- Date
- April 28, 2019, 12:58 local (17:58 UTC)
- Place
- Quanah, TX
- Injuries
- 1 uninjured
- Damage
- Substantial damage
- Phase of flight
- Maneuvering
- Aircraft
- N602AMAir Tractor AT 602
- Defining event
- Maneuvering-low-alt flying: Low altitude operation/event
- Weather
- Visual (VMC) · Day
- Status
- Completed
- Report
- Approved by Office Director
- Investigation class
- Class 3
- NTSB office
- Central Region
- Parties
- Federal Aviation Administration
- FAA report
- 20190428004459A
- Case key
- 99338
From the NTSB’s public API. By law, NTSB reports can’t be used as evidence in lawsuits over the accident.
On this page
Probable cause
The pilot's failure to maintain clearance from the power line during a low altitude aerial application maneuver.
Findings · 2
NTSB’s coded findings. Those marked are part of the probable cause; the rest are factors or other findings. Under each, the cases with the same finding.
Sequence of events
The events NTSB coded, in order, by phase of flight. The defining event is the one that best describes the accident. Under each, the cases with the same event anywhere in their sequence.
Analysis
The pilot was conducting aerial application passes parallel to a transmission power line. During the final trim pass, the pilot flew out of the field and over the power line. As he was passing over the power line, the propeller blades struck a wire that he did not see, and the engine lost power. The pilot indicated that he conducted a controlled "crash landing" about 1.5 miles away from the power line strike during which the airplane sustained substantial damage to the fuselage. The pilot further reported that "there was no malfunction prior to hitting the powerline."
Factual narrative
On April 28, 2019, about 1258 central daylight time, an Air Tractor Inc. AT-602 airplane, N602AM, impacted a powerline and subsequently impacted terrain near Quanah, Texas. The commercial pilot reported no injuries. The airplane sustained substantial fuselage damage during the impact with terrain. The airplane was registered to and operated by Buffalo Ridge Airspray LLC as a Title 14 Code of Federal Regulations Part 137 aerial application flight. Day visual meteorological conditions prevailed in the area about the time of the accident, and the flight was not operated on a flight plan. The local flight originated from the Quanah Municipal Airport, near Quanah, Texas, about 1200. The pilot reported that the airplane was loaded up to spray 200 acres north west of Quanah, Texas, where the wind was from the east northeast about 7 to 9 mph. However, local wind at a nearby airport was 130° at 5 kts. The aerial application passes were conducted east to west, paralleling a transmission powerline. The flight was uneventful for the entire load. Before departing the field location, the pilot performed two "clean up" passes along the west boundary of the field flying from the south to the north. The first north bound heading trim pass was successful. The pilot flew the airplane to the south end of the field to initiate the second and final trim pass. As the pilot flew out of the field over the powerline, he thought the airplane had cleared the powerline. He subsequently thought the propeller blades struck the wire that he did not see and the engine lost power. The pilot conducted the "proper emergency steps such as fuel, feather the prop, and trim the aircraft." He then performed a controlled "crash landing," next to the wheat field he was trying to land in, about 1.5 miles away from the powerline strike. The pilot further reported that "there was no malfunction prior to hitting the powerline." The pilot's safety recommendation stated, "Avoid the powerline entirely by leaving off the "clean up" passes along the west boundary of my field. I could have waited for a south wind to help get my spray under the wire and around the northwest corner of the application area, instead of making the extra "clean up" passes towards the wire."
Aircraft
- Registration
- N602AM
- Reported as
- Air Tractor AT 602 (No Series)
- Category
- Airplane
- Serial number
- 602-0408
- Built
- 1997
- Airframe hours
- 9,582
- Engine
- Pratt & Whitney PT6A-60AG, 1,050 horsepower, turbo prop
- Damage
- Substantial damage
- Flight
- Aerial application · Part 137
- Operator
- Buffalo Ridge Airspray Llc
- Registered owner
- Buffalo Ridge Airspray Llc
- Airworthiness certificate
- Special, Restricted (Special)
- Last inspection
- December 15, 2018
- Departed
- F01 · Quanah, TX
- Destination
- F01 · Quanah, TX
- Equipment
- Stall warning system, Angle of attack indicator
Matched to the registry by N-number and the event date; the registry’s history has gaps, so older matches can be wrong. Compare the reported make and model.
Flight crew
As NTSB recorded them. NTSB leaves out names.
- Role
- Pilot
- Age
- 25
- Injuries
- None
- Certificate
- Commercial
- Airplane ratings
- Single-engine land
- Medical
- Class 2, Without waivers/limitations
- Last flight review
- August 28, 2018
- Seat
- Single
- Flight hours
- 1,306 total · 23 in this make and model · 1,262 as pilot in command · 50 in the last 90 days · 35 in the last 30 days · 8 in the last 24 hours
Weather
- Conditions
- Visual (VMC) · Day
- Wind
- 130° at 5 knots
- Visibility
- 10 statute miles
- Temperature
- 66 °F, dew point 57 °F
- Altimeter
- 29.88 inHg
- Observed at
- KCDS, 27 nm away
Docket · 1
The files NTSB released with the investigation on June 12, 2019, on NTSB’s docket system: statements, records, photos and specialists’ reports. 2.9 MB in all.
FAA reports on this event · 1
The FAA’s own accident and incident reports, matched to the aircraft by N-number and date.