AC 29-2C

Change 2Historical

Advisory circular · Certification of Transport Category Rotorcraft

A newer version is currentThis is a historical version. AC 29-2C CHG 9 is the version in force, approved June 23, 2023.
Approved
April 25, 2006
Last reviewed
December 4, 2008
Family
AC 29-2 · 13 versions
Revision
C, change 2
14 CFR parts
29

Guidance, not mandatory unless a rule or AD requires it. DRS record last changed November 22, 2025.

Show pages 1030–1041
Page 1042Open in PDF

AC 29-2C, Chg 2 4/25/06

(5) Added Features Flight Test Considerations . Flight-testing should be used to verify the proper operation of additional implemented features (i.e. functions not defined by TSO C151b) such as:

Autorotation detection,

Tail Strike,

Bank angle,

Altitude call outs “Approaching Minimums,” or

Other features not listed here.

(6) Corrected Pressure Altitude Variations in Cold Weather. The HTAWS may be designed to account for the effects of cold weather on barometric altitude, while determining vertical position. Flight-testing may be required, unless a suitable verification procedure can be conducted. This will depend on the design of the cold weather compensation. This test is not required for systems that do not use corrected pressure altitude for cold weather compensation.

q. Rotorcraft Flight Manual (RFM) or Rotorcraft Flight Manual Supplement (RFMS).

The applicant should make an evaluation to determine if there are any limitations of the system and, if so, how they will affect aircraft operations. Any limitations affecting operations should be included in the RFM or RFMS. As a minimum, the applicant should provide instructions in the Limitations Section of the RFM or RFMS that include the following as appropriate (i.e., for systems approved on a no operational credit basis):

(1) Limitations. The following instructi ons should be included in the Limitations section of all RFMs or RFMSs:

(i) Navigation must not be predicated upon the use of the HTAWS information.

NOTE: The Terrain and Obstacle Display is intended to serve as a terrain and obstacle awareness tool only. The Display and database may not provide the accuracy or fidelity on which to base routine navigation decisions and plan routes to avoid terrain or obstacles.

(ii) The status of t he inclusion of Power Lines in the Obstacle Database must be stated.

Page MG 18 - 22

Page 1043Open in PDF

(iii) Low Altitude Mode must not be selected when operating under IMC conditions except as required when performing offshore platform IMC Approach Procedures or other Special Procedures.

(iv) The operator must select a range below 3 miles or an alternate range that has been demonstrated by the applicant to be appropriate when low altitude mode is activated on displays that do not auto-range.

(2) Operational Considerations for Normal and Abnormal Procedures. In addition to the GPWS operational procedures, consider the following:

(i) Terrain or Obstacle Awareness Caution. When a terrain or obstacle awareness CAUTION occurs, verify the aircraft flight path and correct it, if required.

(ii) Terrain or Obstacle Awareness Warning. When a terrain or obstacle awareness WARNING occurs, immediately initiate a maneuver that will provide maximum terrain or obstacle clearance, until all alerts cease.

(iii) Audio Inhibit. For those insta llations that include the ability to inhibit all or some of the HTAWS audio alerts, the Flight Manual (or Supplement) should state:

•When the audio inhibit function should be used.

•What alerts are inhibited.

•How long the alerts are inhibited.

•How to re-establish the alerts.

For Example: “For operations in day VFR conditions where terrain clearance may be assured visually and HTAWS audio alerts will hamper aircrew performance, the AUDIO INHIBIT button may be pushed to inhibit all HTAWS audio alerts. The audio alerts will resume five minutes after inhibit is selected or when the AUDIO INHIBIT button is pressed again.”

(iv) Altitude Reference. The Flight Manual (or Supplement) should explain how different altitude sources are blended to create the altitude used by the HTAWS. If the blended altitude is displayed to the pilot, a caution should state that ATC assigned or posted altitudes will be flown according to standard barometric altimeters with a correct altimeter setting. Blended altitudes may not provide adequate traffic separation. If the use of QFE altimeter settings adversely affects the performance of the HTAWS, procedures for QFE operations should be presented in the Flight Manual (or Supplement).

( v ) Environmental Requirements. For operations in cold weather, either the system should be able to account for variations in cold weather at temperatures at Page MG 18 - 23

Page 1044Open in PDF

AC 29-2C, Chg 2 4/25/06 or below zero degrees Celsuis, or additional flight crew procedures should be considered to address pressure altitude limits for vertical position determination.

Limitations may be needed to address insufficient determination of the aircraft’s vertical position in cold weather temperatures.

r. Instructions for Continued Airworthiness. Instructions for Continued Airworthiness are required by § 29.1529 as appropriate and in accordance with FAR/JAR 29 Appendix A. In addition to Appendix A requirements, the applicant should indicate when and how the terrain and obstacle databases need to be updated.

s. Additional Considerations to TSO C-151b Requirements for Helicopter Installation. Suggested consideration to TSO C-151b is provided below for helicopters installations. Items that are commentary only are italicized.

Class A

Additional Considerations to DO-161 Requirements

Mode 1

An Excessive Descent Rate warning function is not required but may be included optionally.

Mode 2

A Helicopter Class A TAWS should provide an Excessive Closure Rate to Terrain warning within a minimum of 8 seconds of impact with terrain. The system should provide a reduced nuisance free warning when in a landing flight profile. Provision should be made to prevent nuisance warnings during day VFR Low Altitude flying.

Mode 3

A Helicopter Class A TAWS should provide a warning of Excessive Altitude Loss during Takeoff. A warning should be generated if the aircraft losses more than 40% of its terrain clearance during takeoff. Takeoff is defined as at least the first 60 seconds of flights when greater than 50 knots and above 100 feet AGL.

Mode 4

A Helicopter Class A TAWS should provide a warning of Insufficient Terrain Clearance when not in a landing configuration (Gear Up) by 150 feet AGL for retractable gear aircraft. For fixed gear aircraft, a warning of Insufficient Terrain Clearance when not at landing speeds should be provided by 100 feet AGL. During an autorotation, improper landing gear configuration warnings should be provided in sufficient time to extend the gear before landing, based on specific helicopter autorotation performance, i.e. rate of descent and time to extend gear.

Page MG 18 - 24

Page 1045Open in PDF

Mode 5 No change is necessary for Mode 5.

Additional or Modified Requirements to TSO C-151b for Helicopter Installation Required Obstacle Clearance (ROC) and Required Terrain Clearance (RTC) By Phase of Flight

Alternate Figure AC 29.MG 18-2.1 is shown below.

TAWS REQUIRED TERRAIN CLEARANCE (RTC) BY PHASE OF FLIGHT Phase of Flight TERPS (ROC) TAWS (RTC) Level Flight

TAWS (RTC) Descending En route 1000 Feet 150 Feet 100 Feet Terminal (Intermediate Segment) 500 Feet 150 Feet 100 Feet Approach 250 Feet 150 Feet 100 Feet Departure (See Note 1) 48 Feet/NM 100 Feet 100 Feet

Note 1: During the Departure Phase of Flight, the FLTA function of Class A and B equipment should alert if the aircraft is projected to be within 100 feet vertically of terrain. However Class A and Class B equipment should not alert if the aircraft is projected to be more than 150 feet above the terrain.

Alternate FIGURE AC 29. MG 18-2.1 Page MG 18 - 25

Page 1046Open in PDF

AC 29-2C, Chg 2 4/25/06 Premature Descent Alert (PDA)

Since helicopters frequently land at off-airport sites, the PDA is inappropriate.

Voice Callouts

Sincehelicopters frequently operate at or below 500 feet AGL, this callout is inappropriate.

Altitude Accuracy A new requirem ent is proposed.

A means should be provided to compute actual MSL altitude and a Vertical Figure of Merit (VFOM). FLTA warning altitudes should compensate for estimated altitude errors.

Aural and Visual Alerts An addition to Table 4.1 of TSO C-151b is proposed.

Add the message “Warning Terrain” to Warning Aural Alert messages for Reduced Required Terrain Clearance and Imminent Impact with Terrain.

Low Altitude Mode A new helicopter requirement is proposed.

A means should be provided to manually select a reduced sensitivity state for Low Altitude and High Density Metropolitan operation.

Class B

Helicopter Additions/Replacements to DO-161A

Mode 1

Mode 1 is not a significant component of Helicopter CFIT accident history. Because of the complexity of Autorotation detection, Mode 1 should not be required for Class B helicopter equipment.

Mode 3

Adequate coverage for inadvertent descent after takeoff should be provided by the FLTA function, or other Mode 3 algorithm that prevents CFIT during takeoff. Takeoff is defined as at least the first 60 seconds of flights when greater than 50 knots and above 100 feet AGL.

Helicopter Additions/Replacements to TSO C-151b

Voice Callouts

Page MG 18 - 26

Page 1047Open in PDF

Since helicopters frequently operate at or below 500 feet AGL, this callout is inappropriate.

Test Conditions (Appendix 3)

Exclude TSO C-151b paragraphs 1.1 through 1.6 as not applicable.

TSO C-151b paragraph 1.7 applies as written.

TSO C-151b paragraphs 2.0 through 2.2 apply using Table G for speed cases of 100 through 160 knots.

TSO C-151b paragraphs 3.0 and 3.1 are excluded as not applicable.

TSO C-151b paragraphs 4.0, 4.2, and 4.3 apply as written. Case 4.1 is excluded as not applicable.

TSO C-151b paragraphs 5.0 and 5.1 are applicable as written.

TSO C-151b paragraphs 6.0 through 6.3 are to be determined.

TSO C-151b paragraphs 7.0, 8.0, and 9.0 are excluded as described above in sections

2.1 and 2.2.

Page MG 18 - 27

Page 1048Open in PDF

Page Apdx A - 1 AC 29-2C

APPENDIX A

INSTRUCTIONS FOR CONTINUED AIRWORTHINESS

Instructions for Continued Airworthiness (ICA) are required by Federal Aviation Regulations (FAR)/Joint Airworthiness Regulations (JAR) § 29.1529. Appendix A to FAR/JAR Part 29 specifies the requirements for Instructions for Continued Airworthiness. The following 70 pages for this AC 29-2C, Appendix A, provide a template for the ICA. This ICA Template was prepared to assist applicants in preparing an ICA for their type design change to rotorcraft.

The guidance is intended for applicants that are required to comply with FAR/JAR § 29.1529 to prepare Instructions for Continued Airworthiness acceptable to FAA/AUTHORITY.

The ICA Template contains requirements of Appendix A to FAR/JAR Part 29, identified by bold type. The bold type requirements are to be included in the applicant Instructions for Continued Airworthiness as applicable to the applicant’s type design change. Items in regular type are not required by FAR/JAR; however, these items are an aviation industry standard and are found in most current Instructions for Continued Airworthiness. The underlined words and sentences are to emphasize the information.

It is recommended the applicant include those in their ICA for standardization and clarity.

The ICA Template is arranged as a sample Instructions for Continued Airworthiness document and can be used as a template for the preparation of the applicant’s Instructions for Continued Airworthiness. The ICA Template was prepared to cover a complete rotorcraft. The applicant for a type design change need not include all information for the appropriate type design, only the applicable information to their type design change.

Appropriate text in regular type can be copied from the ICA Template. Text in italics and the appendices are for instructions and are not to be copied.

The ICA Template is formatted using the Airline Transport Association (ATA) Chapter numbering system. The ATA Chapter format is not required; however, it is recommended. The ATA chapter numbers that are not listed in this document do not relate to ICA’s and are not used in the ATA system for ICA’s (Maintenance Manual).

The Standard Practices chapters are broken out separately from the other listed chapters because they are not a requirement. However, Standard Practices are an industry standard and are found in most industry Maintenance Manuals.

Page 1049Open in PDF

AC 29-2C, Chg 1 2/12/03 Page Apdx A - 2 AC 29-2C

APPENDIX A

INSTRUCTIONS FOR CONTINUED AIRWORTHINESS (continued)

The set of parentheses in the index and chapters indicates the chapter on the ICA Template that is applicable to various ATA chapters. The set of parentheses in Figure 1 and Figure 2 is used to indicate the applicability of the item for that type design change.

Instructions for Continued Airworthiness will be reviewed and evaluated by FAA/AUTHORITY to ascertain their acceptability.

Page 1050Open in PDF

Page Apdx A - 3 AC29 APPENDIX A. INSTRUCTIONS FOR CONTINUED AIRWORTHINESS (MANUAL IDENTIFICATION)

INSTRUCTIONS FOR CONTINUED AIRWORTHINESS TEMPLATE

(COMPANY NAME)

INSTRUCTIONS FOR CONTINUED AIRWORTHINESS

(DRAWING/PHOTOGRAPH) (OPTIONAL)

(ROTORCRAFT MAKE AND MODEL)

REVISION: (DATE) Revision 4 Page i

Page 1051Open in PDF

AC 29-2C, Chg 1 2/12/03 Page Apdx A - 4 (MANUAL IDENTIFICATION)

THIS PAGE INTENTIONALLY LEFT BLANK

R E V I S I O N : ( PAGE NUMBER) Revision 4 Page ii

Page 1052Open in PDF

Page Apdx A - 5 (MANUAL IDENTIFICATION)

RECORD OF REVISIONS

REVISION NUMBER ISSUE DATE DATE

INSERTED

BY REVISION NUMBER ISSUE DATE DATE

INSERTED BY Original 08/04/97 09/03/97 E. R. THOMAS 1 01/30/98 02/14/98 E. R. THOMAS 2 06/18/98 07/02/98 E. R. THOMAS 3 10/21/99 11/01/99 E. R. THOMAS 4 08/04/00 08/24/00 E. R. THOMAS

R E V I S I O N : ( PAGE NUMBER) Revision 4 Page iii

Page 1053Open in PDF

AC 29-2C, Chg 1 2/12/03 Page Apdx A - 6 (MANUAL IDENTIFICATION)

THIS PAGE INTENTIONALLY LEFT BLANK

R E V I S I O N : ( PAGE NUMBER) Revision 4 Page iv