LAX96FA290

The instructor pilot (CFI) reduced power to simulate an emergency landing and instructed the student to simulate a forced landing approach to a dirt road. The CFI said that he allowed the student to get too low, and when he assumed the controls, the airplane struck the ground and bounced. Ground witnesses said that when the airplane struck the ground, the engine power increased, and the airplane entered into a high angle of attack and a steep right banking attitude. The airplane struck the top of a tree about 1/4 mile from the initial touchdown point, then it bounced twice and collided with a concrete barrier. The airplane flipped over the barrier and erupted into flames. Wreckage examination disclosed no evidence of any preimpact malfunctions or failures.

History of Flight

On July 25, 1996, at 0906 hours Pacific daylight time, a Bellanca 8KCAB, N57438, collided with a tree and crashed in the rear yard of Canyon Construction Company, Mound House, Nevada. The pilots were conducting a local visual flight rules instructional flight. The airplane, registered to the pilot's son, was destroyed by the impact forces and resulting postimpact fire. The certificated airline transport pilot/flight instructor sustained serious injuries and the dual student sustained fatal injuries. Visual meteorological conditions prevailed. The flight originated at Carson City Airport, Carson City, Nevada, at 0850.

The airport refueler reported that he fueled the airplane with 16 gallons of fuel (8 gallons in each wing tank) before the flight departed. The refueler said that both pilots were conducting an extensive preflight inspection while he was fueling the airplane. He also said that both tanks were less than full after he completed the fueling.

Safety Board investigators interviewed several ground witnesses. They reported they were standing in their company's yard (located about 3/4 mile south/southeast of the crash site) and observed the airplane fly over their building in a westerly direction. The airplane was between 30 to 40 feet above the building and the engine was not producing power. The airplane turned to the north and lined up with a dirt road and then suddenly nosed down and struck the road. The engine power suddenly increased and the airplane entered into a 30-degree nose-up attitude and banked sharply (about 90 degrees) to the right. The engine sounded normal and there was no sputtering or cutting out sounds. The airplane disappeared from their view momentarily and then they saw the airplane's tail raise and the airplane flipped over and burst into flames.

Another ground witness reported that he was driving a skip loader about 1 mile west of the crash site when he saw a dust cloud. He then observed the airplane bounce twice and then erupt in a ball of flames. The witnesses did not hear any engine sounds and said that he was wearing ear plugs.

The pilot reported in a telephone interview conducted on July 26, 1996, at 1015, that he was giving his daughter a flight lesson. He said that before the accident they were performing a simulated emergency forced landing to a dirt road. He said that he allowed his daughter to get "too low" and that he attempted to recover from the maneuver, but without success. The airplane struck the ground and he immediately applied power. The engine responded normally, but the airplane's rate of climb was insufficient to clear the tree. He also said that the airplane did not experience any preimpact malfunctions or failures.

Crew Information

The pilot-in-command (PIC) holds an airline transport pilot certificate with an airplane multiengine land and several large airplane type ratings; the certificate is endorsed for commercial privileges in airplane single engine land and sea ratings. He also holds a certified flight instructor certificate with ratings for airplane single engine, multiengine, and instruments, and a second-class medical certificate. The medical certificate was issued on July 10, 1996, and contains a "must wear hearing aid" limitation endorsement.

Safety Board investigators did not obtain the pilot's flight hours logbook. The flight hours reflected on page 3 of this report were obtained from the FAA. The pilot noted on his last medical application form that he had accrued 24,900 hours. The PIC's son, the owner of the airplane, said that his father told him that he renewed his flight instructor's certificate about 2 weeks before the accident. The FAA records, however, do not show that the PIC received a new flight instructor's certificate. A renewed certificate is not reflected in the records for about 120 days.

The dual student held a student pilot/third-class medical certificate. The student pilot received the certificate on July 10, 1996. The medical certificate contains a "must wear corrective lenses" limitation endorsement.

Safety Board investigators did not obtain the student pilot's logbook. The dual student noted on her third-class medical application form that she had accrued 10 flight hours. A Lyon County Sheriff's Deputy told Safety Board investigators that airport personnel told him that the student pilot soloed the airplane about a week before the accident. The pilot's son confirmed this statement.

Aircraft Information

The airplane owner said that the airplane's maintenance logbooks were in the airplane. Safety Board investigators found logbook remnants at the accident site. According to the owner, the airplane received its last annual inspection sometime in August 1995. The inspection was accomplished by Scottsdale Flyer's, Scottsdale, Arizona.

Scottsdale Flyer's owner provided the Safety Board with all of the maintenance records he had in connection with the maintenance the company performed on the airplane. The records show that the last annual/100-hour inspection was performed on August 22, 1995. At the time of the inspection, the engine and the airframe accrued 1,076.3 hours.

The accident site elevation is about 5,000 feet mean sea level. Safety Board investigators calculated the density altitude to be about 7,500 feet.

According to a New American Champion Company representative, the accident airplane make and model average empty weight is about 1,150 pounds. The maximum allowable gross weight is 1,800 pounds. Safety Board investigators estimated the takeoff weight to be about 1,686 pounds. The pilot and student weights were obtained from their FAA medical records and the fuel quantity was estimated at 20 gallons (1/2 full).

Meteorological Information

There is no surface weather reporting facility at the accident site. The weather data reflected on page 3 of this report were obtained from the pilot. According to the ground witnesses, the skies were clear with unrestricted visibility, the surface winds were from the west at 5 knots, and the surface temperature was about 75 degrees Fahrenheit.

Fire

Personnel from the Canyon Construction Company extinguished the fire before the Lyon County Fire Department personnel arrived.

Wreckage and Impact Information

The airplane came to rest, inverted, in the rear (western section) of a construction yard. The fuselage was found resting on its right side against a "skimmer" (a lean-to type shed). The ground roll path area is level, but the southern end slopes downward about 10 degrees. The northern end of the ground path is separated from the rear of the construction yard with several concrete barrier sections weighing about 2 tons each. The main wreckage area is about 4 feet lower than the airplane's ground path area.

Safety Board investigators found the forward section of the right main wheel fairing next to the dirt road. The airplane's propeller initially struck a pinon tree about 528 feet south/southwest of the main wreckage site. Scattered tree branches were found between 20 to 25 feet north of the tree. The ground scars and a witness observation show that after striking the tree, the airplane bounced twice on the ground and then collided with a concrete barrier section. A concrete barrier section moved about 2 feet and contained the airplane's right wheel imprint on its southern facing side. After colliding with the barrier, the airplane flipped over and came to rest in the construction yard.

Both landing gear wheel pants were found along the airplane's ground path near their associated wheel ground imprints. Both main landing gears were found next to the southern side of the concrete barriers. Examination of the landing gears attach bolts fractured surfaces displayed characteristics of a tensile overload separation.

The entire airplane was incinerated by the postcrash