ANC07LA022

NTSB accident investigation · Hughes 369D · Gustavus, AK · March 3, 2007

Accident · No injuriesLimited investigationFinal report
Date
March 3, 2007, 16:10 local (20:10 UTC)
Place
Gustavus, AK
Injuries
2 uninjured
Damage
Substantial damage
Phase of flight
Maneuvering
Aircraft
N5134VHughes 369D
Weather
Visual (VMC) · Day
Status
Completed · report June 27, 2007
Report
Approved by Office Director
NTSB office
Alaska Regional Office
Parties
Juneau FSDO-05
FAA report
20070303002289A
Case key
65367

From the NTSB’s public API. By law, NTSB reports can’t be used as evidence in lawsuits over the accident.

On this page

Probable cause

The inadequate clearance from a tranquilized moose while hovering in ground effect, and the operator's inadequate procedures for such operations, which resulted in an in-flight collision with the moose. Factors associated with the accident were the moose, a sheared tail rotor drive shaft, and the resultant lack of tail rotor anti-torque control.

Sequence of events

NTSB’s coding before 2008: each occurrence and phase of flight, and the causes and factors under it. The codes are defined in NTSB’s coding manual.

In flight collision with objectHover - in ground effect
Object - animal(s)Factor
Procedure inadequateCompany/operator managementCause
Clearance - inadequateCause
Airframe/component/system failure/malfunctionHover - in ground effect
Rotor drive system,tail rotor drive shaft - shearedFactor
Tail rotor/anti-torque control - not availableFactor
Forced landingEmergency descent/landing
Terrain condition - snow covered

Analysis

The helicopter was being operated as a visual flight rules on-demand passenger flight under Title 14, CFR Part 135. The purpose of the flight was to tranquilize moose for capture and collaring. The company's chief pilot said a moose was shot with a tranquilizer dart from the helicopter, and that the helicopter was used to block the moose from moving into a hazardous area. The pilot of an airplane orbiting above said the moose charged the helicopter, and that as the helicopter attempted to evade the moose, the moose reared, or jumped, contacting the helicopter's tail rotor. The helicopter pilot reported a loss of directional control, and made a hovering autorotation to the ground. The flex coupling between the drive shaft and the tail rotor gearbox failed, and the spinning drive shaft cut the tail boom and separated the tail from the rest of the airframe. According to the chief pilot, the company's practice had been for the helicopter to hover/maneuver about 10 feet above the ground, and no closer to the darted animal than 10 feet horizontally. He said the pilot and scientist aboard felt the distances were appropriate. He said this was the first incident of extreme, erratic, behavior on the part of a darted animal, and that due to this incident, the company has revised its procedure, and now requires the pilot to maintain 30 feet of altitude above the ground and 30 feet horizontally from a darted animal.

Factual narrative

On March 3, 2007, about 1610 Alaska standard time, a Hughes 369D helicopter, N5134V, sustained substantial damage while hovering in ground-effect, when its tail rotor was struck by a moose during a game management operation, about 1 mile southwest of the Gustavus Airport, Gustavus, Alaska. The helicopter was being operated by Temsco Helicopters Inc., Ketchikan, Alaska, as a visual flight rules (VFR) on-demand passenger flight under Title 14, CFR Part 135, when the accident occurred. The commercial certificated pilot and sole passenger were not injured. Visual meteorological conditions prevailed, and company flight following procedures were in effect.

During a telephone conversation with the National Transportation Safety Board (NTSB) investigator-in-charge (IIC) on March 5, the chief pilot for the operator said the helicopter was involved in a moose tagging operation for the Alaska State Department of Fish and Game. He said the moose was shot with a tranquilizer dart from the helicopter, and that the helicopter is used to block the moose's path to prevent them from running into water and drowning, or running into an area where the tranquilized animals cannot be handled safely. He said the helicopter was hovering, waiting for the animal to "go down." The chief pilot said that the pilot of an airplane was orbiting above, and saw the moose charge the helicopter. According to the chief pilot, the airplane pilot stated that as the helicopter attempted to evade the moose, the moose reared, or jumped, contacting the helicopter's tail rotor. The airplane pilot said that the helicopter made three complete 360 degree rotations before it landed.

The helicopter pilot reported that he was not aware that the moose contacted the tail rotor. He indicated he had a loss of directional control, and said that he made a hovering autorotation to the ground. According to the chief pilot, the flex coupling between the drive shaft and the tail rotor gearbox failed. He said the spinning drive shaft cut through the tail boom adjacent to the gearbox, and separated the tail from the rest of the airframe.

On April 2, the chief pilot told the IIC that their past practice had been for the helicopter to hover/maneuver about 10 feet above the ground, and no closer to the darted animal than 10 feet horizontally. He said this past practice had served them well, and the pilot and scientist aboard the helicopter felt the distances were appropriate. He said this was the first incidence of extreme, erratic, behavior on the part of a darted animal. In a written statement to the NTSB dated March 14, the chief pilot reported that due to this incident, the company had revised its procedure, and now requires the pilot to maintain 30 feet of altitude above the ground, and 30 feet horizontally from a darted animal.

Aircraft

Registration
N5134V
Reported as
Hughes 369D
Category
Helicopter
Serial number
1103D
Airframe hours
9,041
Engine
Allison 250C20B, 420 horsepower, turbo shaft
Damage
Substantial damage
Flight
Part 135
Operator
Temsco Helicopters Inc, doing business as Temsco Helicopters
Registered owner
Temsco Helicopter Inc.
Airworthiness certificate
Standard, Normal
Last inspection
100 hour · October 1, 2006
Departed
PAGS · Gustavus, AK
Flight plan
Company VFR

Matched to the registry by N-number and the event date; the registry’s history has gaps, so older matches can be wrong. Compare the reported make and model.

Flight crew

As NTSB recorded them. NTSB leaves out names.

Role
Pilot
Age
26
Injuries
None
Certificate
Commercial
Instrument ratings
Helicopter
Medical
Class 2, Without waivers/limitations
Last flight review
March 1, 2006
Seat
Left
Flight hours
2,700 total · 415 in this make and model · 2,600 as pilot in command · 44 in the last 90 days · 23 in the last 30 days · 4 in the last 24 hours

Weather

Conditions
Visual (VMC) · Day
Visibility
10 statute miles
Lowest ceiling
None
Temperature
18 °F, dew point 3 °F

FAA reports on this event · 1

The FAA’s own accident and incident reports, matched to the aircraft by N-number and date.