What was found
ENG 2 REV THRUST STICKY ON LANDING. PERFORM THE BITE TEST ON 2 ENGINE REV THE EAU FOUND ONLY ONE FAULT T/R DELOY FAULT DID THE NORMAL OPS TEST SYSTEM WORK UNTIL NOTICE AFTER YOU DELOYED THE HANDLE TO FULL DELOY THE T/R DOES NOT DELOY AND YOU GET THE REV LIGHT BUT WHEN YOU GO BACK A FEW INCHES SHORT OF FULL DELOY T/R DELOYED AND STOWED WITHOUT A PROBLEM SUSPECT THE SWITCHPACK SWITCH IS BAD I NEED MORE TROUBLESHOOTING REF AMM 78-31-00-700-801-F00 AND FIM 78-34 TASK 810 . PERFORM SYNC LOCK OPERATION TEST AND THE TEST PASS REF AMM 78-31-00-700-803-F00. CYCLED ENG 2 T/R. FIRST CYCLE IT DEPLOYED APPROX 3-5 INCHES THEN STOWED IMMEDIATELY W/O MOVING LEVER TO STOW. EVERY CYCLE AFTER T/R FULLY DEPLOYED AND STOWED CORRECTLY. PERFORMED EAU BITE, PICTURES ATTACHED. REF FIM 78-32 TASK 806 FAULT ISOLATION, PERFORMED SPRING FREE ANGLE CHECK. SPRING IS OUT OF LIMITS. GAINED ACCESS TO CONTROL SWITCH IN ENG 2 THRUST LEVER REF AMM 78-34-04. SUSPECT SWITCH WAS INSTALLED OR WIRED BACKWARDS. ACTUATOR BUTTON WAS AFT, AMM/AIPC SHOWS ACTUATOR BUTTON FWD. WIRING COMPLETED INSTALL OF ENG 2 TR CONTROL SWITCH REF AMM 78-34-04 THROUGH END OF TASK. OPS CHECK GOOD NO FAULTS NOTED AT THIS TIME. OPERATED ENG 2 TR WITH ENGINE RUNNING NO FAULTS NOTED REF LP 5723511 FOR TRA FLUCTUATIONS.