scheduled engine removal after the effective date of this AD, or prior to accumulating 12,000 landings, whichever is later, and thereafter at intervals not to exceed 12,000 landings, perform an inspection with the taper bolt and taper split-bush removed from the engine subframe/wing attachment assemblies in accordance with paragraph 2D of British Aerospace Service Bulletin 54-29, dated October 1986. Any components found to be unserviceable must be repaired, prior to further flight, in a manner approved by the FAA.

D. An alternate means of compliance or adjustment of the compliance time, which provides an acceptable level of safety, maybe used when approved by the Manager, Standardization Branch, ANM-113, FAA, Northwest Mountain Region.

E. Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a base for the accomplishment of inspections and/or modifications required by this AD.

All persons affected by this proposal who have not already received the appropriate service documents from the manufacturer may obtain copies upon request to British Aerospace, Librarian for Service Bulletins, P.O. Box 17414 Dulles International Airport, Washington, D.C. 20041. These documents may be examined at the FAA, Northwest Mountain Region, 17900 Pacific Highway South, Seattle, Washington, or at the Seattle Aircraft Certification Office, 9010 East Marginal Way South, Seattle, Washington.

This amendment becomes effective January 19, 1988.

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 2

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • British Aerospace2 aircraft

By model

Aircraft