Copy · MSB1121-144 · 4 pages

© Grob. Filed by the FAA in regulations.gov docket FAA-2014-0848; AD 2014-26-04 incorporates this document by reference. Not covered by OpenAirDocs’ CC0 dedication.

TextOCR

This text is OCR from a scan. OCR can misread letters and numbers.

Query with SQL
duckdb -csv -c "SELECT p.page, p.text_source, p.text, f.rights_holder, f.license
  FROM 'https://openairdocs.org/data/latest/service_document_file_page.parquet' p JOIN 'https://openairdocs.org/data/latest/service_document_file.parquet' f USING (file_sha256)
  WHERE p.file_sha256 = 'b4f76f52e763b4f741d641b89afaaed171421a21a80bc124d9add840818dcc01'
  ORDER BY p.page"

Prints the whole list as CSV. It reads the release’s Parquet files over HTTPS, so there’s nothing to download first. Install DuckDB to run it.

Page 1OCROpen in PDF

MSB1121-144 Page 1 of 4 I GROB 14 July 2014 AIRCRAFT Replaces Issue:

SERVICE BULLETIN NO. MSB1121-144 I. TECHNICAL DETAILS

1.1 Category:

Mandatory Note: GROB issues Service Bulletins of category Mandatory (MSBs), if the information or instructions have a safety intent either related to design or conformity and to publish revisions of manuals (AFM, AMM, IPC). However, according to Article 20

(1) of Regulation (EC) No. 216/2008, only EASA may issue mandatory information, in the form of an Airworthiness Directive (AD), in order to react to a given safety problem. Service Bulletins classified Mandatory issued by GROB's design organisation do not have a legally mandatory character equivalent to an AD, cannot have enforcement implications and, therefore, serve as information or instruction by GROB only. This also applies to cases where a Service Bulletin is published in anticipation of an AD.

Note: This service bulletin is issued in anticipation of an AD. Issue of an AD will not necessarily lead to revision of this service bulletin.

1.2 Airplanes affected:

G 120A all S/N G 120A-I all S/N

1.3 Time of Compliance:

Part A: Before next IFR or VFR Night flight, or within next 50FH, whichever comes first.

1.4 Subject:

ATA-Code: 80-00 Starting Inspection of starter solenoid

1.5 Reason:

Grob received a report about a total loss of electrical power in IMC on a G 115E aircraft. Root cause was found to be a defect starter solenoid. The starter solenoid had an internal defect causing a short circuit. The defect cannot be detected by visual inspection. The installation is similar to the installation on G120 aircraft.

This Service Bulletin is intended to prevent an unsafe condition. The configuration of the aircraft is not affected by this Service Bulletin.

1.6 Concurrent documents:

Corresponding AMM

1.7 Approval Note:

The technical content of this document is approved under the authority of EASA Design Organization Approval No. EASA.21J.030.

1121-144 MSB, Inspection of starter solenoid G 120A, A-I Grob Aircraft AG, Lettenbachstrasse 9, D-86874 Tussenhausen-Mattsies

Page 2OCROpen in PDF

MSB1121-144 Page 2 of 4 I GROB 14 July 2014 Replaces Issue: AIRCRAFT

1.8 Accomplishment/ Instructions Part A One-time Inspection Disconnect the aircraft battery, refer to AMM Chapter 24-31.

Remove the Engine Cowlings, refer to AMM Chapter 71-10.

Visually inspect the starter. Make sure that the power connection bolts have the same length, refer to Figure 1 for defective item and Figure 2 for correct installation.

Figure 1: Incorrect connection bolts Figure 2: Correct installation

1.8.4 Release the two bolts on the starter solenoid. Carefully pull the solenoid away from the starter housing until the dead stop. Make sure that the solenoid plunger is still attached, refer to Figure 3. Attach the solenoid to the starter with the two bolts.

Figure 3: Starter solenoid at dead stop

1.8.5 If the starter is OK, do step 1.8.7.

1.8.6 If the starter is not OK or in case of doubt, replace the Starter.

1121-144 MSB, Inspection of starter solenoid G 120A, A-I Grob Aircraft AG, Lettenbachstrasse 9, D-86874 Tussenhausen-Mattsies

Page 3OCROpen in PDF

MSB1121-144 Page 3 of 4 I GROB 14 July 2014 AIRCRAFT Replaces Issue:

1.8.7 Install the Engine Cowlings, refer to AMM Chapter 71-10.

1.8.8 Connect the aircraft battery, refer to AMM Chapter 24-31.

1.8.9 Release aircraft into service according to national requirements.

Part B Reserved for the terminating action

1.9 Repetitive Actions none II. PLANNING INFORMATION Material and Availability EZ Special Tools ₺°Z V/N 9°Z 1121-144 MSB, Inspection of starter solenoid G 120A, A-I Grob Aircraft AG, Lettenbachstrasse 9, D-86874 Tussenhausen-Mattsies

Page 4OCROpen in PDF

MSB1121-144 Page 4 of 4 I GROB 14 July 2014 AIRCRAFT Replaces Issue:

III. REMARKS The instructions in paragraph 1.8 have to be accomplished and certified in the logbook by authorized staff:

- in EASA countries according to Article 5 VO EG 2042/03 (VO EG 1056/2008) Appendix III - Part 66

- in non-EASA countries according to national regulations with respect to maintenance.

If you have sold your aircraft in the meantime, we kindly ask you to forward this information to the new owner and to provide us with the name and address of the new owner as well as with the respective serial number.

For questions and assistance please contact:

Product Support, phone: +49 8268 998105 fax: +49 8268 998200 e-mail: productsupport@grob-aircraft.com 1121-144 MSB, Inspection of starter solenoid G 120A, A-I Grob Aircraft AG, Lettenbachstrasse 9, D-86874 Tussenhausen-Mattsies