AD 2025-12-06

Airworthiness directive · Time Limits/Maintenance Checks · Airbus Helicopters AS332L1

Effective
July 25, 2025
Published
June 20, 2025 · 90 FR 26198–26200
Issued
June 13, 2025
Model
AS332L1
Data sheet
TCDSH4EU
Registered aircraft
10 matched by model
Product
Aircraft · Rotorcraft
ATA chapter
05 · Time limits and maintenance checks
Amendment
39-23064
Docket
FAA-2025-0350
Project
MCAI-2023-00877-R
Issued as
Final rule

Unofficial copy from the Federal Register XML, document 2025-11346. Only the govinfo PDF is the legal edition. DRS record last changed November 21, 2025.

On this page

Summary

The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model AS332L1 helicopters. This AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. This AD requires revising the airworthiness limitations section (ALS) of the existing maintenance manual (MM) or instructions for continued airworthiness (ICAs) and the existing approved maintenance or inspection program, as applicable. The FAA is issuing this AD to address the unsafe condition on these products.

The airworthiness directive

2025-12-06 Airbus Helicopters: Amendment 39-23064; Docket No. FAA-2025-0350; Project Identifier MCAI-2023-00877-R.

(a) Effective Date

PDF page 2

This airworthiness directive (AD) is effective July 25, 2025.

(b) Affected ADs

PDF page 2

None.

(c) Applicability

PDF page 2

This AD applies to Airbus Helicopters Model AS332L1 helicopters, certificated in any category.

(d) Subject

PDF page 2

Air Transport Association (ATA) of America Code 05, Time Limits/Maintenance Checks.

(e) Unsafe Condition

PDF page 2

This AD was prompted by new or more restrictive airworthiness limitations. The FAA is issuing this AD to prevent failure of critical parts and primary structural components, which if not addressed, could result in loss of control of the helicopter.

(f) Compliance

PDF page 3

Comply with this AD within the compliance times specified, unless already done.

(g) Required Action

PDF page 3

Except as specified in paragraphs (h) and (i) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency AD 2023-0142, dated July 14, 2023 (EASA AD 2023-0142).

(h) Exceptions to EASA AD 2023-0142

PDF page 3

(1) Where EASA AD 2023-0142 refers to its effective date, this AD requires using the effective date of this AD.

(2) This AD does not adopt paragraphs (1), (2), (4), and (5) of EASA AD 2023-0142.

(3) Where paragraph (3) of EASA AD 2023-0142 specifies “Within 12 months after the effective date of this AD, revise the approved AMP,” this AD requires replacing that text with “Within 30 days after the effective date of this AD, revise the airworthiness limitations section of the existing maintenance manual or instructions for continued airworthiness and the existing approved maintenance or inspection program, as applicable.”

(4) The initial compliance time for doing the tasks specified in paragraph (3) of EASA AD 2023-0142 is on or before the applicable “limitations” and “associated thresholds” as incorporated by the requirements of paragraph (3) of EASA AD 2023-0142 or within 30 days after the effective date of this AD, whichever occurs later.

(5) This AD does not adopt the “Remarks” section of EASA AD 2023-0142.

(i) Provisions for Alternative Actions and Intervals

PDF page 3

After the action required by paragraph (g) of this AD has been done, no alternative actions and associated thresholds and intervals, including life limits, are allowed unless they are approved as specified in the provisions of the “Ref. Publications” section of EASA AD 2023-0142.

(j) Alternative Methods of Compliance (AMOCs)

PDF page 3

(1) The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the International Validation Branch, send it to the attention of the person identified in paragraph (k) of this AD and email to: AMOC@faa.gov.

(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

(k) Additional Information

PDF page 3

For more information about this AD, contact Adam Hein, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: (316) 946-4116; email: adam.hein@faa.gov.

(l) Material Incorporated by Reference

PDF page 3

(1) The Director of the Federal Register approved the incorporation by reference of the material listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) You must use this material as applicable to do the actions required by this AD, unless the AD specifies otherwise.

(i) European Union Aviation Safety Agency (EASA) AD 2023-0142, dated July 14, 2023.

(ii) [Reserved]

(3) For EASA material identified in this AD, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; phone: +49 221 8999 000; email: ADs@easa.europa.eu; website: easa.europa.eu. You may find the EASA material on the EASA website at ad.easa.europa.eu.

(4) You may view this material at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Parkway, Room 6N-321, Fort Worth, TX 76177. For information on the availability of this material at the FAA, call (817) 222-5110.

(5) You may view this material at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, visit www.archives.gov/federal-register/cfr/ibr-locations or email fr.inspection@nara.gov.

Rule preamble

The FAA’s background, reasoning and cost estimate, published with the AD.

DatesPage 1

This AD is effective July 25, 2025.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of July 25, 2025.

AddressesPage 1

AD Docket: You may examine the AD docket at regulations.gov under Docket No. FAA-2025-0350; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this final rule, the mandatory continuing airworthiness information (MCAI), any comments received, and other information. The address for Docket Operations is U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590.

Material Incorporated by Reference:

• For European Union Aviation Safety Agency (EASA) material identified in this AD, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; phone: +49 221 8999 000; email: ADs@easa.europa.eu; website: easa.europa.eu. You may find the EASA material on the EASA website at ad.easa.europa.eu.

• You may view this material at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Parkway, Room 6N-321, Fort Worth, TX 76177. For information on the availability of this material at the FAA, call (817) 222-5110. It is also available at regulations.gov under Docket No. FAA-2025-0350.

For further information contactPage 1

Adam Hein, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: (316) 946-4116; email: adam.hein@faa.gov.

BackgroundPage 1

The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to all Airbus Helicopters Model AS332L1 helicopters. The NPRM was published in the Federal Register on March 19, 2025 (90 FR 12691). The NPRM was prompted by AD 2023-0142, dated July 14, 2023 (EASA AD 2023-0142) (also referred to as the MCAI), issued by EASA, which is the Technical Agent for the Member States of the European Union. The MCAI states that new or more restrictive airworthiness limitations have been developed. EASA advises that airworthiness limitations and certification maintenance instructions are identified as mandatory for continued airworthiness and that Revision 9 of Airbus Helicopters Model AS 332 L1 ALS, dated July 27, 2022, has been issued to specify all service life limits and maintenance tasks for Model AS 332 L1 helicopters and separate the airworthiness limitations from the Master Servicing Manual.

In the NPRM, the FAA proposed to require revising the ALS of the existing MM or ICAs and the existing approved maintenance or inspection program, as applicable. The FAA is issuing this AD to prevent failure of critical parts and primary structural components, which if not addressed could result in loss of control of the helicopter.

You may examine the MCAI in the AD docket at regulations.gov under Docket No. FAA-2025-0350.

CommentsPage 2

The FAA received a comment from an individual who supported the NPRM without change.

ConclusionPage 2

These products have been approved by the civil aviation authority of another country and are approved for operation in the United States. Pursuant to the FAA's bilateral agreement with this State of Design Authority, that authority has notified the FAA of the unsafe condition described in the MCAI referenced above. The FAA reviewed the relevant data, considered any comments received, and determined that air safety requires adopting this AD as proposed. Accordingly, the FAA is issuing this AD to address the unsafe condition on these products. Except for minor editorial changes, this AD is adopted as proposed in the NPRM. None of the changes will increase the economic burden on any operator.

Material Incorporated by Reference Under 1 CFR Part 51Page 2

The FAA reviewed EASA AD 2023-0142, which requires replacing components before exceeding their life limits and accomplishing all applicable maintenance tasks within thresholds and intervals specified in the ALS as defined in EASA AD 2023-0142. Depending on the results of the maintenance tasks, EASA AD 2023-0142 requires accomplishing corrective action(s) or contacting Airbus Helicopters for approved instructions and accomplishing those instructions.

Additionally, EASA AD 2023-0142 requires revising the Aircraft Maintenance Programme (AMP) by incorporating the limitations, tasks, and associated thresholds and intervals described in the specified ALS, as applicable. Revising the AMP constitutes terminating action for the requirement to record accomplishment of the actions of replacing components before exceeding their life limits and accomplishing maintenance tasks within thresholds and intervals specified in the applicable ALS as required by EASA AD 2023-0142 for demonstration of AD compliance on a continued basis.

This material is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

Costs of CompliancePage 2

The FAA estimates that this AD affects seven helicopters of U.S. registry. Labor rates are estimated at $85 per hour. Based on these numbers, the FAA estimates the following costs to comply with this AD.

Revising the ALS of the existing MM or ICAs and the existing approved maintenance or inspection program, as applicable, takes 1 work-hour, for an estimated cost of $85 per helicopter and $595 for the U.S. fleet.

Authority for This RulemakingPage 2

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory findingsPage 2

This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Will not affect intrastate aviation in Alaska, and

(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

The amendmentPage 2

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

Adoption of the amendmentPage 2

1. The authority citation for part 39 continues to read as follows:

2. The FAA amends § 39.13 by adding the following new airworthiness directive:

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 10

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Aerospatiale3 aircraft
  • Airbus Helicopters3 aircraft
  • Eurocopter3 aircraft
  • Eurocopter France1 aircraft
By year built
19882006
Registered aircraft by year built: 10 aircraft
19881
19901
19911
19921
19931
19941
20001
20032
20061

By model

Aircraft