AD 98-10-15

Airworthiness directive · Fuel Line · Honeywell International TFE731-40R

Effective
May 19, 1998
Published
May 19, 1998 · 63 FR 27450–27452
Model
TFE731-40R
Data sheet
TCDSE1NM
Registered aircraft
336 matched by model
Product
Engine
Amendment
39-10527
Docket
98-ANE-30-AD
Issued as
Final rule; request for comments

Unofficial copy of the text in the FAA’s Dynamic Regulatory System. Only the govinfo PDF is the legal edition. DRS record last changed May 30, 2024.

On this page

Summary

This amendment adopts a new airworthiness directive (AD) that is applicable to AlliedSignal Inc. Model TFE731-40R-200G turbofan engines. This action requires replacing the fuel line between the main fuel pump and the motive flow pump with a serviceable assembly and adding a supporting bracket and clamp. This amendment is prompted by a report of a cracked fuel line between the main fuel pump and the motive flow pump causing the spraying of fuel on and around electrical components. The actions specified in this AD are intended to prevent fuel spraying on and around electrical components due to a cracked fuel line, which could result in an engine fire.

The airworthiness directive

98-10-15 AlliedSignal Inc.: Amendment 39-10527. Docket 98-ANE-30-AD. Applicability: AlliedSignal Inc. Model TFE731-40R-200G turbofan engines, equipped with a fuel line, part number (P/N) 3061191-1, between the main fuel pump and the motive flow pump. These engines are installed on but not limited to Israel Aircraft Industries LTD. (IAI) Model Astra SPX aircraft. Note 1: This airworthiness directive (AD) applies to each engine identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For engines that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it. Compliance: Required as indicated, unless accomplished previously. To prevent fuel spraying on and around electrical components due to a cracked fuel line, which could result in an engine fire, accomplish the following: (a) Within 10 hours time in service (TIS) after the effective date of this AD, replace the fuel line, P/N 3061191-1, between the main fuel pump and the motive flow pump, with a serviceable assembly, and add a supporting bracket and clamp, in accordance with the Accomplishment Instructions of AlliedSignal Inc. Alert Service Bulletin (ASB) No. TFE731-A73-5111, dated April 16, 1998. (b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Los Angeles Aircraft Certification Office. Operators shall submit their requests throughan appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Los Angeles Aircraft Certification Office. Note 2: Information concerning the existence of approved alternative methods of compliance with this airworthiness directive, if any, may be obtained from the Los Angeles Aircraft Certification Office. (c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the aircraft to a location where the requirements of this AD can be accomplished. (d) The actions required by this AD shall be done in accordance with the following AlliedSignal Inc. ASB:

Document No. Pages Date TFE731-A73-5111 1-8 April 16, 1998 Total pages: 8.

This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from AlliedSignal Aerospace Services Attn.: Data Distribution, M/S 64-3/2101-201, P.O. Box 29003, Phoenix, AZ 85038-9003; telephone (602) 365-2493, fax (602) 365-5577. Copies may be inspected at the FAA, New England Region, Office of the Regional Counsel, 12 New England Executive Park, Burlington, MA; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC. (e) This amendment becomes effective on May 19, 1998.

Rule preamble

The FAA’s background, reasoning and cost estimate, published with the AD.

Supplementary information

The Federal Aviation Administration (FAA) has received a report of a cracked fuel line between the main fuel pump and the motive flow pump causing the spraying of fuel on and around electrical components on an AlliedSignal Inc. Model TFE731-40R-200G turbofan engine. While taxiing after flight, the ground crew noted a fuel leak from the right hand engine of an Israel Aircraft Industries, LTD. (IAI) Astra SPX aircraft. The fuel line, part number (P/N) 3061191-1, between the main fuel pump and the motive flow pump, was found cracked at the weld of the elbow fitting. The right-hand engine had accumulated 8 operating hours. The investigation revealed that during manufacturing of the fuel line between the main fuel pump and the motive flow pump, inadequate weld penetration was created by an orbital weld operation. The lack of penetration was not identified by the post-weld X-ray inspection. The fracture of the fuel line was due to high cycle fatigue which initiated at the localized area of incomplete weld penetration. This condition, if not corrected, could result in fuel spraying on and around electrical components due to a cracked fuel line, which could result in an engine fire. The FAA has reviewed and approved the technical contents of AlliedSignal Inc. Alert Service Bulletin (ASB) No. TFE731-A73-5111, dated April 16, 1998, that describes procedures for replacing the fuel line between the main fuel pump and the motive flow pump with a serviceable assembly and adding a supporting bracket and clamp. Since an unsafe condition has been identified that is likely to exist or develop on other engines of the same type design, this AD is being issued to prevent fuel line cracking. This AD requires, within 10 hours time in service (TIS) after the effective date of this AD, replacing the fuel line between the main fuel pump and the motive flow pump with a serviceable assembly and adding a supporting bracket and clamp. The actions are required to be accomplished in accordance with the ASB described previously. Since a situation exists that requires the immediate adoption of this regulation, it is found that notice and opportunity for prior public comment hereon are impracticable, and that good cause exists for making this amendment effective in less than 30 days. Comments Invited Although this action is in the form of a final rule that involves requirements affecting flight safety and, thus, was not preceded by notice and an opportunity for public comment, comments are invited on this rule. Interested persons are invited to comment on this rule by submitting such written data, views, or arguments as they may desire. Communications should identify the Rules Docket number and be submitted in triplicate to the address specified under the caption "ADDRESSES." All communications received on or before the closing date for comments will be considered, and this rule may be amended in light of the comments received.Factual information that supports the commenter's ideas and suggestions is extremely helpful in evaluating the effectiveness of the AD action and determining whether additional rulemaking action would be needed. Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the rule that might suggest a need to modify the rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report that summarizes each FAA-public contact concerned with the substance of this AD will be filed in the Rules Docket. Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this notice must submit a self-addressed, stamped postcard on which the following statement is made: "Comments to Docket Number 98-ANE-30-AD." The postcard will be date stamped and returned to the commenter. The regulations adopted herein will not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment. The FAA has determined that this regulation is an emergency regulation that must be issued immediately to correct an unsafe condition in aircraft, and is not a "significant regulatory action" under Executive Order 12866. It has been determined further that this action involves an emergency regulation under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979). If it is determined that this emergency regulation otherwise would be significant under DOT Regulatory Policies and Procedures, a final regulatory evaluation will be prepared and placed in the Rules Docket. A copy of it, if filed, may be obtained from the Rules Docket at the location provided under the caption "ADDRESSES." List of Subjects in 14 CFR Part 39 Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety. Adoption of the Amendment Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows: PART 39 - AIRWORTHINESS DIRECTIVES 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 39.13 [Amended] 2. Section 39.13 is amended by adding the following new airworthiness directive:

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 336

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Raytheon99 aircraft
  • Learjet87 aircraft
  • Dassault64 aircraft
  • Israel Aircraft Industries35 aircraft
  • Dassault-Breguet16 aircraft
  • Other makers1235 aircraft
By year built
19692011
Registered aircraft by year built: 315 aircraft
19691
19741
19761
19773
19791
19806
19814
19826
19834
19843
19851
19862
19871
19894
19902
19912
19924
19937
19941
19952
19965
19975
19987
19999
200021
200156
200248
200320
200447
200526
200610
20073
20081
20111

21 with no year recorded

By model

Aircraft

See all 336 aircraft