AD 2000-22-05

Airworthiness directive · Power Control Cable Assemblies · Short Brothers SD3-60 SHERPA

Effective
December 4, 2000
Published
October 30, 2000 · 65 FR 64601–64602
Issued
October 23, 2000
Supersedes
AD99-03-06
Model
SD3-60 SHERPA
Registered aircraft
11 matched by model
Product
Aircraft · Large airplane
Amendment
39-11951
Docket
2000-NM-202-AD
Issued as
Final rule

Unofficial copy from the Federal Register XML, document 00-27629. Only the govinfo PDF is the legal edition. DRS record last changed May 30, 2024.

On this page

Summary

This amendment supersedes an existing airworthiness directive (AD), applicable to all Short Brothers Model SD3-60 SHERPA series airplanes, that currently requires a one-time visual inspection to determine the part number of the power control cable assemblies and pulleys of the engine controls; and replacement of the power control cable assemblies and pulleys (as applicable) with new parts, if necessary. This amendment requires accomplishment of the inspection and replacement in accordance with revised procedures. This amendment is prompted by issuance of mandatory continuing airworthiness information by a foreign civil airworthiness authority. The actions specified by this AD are intended to prevent breakage of the power control cable assemblies due to the inflexible construction of the cable, which could result in loss of engine power and consequent reduced controllability of the airplane.

The airworthiness directive

2000-22-05 Short Brothers, PLC: Amendment 39-11951. Docket 2000-NM-202-AD. Supersedes AD 99-03-06, Amendment 39-11020.

Applicability: All Model SD3-60 SHERPA series airplanes, certificated in any category.

Note 1:

This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required as indicated, unless accomplished previously.

To prevent breakage of the power control cable assemblies due to the inflexible construction of the cable, which could result in loss of engine power and consequent reduced controllability of the airplane, accomplish the following:

(a) Inspection and Corrective Actions

PDF page 2

(a) At the next scheduled heavy maintenance inspection, but no later than 1,200 flight hours after the effective date of this AD: Perform a one-time inspection to determine the part number (P/N) of the power control cable assemblies and pulleys of the engine controls, in accordance with Part A of the Accomplishment Instructions of Shorts Service Bulletin SD3-60 SHERPA-76-1, Revision 2, dated March 21, 2000.

(1) If any power control cable assembly having P/N SD3-47-1091 or SD3-47-1094 is found, prior to further flight, replace the power control cable assembly with a new power control cable assembly in accordance with Part B of the Accomplishment Instructions of the service bulletin.

(2) If any pulley having P/N C181605 is found, prior to further flight, replace the pulley with a new pulley in accordance with Part C of the Accomplishment Instructions of the service bulletin.

(b) Spares

PDF page 2

(b) As of the effective date of this AD, no person shall install on the engine controls of any airplane a cable assembly having P/N SD3-47-1091 or SD3-47-1094, or any pulley having P/N C181605.

(c) Alternative Methods of Compliance

PDF page 2

(c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.

Note 2:

Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Manager, International Branch, ANM-116.

(d) Special Flight Permits

PDF page 2

(d) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

(e) Incorporation by Reference

PDF page 2

(e) The actions shall be done in accordance with Shorts Service Bulletin SD3-60 SHERPA-76-1, Revision 2, dated March 21, 2000, which contains the following list of effective pages:

Page No.Revision level shown on pageDate shown on page
1, 3, 4, 7, 13, 272Mar. 21, 2000.
2, 8, 10-12, 14-16, 23, 291Oct. 14, 1998.
5, 6, 9, 17-22, 24-26, 28OriginalJuly 1998.

This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Short Brothers, Airworthiness & Engineering Quality, P.O. Box 241, Airport Road, Belfast BT3 9DZ, Northern Ireland. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

(f) Effective Date

PDF page 2

(f) This amendment becomes effective on December 4, 2000.

Rule preamble

The FAA’s background, reasoning and cost estimate, published with the AD.

DatesPage 1

Effective December 4, 2000.

The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of December 4, 2000.

AddressesPage 1

The service information referenced in this AD may be obtained from Short Brothers, Airworthiness & Engineering Quality, P.O. Box 241, Airport Road, Belfast BT3 9DZ, Northern Ireland. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

For further information contactPage 1

Norman B. Martenson, Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2110; fax (425) 227-1149.

Supplementary informationPage 1

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) by superseding AD 99-03-06, amendment 39-11020 (64 FR 5588, February 4, 1999), which is applicable to all Short Brothers Model SD3-60 SHERPA series airplanes, was published in the Federal Register on June 30, 2000 (65 FR 40549). The action proposed to require a one-time inspection to determine the part number of the power control cable assemblies and pulleys of the engine controls; and replacement of the power control cable assemblies and pulleys (as applicable) with new parts, if necessary.

CommentsPage 1

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

ConclusionPage 1

The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Cost impactPage 1

The FAA estimates that approximately 28 airplanes of U.S. registry will be affected by this AD, that it will take approximately 15 work hours per airplane to accomplish the required actions, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $25,200, or $900 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory impactPage 1

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

Adoption of the amendmentPage 1

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

1. The authority citation for part 39 continues to read as follows:

2. Section 39.13 is amended by removing amendment 39-11020 (64 FR 5588, February 4, 1999), and by adding a new airworthiness directive (AD), amendment 39-11951, to read as follows:

Registered aircraft · 11

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Short Bros11 aircraft
By year built
19841998
Registered aircraft by year built: 11 aircraft
19842
19851
19975
19983

By model

Aircraft