TCDS LTC-31

Type certificate data sheet · Rehr Louis S. · Aircraft · Small Airplane

Holder
Rehr Louis S.
Revision
3
Revised
August 24, 2015
Status
Current
Product
Aircraft · Small Airplane
Certification basis
CAR 9
Models
2

The release keeps the latest revision of each data sheet. Model names are as the data sheet lists them.

On this page

Models · 2

ModelAlso known asNote
Army AT-9Formerly Curtiss-Wright Corporation
Army AT-9AFormerly Curtiss-Wright Corporation

Airworthiness directives · 0

ADs whose products are models on this data sheet, matched by model and maker.

No ADs matched this data sheet’s models

STCs approved under this data sheet · 3

What the data sheet says

From the PDF’s text layer, line by line: tables lose their columns. The PDF is the record.

Page No. 1 2 3 Rev. No. 3 2 3 Reformatted 8/2015. DEPARTMENT OF TRANSPORTATION FEDERAL AVIATION ADMINISTRATION LTC-31 Revision 3 L. S. REHR (Curtiss) Army AT-9 Army AT-9A August 24, 2015 TYPE CERTIFICATE DATA SHEET NO. LTC-31 This data sheet (formerly Specification L-31-2) which is part of Limited Type Certificate No. 31, prescribes conditions and limitations under which the product for which the retype certificate was issued meets the airworthiness requirements of the Civil Air Regulations. Type Certificate Holder L. S. Rehr Coral Gables, Florida I. - Model Army AT-9 (Curtiss) (Limited Category), approved January 14, 1948, and II. - Model Army AT-9A (Curtiss) (Limited Category), approved January 14, 1948 Engine Lycoming R-680-9 Fuel 87 minimum octane aviation gasoline Engine Limits Maximum, except take-off (Sea level) 2200 rpm (285 hp) Take-off 2300 rpm (300 hp) Propeller Hamilton Standard 2B20 hub; 6135A-6 blades (8’6” diameter) or 6135A-15 blades (7’9” diameter) Airspeed Limits Glide or dive 230.0 mph (see NOTE 2 for other speed limitations) Maximum Weight 6000 lbs. C.G. Range 12 percet to 23 percent MAC 78.2 in. to 86.3 in. aft of datum Datum 123.0 in. forward of Jig Point MAC 73.9 in. L.E. MAC 69.4 in aft of Datum Other Operating Limitations Army Technical Orders 01-25KA-1 for the AT-9 and 01-25KB-1 for the AT-9A Certification Basis Limited Type Certificate No. 31 (CAR 9 effective 11/21/46) Production Basis None may be produced under this approval. Export Eligibility Not eligible for a Certificate of Airworthiness for Export LTC-31 Page 2 Equipment No equipment other than engine and propellers are specified. However, equipment as required by Civil Air Regulations Part 43.30 for the particular operation authorized for NC aircraft must be installed. Also, any additional equipment necessary for the proper operation of the aircraft. In addition, the aircraft may incorporate such military equipment (except armament) as was originally incorporated in the type for military or naval service. Additional equipment may be installed as can be substantiated on the basis that it presents no obvious hazard to safety. NOTE 1. Weight and Balance Report including list of equipment included in the certificated empty weight must be submitted for each aircraft. Army or Navy weight records in current condition may be submitted in lieu of an actual weight. The equipment list need include no more than the following: (a) Required equipment as defined under "Equipment" above. (b) Additional items as may be reasonably considered removable and are so located or of such weight that their removal or addition could noticeably affect the weight and balance of the aircraft. Items built into the aircraft structure need not be listed. The equipment list must be prepared by the applicant for the approval of the certificating C.A.A. representative, and in such form that it can be attached to the C.A.A. Operation Limitations. NOTE 2. The following placards must be prominently displayed in the positions indicated: (a) In full view of passengers: "This is a military type aircraft and under the Civil Air Regulations shall not be used for the carriage of passengers or cargo for compensation or hire." (b) In the cockpit in full view of the pilot: “Do not lower flaps above 140 mph.” “Do not lower landing gear above 140 mph.” “Do not lower landing lights above 140 mph.” “All acrobatic maneuvers prohibited.” NOTE 3. The following statement must appear on the Operation Limitations: "This airplane must be operated at all times within the limitations set forth in Army Technical Order No. AN-01-25KA-1 for the AT-9 and AN-01-25KB-1 for the AT-9A, except for limitations specifically called out in Aircraft Specification AL-31 in which case the values given in the Specification must be observed. A copy of pertinent Army Technical Order and Aircraft Specification AL-31 must be carried during flight." In all cases it will be the responsibility of the applicant to secure copies of the Army Technical Orders. The C.A.A. does not have these documents available for distribution. NOTE 4. If any repairs or modifications are made prior to and/or subsequent to NL certification, it is the responsibility of the owner to furnish sufficient evidence to a C.A.A. representative to show that the modified airplane maintains the same degree of airworthiness as the original. The C.A.A. can give no technical assistance on such matters since complete structural data for NL aircraft are not required by Part 9 and therefore are not available in the C.A.A. NOTE 5. Prior to obtaining certification for night operation, the following modifications to the exterior lighting must be made in order to comply with the general requirements of the Civil Air Regulations: (1) Position Lights (a) Wing Tip – The Type A-9 (AN-3033-10 or AN-3033-5 through -8) light assemblies may be satisfactorily modified by painting the sand blasted portion of the inner surface of the AN-1042-3 and -4 covers black. The AN-3033-9 or AN-3033-1 through -4 light assemblies are satisfactory without modification. (b) Tail - The present lights are unsatisfactory and must be replaced with a certificated unit. LTC-31 Page 3 (2) Position Light Installation The position lights shall be installed to comply with the requirements of the CAR, Part 03.538, and as follows: (3) Position Light Circuit and Control The position lights (wing tips and tail) shall be controlled by one SPST switch. The circuit should be protected by its own fuse or circuit breaker. The individual wing tip and tail light switches with dim and bright positions and the dimming resistors presently installed shall be removed. (4) Other Exterior lights With the exception of the landing light, any other exterior lights are not required and may be removed, if so desired. NOTE 6. On August 24, 2015 a search of all FAA files and records was conducted and no type design records were found. No original NL airworthiness certificates may be issued after 8/31/48. The list of mandatory changes required prior to original certification may be obtained from CAA Aircraft Service, Washington 25, D.C. Attn: A-298. ...END...