AD 92-06-05 R1

Airworthiness directive · Nose Landing Gear · Textron BAe.125 Series 1000B, BAe.125 Series 800A, BAe.125 Series 800A (C-29A) and 38 more

Effective
April 21, 1992
Models
BAe.125 Series 1000B, BAe.125 Series 800A, BAe.125 Series 800A (C-29A), BAe.125 Series 800A (U-125), BAe.125 Series 800B, BH.125 Series 400A and 35 more
Data sheet
TCDSA3EU
Registered aircraft
111 matched by model
Product
Aircraft · Large airplane
Amendment
39-8251
Docket
91-NM-209-AD

Unofficial copy of the text in the FAA’s Dynamic Regulatory System. The FAA’s own copy is the authoritative one. DRS record last changed January 21, 2026.

On this page

The airworthiness directive

92-06-05 R1 BRITISH AEROSPACE: Amendment 39-8251. Revises amendment 39-8185, AD 92- 06-05. Docket No. 91-NM-209-AD.

Applicability: Model DH/BH/HS/BAe 125 series airplanes, except Model BAe 125-1000A series airplanes, certificated in any category.

Compliance: Required as indicated, unless accomplished previously.

To prevent reduced structural integrity of the fuselage and subsequent decompression of the airplane, accomplish the following:

(a) Prior to the accumulation of 4,000 landings, or within 60 days after the effective date of this AD, whichever occurs later, accomplish the following in accordance with British Aerospace Service Bulletin 53-73, Revision 2, dated May 18, 1991:

(1) Perform a visual inspection of the nose landing gear (NLG) bay left and right sidewalls to detect the presence of washers or spotface under nuts.

(i) If no spotface is found, perform a visual inspection to detect damage to the web caused by nuts or washers.

(ii) Blend out any damage found, excluding cracking, prior to further flight.

(2) Perform either a dye penetrant or eddy current inspection to detect cracks on the NLG bay left and right sidewalls. If cracks are found, repair prior to further flight, in a manner approved by the Manager, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate.

(b) An alternative method of compliance or adjustment of the compliance time, which provides an acceptable level of safety, may be used when approved by the Manager, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate. The request shall be forwarded through an FAA Principal Maintenance Inspector, who may concur or comment and then send it to the Manager, Standardization Branch, ANM-113.

(c) Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate the airplane to a location where the requirements of this AD can be accomplished.

(d) The inspections shall be done in accordance with British Aerospace Service Bulletin 53- 73, Revision 2, dated May 18, 1991. This incorporation by reference was previously approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51 as of April 21, 1992 (57 FR 9170, March 17, 1992). Copies may be obtained from British Aerospace, PLC, Librarian for Service Bulletins, P.O. Box 17414, Dulles International Airport, Washington, DC. 20041-0414. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington; or at the Office of the Federal Register, 1100 L Street NW., Room 8401, Washington, DC.

(e) This amendment is effective April 21, 1992.

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 111

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • British Aerospace80 aircraft
  • Hawker Siddeley11 aircraft
  • Corporate Jets8 aircraft
  • Raytheon Corporate Jets8 aircraft
  • Raytheon3 aircraft
  • Hawker Beechcraft1 aircraft
By year built
19681993
Registered aircraft by year built: 66 aircraft
19681
19701
19711
19771
19781
19802
19811
19825
19847
19855
19862
19874
19885
19897
19906
19911
19927
19939

45 with no year recorded

By model

Aircraft

See all 111 aircraft