MIA96LA172

NTSB accident investigation · Charles Raymond Glasair 2SFT · Apalachicola, FL · June 30, 1996

Accident · No injuriesLimited investigationFinal report
Date
June 30, 1996, 10:45 local (14:45 UTC)
Place
Apalachicola, FL
Injuries
2 uninjured
Damage
Substantial damage
Phase of flight
Approach
Aircraft
N16CDCharles Raymond Glasair 2SFT
Weather
Visual (VMC) · Day
Status
Completed · report May 23, 1997
Report
Approved by Office Director
FAA report
19960630015509A
Case key
38040

From the NTSB’s public API. By law, NTSB reports can’t be used as evidence in lawsuits over the accident.

On this page

Probable cause

Inadequate application of throttle input and up elevator input by the pilot-in-command. Contributing to the accident was the in-flight encounter with a downdraft and inadequate design of the airplane by the kit manufacturer.

Sequence of events

NTSB’s coding before 2008: each occurrence and phase of flight, and the causes and factors under it. The codes are defined in NTSB’s coding manual.

UndershootApproach - vfr pattern - final approach
Weather condition - downdraftFactor
Throttle/power control - improper use ofPilot in commandCause
Elevator - inadequatePilot in commandCause
Nose gear collapsedLanding - flare/touchdown
Landing gear,nose gear attach point - overload
Acft/equip,inadequate designKit manufacturerFactor

Analysis

The pilot stated that she entered the traffic pattern to land on runway 14 with a crosswind from the left of about 10 knots. While on short final approach with partial flaps extended and an indicated airspeed of 90 miles-per-hour, the flight encountered a downdraft. She added only partial power and the airplane landed short of the runway separating the nose landing gear. She further stated that the engine responded when she added power and she only applied a slight pitch up correction when adding power. Examination of the airplane revealed that the 4 AN3-14A bolts that secure the nose gear trunnion attach plate to the nose gear support rib were bent and the threads were stripped. The original prototype engine/propeller combination was approximately 100 pounds lighter than the installed engine/propeller combination but with the same size and number of bolts used to secure the nose gear trunnion attach plate.

Factual narrative

On June 30, 1996, about 1045 eastern daylight time, a homebuilt Glasair 2SFT, N16CD, registered to a private individual, was substantially damaged on landing at the St. George Island Airport, Apalachicola, Florida. Visual meteorological conditions prevailed at the time and no flight plan was filed for the 14 CFR Part 91 personal flight. The private-rated pilot and pilot-rated passenger were not injured. The flight originated about 0915 from the Cartersville Airport, Cartersville, Georgia.

The pilot stated that she entered the traffic pattern to land on runway 14 with a crosswind from the left about 10 knots. While on short final approach with partial flaps extended and an indicated airspeed of 90 miles per hour, the flight encountered a downdraft. She added partial power and the airplane landed short of the runway on grass then rolled onto the runway separating the nose landing gear. She further stated that the engine responded when she added power and she only applied a slight pitch up correction when adding power.

Examination of the airplane revealed that the four each AN3-14A bolts that secure the nose gear trunnion attach plate to the nose gear support rib were bent and the threads were stripped.

According to a representative of the designer of the prototype airplane, a Glasair 1 FT, the original engine installed was a Lycoming O-320E2D model with a wood fixed pitch propeller. Additionally, the original design only indicated that four each AN3-14A bolts to be installed to secure the nose gear trunnion attach plate. The builder of the airplane installed a model IO-360-A3B6 engine with a constant speed propeller and he stated he followed the plans pertaining to the nose gear trunnion attach plate installation.

The installed engine/propeller combination weighed about 100 pounds greater than the prototype installed engine/propeller combination.

Aircraft

Registration
N16CD
Reported as
Charles Raymond Glasair 2SFT (GLASAIR 2S)
Category
Airplane, amateur-built
Serial number
2043
Airframe hours
426
Engine
Lycoming IO-360-A3B6, 200 horsepower, reciprocating
Damage
Substantial damage
Flight
Personal · Part 91
Registered owner
Charles P. Raymond
Airworthiness certificate
Special, Experimental (Special)
Last inspection
Annual · September 25, 1995 · 41 hours before
Departed
VPC · Cartersville, GA
Destination
F47
Airport
F47 · St George Island, runway 14, 3,700 × 65 ft, asphalt

Matched to the registry by N-number and the event date; the registry’s history has gaps, so older matches can be wrong. Compare the reported make and model.

Flight crew

As NTSB recorded them. NTSB leaves out names.

Role
Pilot
Age
40
Certificate
Private
Airplane ratings
Single-engine land
Medical
Class 3, Valid Medical--w/ waivers/lim
Seat
Left
Flight hours
900 total · 350 in this make and model · 748 as pilot in command · 13 in the last 90 days · 2 in the last 30 days · 2 in the last 24 hours

Weather

Conditions
Visual (VMC) · Day
Wind
70° at 8 knots
Visibility
7 statute miles
Lowest ceiling
None
Temperature
84 °F, dew point 70 °F
Altimeter
30.00 inHg
Observed at
PAM, 42 nm away

FAA reports on this event · 1

The FAA’s own accident and incident reports, matched to the aircraft by N-number and date.