AD 82-12-02 R1

Airworthiness directive · Flap Structure · BH.125 Series 400A, BH.125 Series 600A, DH.125 Series 1A and 9 more

Effective
June 17, 1985
Models
BH.125 Series 400A, BH.125 Series 600A, DH.125 Series 1A, DH.125 Series 1A/R-522, DH.125 Series 1A/S-522, DH.125 Series 1A-522 and 6 more
Data sheet
TCDSA3EU
Registered aircraft
26 matched by model
Product
Aircraft · Large airplane
Amendment
39-5058

Unofficial copy of the text in the FAA’s Dynamic Regulatory System. The FAA’s own copy is the authoritative one. DRS record last changed May 30, 2024.

On this page

The airworthiness directive

82-12-02 R1 BRITISH AEROSPACE (HAWKER SIDDELEY): Amendment 39-4392 as amended by Amendment 39-5058. Applies to British Aerospace Model HS/BH/DH 125 up to and including series 700 airplanes certificated in all categories except those airplanes incorporating Modification 252772. To prevent structural failure of the flap, accomplish the following within the next 100 hours time in service after the effective date of this AD or before the accumulation of 600 hours time in service on the airplane, whichever is later, unless already accomplished.

1. Visually inspect the flap outboard hinge nose ribs for cracks in accordance with the instructions in paragraph 2A of British Aerospace, Aircraft Group, 125 Service Bulletin (SB) No. 57-58, Revision 3, dated September 1, 1983.

a. If no cracks are found, no further action is necessary.

b. If cracks are found during the inspection required by paragraph 1, above, which do not exceed the criteria in paragraph 2A(5) of the service bulletin, reinspect at intervals not exceeding 40 hours time in service from the last inspection until a permanent repair is incorporated.

c. If cracks are found during the inspection required by paragraph 1 or during the repetitive inspection required by paragraph 1.b, above, which exceed the criteria in paragraph 2A(5) of the service bulletin, replace the flap with a serviceable flap or contact the manufacturer for instructions to make a permanent repair before further flight.

2. Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a base for the accomplishment of inspections and/or modifications required by this AD.

3. Alternate means of compliance which provide an equivalent level of safety may be used when approved by the Manager, Seattle Aircraft Certification Office, FAA Northwest Mountain Region.

The manufacturer's specifications and procedures identified and described in this directive are incorporated hereinand made a part hereof pursuant to 5 U.S.C. 552(a)(1).

Amendment 39-4392 became effective June 8, 1982.

This amendment becomes effective June 17, 1985.

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 26

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • British Aerospace14 aircraft
  • Hawker Siddeley11 aircraft
  • Raytheon1 aircraft
By year built
19681984
Registered aircraft by year built: 14 aircraft
19681
19701
19711
19771
19781
19802
19811
19825
19841

12 with no year recorded

By model

Aircraft

See all 26 aircraft