- Registered owner
- Weber Justin L
- Location
- Temple, TX
- Owner type
- Individual
- Serial number
- 30190
- Type
- Fixed wing single engine
- Engine
- Reciprocating
- Airworthiness
- Standard, normal
- Airworthiness date
- February 14, 1969
- Certificate issued
- June 5, 2020
- Expires
- June 30, 2027
- Mode S code
- A9D905
From the FAA registry file of October 24, 2026. The registry lists only the engine series, so ADs for every Continental IO-520 model are included below.
On this page
Airworthiness directives that may apply · 54
Matched by this aircraft’s airframe and engine models. Each AD’s applicability may narrow it by serial number, part number or equipment.
| 1968 | 1 |
|---|---|
| 1969 | 1 |
| 1971 | 2 |
| 1972 | 2 |
| 1974 | 1 |
| 1975 | 1 |
| 1976 | 1 |
| 1977 | 2 |
| 1979 | 1 |
| 1980 | 2 |
| 1981 | 2 |
| 1986 | 2 |
| 1987 | 3 |
| 1988 | 3 |
| 1990 | 1 |
| 1991 | 1 |
| 1993 | 3 |
| 1994 | 1 |
| 1995 | 2 |
| 1996 | 2 |
| 1998 | 2 |
| 1999 | 1 |
| 2000 | 2 |
| 2004 | 1 |
| 2005 | 1 |
| 2006 | 1 |
| 2007 | 1 |
| 2008 | 1 |
| 2009 | 2 |
| 2010 | 1 |
| 2012 | 1 |
| 2014 | 2 |
| 2016 | 1 |
| 2022 | 3 |
| 2023 | 5 |
See all 66 ADs
Information bulletins that may apply · 12
Advisory, not mandatory.
Airframe · Bellanca 17-30
SAIB SW-18-31Navigation, Attitude, and Direction Data SystemEngine · Continental IO-520 series
SAIB NE-20-05POWERPLANT - Engine Camshaft Gear Tooth FractureSAIB NE-18-16POWERPLANT Alternator Drive CouplingSAIB NE-17-11POWERPLANT Engine damage as a result of kickbackSAIB NE-16-13Powerplant - Prohibited use of sealantSAIB NE-13-15Engine Controls: Continental Motors, Inc. (CMI) Throttle and Mixture Control LeversSAIB NE-13-04Continental Motors, Inc. (CMI) Connecting Rod Piston Pin Bushing InspectionSAIB NE-10-09Reciprocating Engine Power Section: Hydraulic Valve LiftersSAIB NE-10-07Reciprocating Engine Cylinder: Identification Information for Superior Air Parts, PMA Cylinder Heads for Teledyne Continental Motors (TCM) IO-520, TSIO-520,and IO-550 Series Engines.SAIB NE-09-08Reciprocating Engine Cylinder SectionSAIB NE-07-09R1Periodic Inspections of ECi Cylinder Assemblies for Cracks in the Aluminum HeadSAIB NE-02-41NTSB investigations · 1
Matched to this aircraft by N-number and event date, checked against the reported serial number, make and model.
FAA incident reports · 3
FAA accident and incident reports matched to this aircraft by N-number and event date, checked against the reported make and model.
Accident 20201005020599ACruise/Level Flight · San Saba, TXOn October 5, 2020. A Bellanca sv 1730-A, N7333V, departed temple Texas In route to midland Texas. At approximately 1421 CST, the engine lost Power. Pilot attempted to restart engine. Attempt failed. Notified air Traffic control and proceed to land at San…Incident 20101018050209ILanding: Touchdown · Columbus, TXAircraft lost electrical power and pilot made emergency landing. Pilot stated he was unable to get flaps or landing gear down. Upon touch down gear collapsed. Aircraft had minor damage and no injuries.Incident 19970823035169IFcd/Prec Ldg From Cruise · Pomonkey, MDNarrative: the pilot departed concord regional airport, NC, at approximately 0920 hours on a flight under visual flight rules. No flight plan was filed. According to the pilot's statement, the main and auxiliary (aux) fuel tanks were almost full during the…
Service difficulty reports
No reports matched to N7333VGeneral aviation reporting is voluntary. Matched to this aircraft by N-number and event date, checked against the reported serial number, make and model. Reports on Bellanca 17-30 aircraft
STCs that may be installed · 228
Approved for this aircraft’s airframe or engine model. The registry doesn’t record which STCs an aircraft has; its records do.
Airframe · Bellanca 17-30
STC SA02571SEInstallation of Garmin G500/G600 TXi Integrated Avionics System (Primary Flight Display, Multi-Function Display, and Engine Indicating System Display).STC SA01800SEFabrication and installation of new or replacement of existing instrument panel lights dimmer control.STC SA01861SEFabrication and installation of Landing Light Controller