NYC93FA102

The pilot was conducting a banner tow pickup. Another tow pilot who was performing ground duties stated that the approach and climb seemed normal until about 50 to 100 feet, when the airplane nosed over for a few seconds and then started to climb again. The witness said the banner pickup was normal, but then the tow airplane 'started to descend and wobble the wings.' The banner was released and the aircraft nose 'pitched up.' The witness said the airplane then appeared to stall and did a 180 degree turn to the right and hit the ground in a steep attitude. The investigation did not disclose evidence of mechanical malfunction. The pilot completed banner towing training about a month earlier, and he had since acquired about 33 hours total time of banner towing experience.

History of flight

On Monday, June 7, 1993, at 1230 eastern daylight time, a Cessna 150E, N3981U, operated by Sky Banners, Inc., and piloted by James E. Haas, Jr., was destroyed after impact with the ground while maneuvering near the Warrington Airport, Selbyville, Delaware. The pilot was fatally injured. Visual meteorological conditions prevailed, and no flight plan was filed. The flight was being conducted under 14 CFR 91.

The pilot departed the private airstrip at approximately 1145. He picked up a banner and proceeded to conduct a towing sortie along the beach. He returned to the airport, dropped the banner and maneuvered for another banner pickup. He lined up with the banner pickup poles on an approximate heading of 360 and started his approach for pickup.

Mr. Bryan Payne, another banner pilot, was performing ground duties and observed N3981U perform the pickup maneuver. Mr. Payne said, "The plane made a normal approach to the pickup. Full power was applied just before pickup poles. At that time he rotated [and] the engine sputtered. The pickup was made and the plane nosed over and then went back to a normal nose high attitude...The banner lifted off the ground with no problems. After the banner was in the air the plane started to descend and wobble the wings. The banner was then released and the aircraft went nose high. The left wing raised sharply while descending to the right. The aircraft did approximately a 180 degree turn, nose down and one wing high...it hit the ground with a nose low attitude."

In a telephone interview, Mr. Payne said, "The engine sputter was brief and it sounded normal during the climb, and the engine sounded like it had full power when it hit the ground." He also said that about 50 to 100 feet above the ground, the airplane's nose was lowered for a few seconds to a near level flight attitude, and then the climb was resumed.

Ms. Laura Demango was travelling in her automobile in an easterly direction, when she observed "the airplane to her right and the banner dropping to the ground. The airplane was flying slow and the wings were wobbling...then it nosed over towards the ground and disappeared behind a house." She then said she saw flames where the airplane impacted the ground.

The accident occurred during the hours of daylight, at about 38 degrees, 30 minutes North, 75 degrees, 10 minutes West.

Personnel information

Mr. Haas held a Federal Aviation Administration Commercial Pilot Certificate, with single and multiengine, land airplane and instrument ratings. He also was a Certified Flight Instructor. He held a Second Class Medical Certificate issued April 24, 1992.

He was hired by the banner towing company on April 24, 1993. At that time, Mr. Haas indicated his total flight time as 231 hours. His pilot log book showed that he had not flown from September 14, 1992 until April 13, 1993, a period of approximately 7 months. Additionally, in the year prior to the accident, Mr. Haas had flown a total of 36.8 hours. He had 33.6 hours of banner towing experience.

Company training records showed that Mr. Haas received 2.5 hours of ground school and 8 hours of flight training in the banner towing operation. This training was completed on May 7, 1993.

Aircraft information

The airplane was originally equipped with a Continental O-200-A engine, which produced 100 horsepower. It had been modified with the installation of a Lycoming O-320-E2D engine, which produced 150 horsepower.

Additionally, an STC (Supplemental Type Certificate) was accomplished on N3981U, which involved the installation of STOL (Short Takeoff & Landing) devices, such as leading edge cuffs, stall fences, aileron seals, and wing tips.

The airplane was also modified to accommodate the banner tow and release mechanisms.

FAA Forms 337, Major Repair And Alteration, were submitted for these modifications.

Wreckage

An on site examination of the airplane wreckage was conducted on June 8, 1993. The results of this examination revealed that the airplane came to rest on a heading of approximately 218 degrees in a corn field about 300 feet north of the Warrington Airport. The ground tracks were about 6 feet in length. The landing gear had collapsed, and the airplane was upright on the fuselage. A post impact fire consumed the cockpit area, including the instrument panel. No documentation of instrument or switch positions was possible. There was crushing of the wing leading edges, with a crush angle of approximately 45 degrees.

All control surfaces were accounted for, and flight control continuity was established. The wing flaps were extended to approximately the 10 degree position.

One propeller blade had no impact damage, and the other blade was underneath the wreckage and was bent backwards about 45 degrees.

Examination of the engine revealed drive train continuity from the propeller to the accessory section, including movement of the valves for each cylinder and the fuel pump plunger. Compression was obtained on all cylinders. The engine accessory section incurred post impact fire damage, including both magnetos and the carburetor, which had a metal float.

The wing fuel tank caps were not on the airplane, and could not be located by Safety Board Investigators. On June 15, 1993, Mr. Steve Hudson, of the Selbyville Fire and Rescue Department, stated that his fire crew had removed the fuel caps while fighting the fire, and had thrown the caps into the corn field. Water was then sprayed into the fuel tanks.

Medical and pathological information

An autopsy was performed on the pilot by Dr. Judith G. Tobin, Medical Examiner for the State of Delaware, on June 8, 1993. The results of this autopsy determined the cause of death as "...blunt force injury."

Toxicological tests were conducted by Dr. A. DasGupta, of the Forensic Sciences Laboratory, Office of the Chief Medical Examiner, State of Delaware, on August 6, 1993. The results of these tests were negative for alcohol and drugs.

Additional information

The following description of the banner pickup maneuver was extracted from the Sky Banner Flight Operations Manual. "The hook rope is that part of the towing assembly which is used to literally "snatch the banner from the ground" and is attached directly to the tow hitch by the pilot before each banner pickup. The hook rope is comprised of a 25 foot rope with a steel release ring at one end and a three pronged grapple hook at the other end. The release ring is used to attach the hook rope to the tow hitch, while the grapple hook is used to grasp the banner tow line during the banner pickup. The hook rope is attached to the aircraft by locking the release ring onto the release latch of the tow hitch, extending the remaining length of the hook rope forward along the left side of the fuselage and attaching the grapple hook onto the left wing strut. The grapple hook is secured by placing one of the hook prongs through a hole in a hook restraining strip located on the trailing edge of the strut just outside of the pilot's window."

After the airplane is airborne, the grapple hook is removed from the restraining strip by the pilot. He then throws it away from the airplane, so that it drops below and to the rear of the airplane in preparation for the pickup of the banner.

The manual continues: "The pickup poles are part of the banner launching assembly and are used to support and position the banner tow line on the ground for aerial pickup. The pickup poles are approximately 5 feet tall....The launch assembly is placed downwind of the banner and the tow line is then stretched across the two poles creating a target zone of approximately 30 feet square....The banner tow line is that part of the towing assembly which is snatched from the gro