- Holder
- Carlisle Richard R.
- Revision
- 3
- Revised
- July 31, 2015
- Status
- Current
- Product
- Aircraft · Small Airplane
- Certification basis
- Part 3, Part 15, CAR 9
- Models
- 1
- Registered
- 15 aircraft
The release keeps the latest revision of each data sheet. Model names are as the data sheet lists them.
On this page
Models · 1
| Model | Also known as | Note |
|---|---|---|
| FM-2 (Navy) | Formerly Grumman |
Airworthiness directives · 0
ADs whose products are models on this data sheet, matched by model and maker.
No ADs matched this data sheet’s models
Registered aircraft
Registry models that point at this data sheet, with their registered aircraft.
STCs approved under this data sheet · 8
STC SA4503NMRemove original cloth covering and install Ceconite coveringSTC SA04776NYThe HIPEC Covering and Finishing System must be performed and maintainedSTC SA241CHInstall Ceconite 101 fabric.STC SA8075SWInstallation of fiberglass covering. (M-62 SERIES PT-19) (G-73 SCHWEIZER)STC SA1008WEInstallation of Poly-Fiber covering material.STC SA1351WEReplace existing fabric on wings, fuselage, empennage, and/or control surfaces, with Ceconite101 material. (262A Series -12)STC SA4-1210Installation of Eonnex cover on aircraft surfaces.STC SA4-1613Ceconite 101 covering of all fabric covered control surfaces.
What the data sheet says
From the PDF’s text layer, line by line: tables lose their columns. The PDF is the record.
Page No. 1 2
Rev. No. 3 3
DEPARTMENT OF TRANSPORTATION
FEDERAL AVIATION ADMINISTRATION
LTC 25
Revision No. 3
RICHARD R. CARLISLE
FM-2 (Navy)
July 31, 2015
TYPE CERTIFICATE DATA SHEET NO. LTC 25
This data sheet (formerly Specification L-25-2), which is part of Type Certificate No. LTC 25, prescribes conditions and
limitations under which the product for which the Type Certificate was issued meets the airworthiness requirements of the Civil
Aviation Regulations (CAR).
Limited Type Certificate Holder: Richard R. Carlisle
Tarrant, Alabama
I. - Model FM-2 (Grumman Navy) 1PCLM (Limited Category) approved November 5, 1947
Engine Wright R-1820-56
Fuel 100/130 minimum grade aviation gasoline
Engine Limits H.P. R.P.M. M.P.(In. Hg.) ALT.
For Engines identified by letter "N" stamped on engine data plate in blank labeled "Master Rod Location":
Low Blower:
Takeoff 1,300 2,500 46.5 S.L.
Max. Continuous 1,200 2,500 44.0 S.L.
Max. Continuous 1,200 2,500 43.5 2,500 ft.
High Blower:
Max. Continuous 900 2,500 44.0 11,200 ft.
Max. Continuous 900 2,500 43.5 17,000 ft.
For Engines not identified as described above:
Low Blower:
Takeoff 1,200 2,500 43.5 S.L.
Max. Continuous 870 2,300 35.0 S.L.
Max. Continuous 940 2,300 35.0 7,500 ft.
High Blower:
Max. Continuous 770 2,300 35.0 14,500 ft.
Max. Continuous 800 2,300 35.0 19,500 ft.
Propeller Curtiss C5325D-A20 or -A32 hub; 109354 blades
Diameter 10’0”, Low pitch 20 degrees, High pitch 55 degrees
Airspeed limits No restrictions except those indicated in NOTE 2.
Maximum weight 7,500 pounds
C.G. range 26 percent to 31 percent MAC gear down
Datum 80 inches forward of leading edge of wing at root chord
MAC 84.14” L.E. MAC 83.3 aft of datum
Other operating Navy Technical Order 13-44 dated 2/7/44 (also see NOTE 3 for operating limitations)
limitations
LTC 25 Page 2
Certification basis Limited Type Certificate No. 25 (CAR 9 effective 11/21/1946)
Production basis None may be produced under this approval
Export eligibility Not eligible for a Certificate of Airworthiness for Export
Equipment: No equipment other than engines and propellers are specified. However, such equipment as required by Civil Air
Regulations Part 43.30 for the particular operation authorized for NC aircraft must be installed. Also, any additional
equipment necessary for the proper operation of the aircraft.
In addition, the aircraft may incorporate such military equipment (except armament) as was originally incorporated
in the type for military or naval service. Additional equipment may be installed as can be substantiated on the basis
that it presents no obvious hazard to safety.
NOTE 1. Weight and Balance Report including list of equipment included in the certificated empty weight must be submitted
for each aircraft. Army or Navy weight records in current condition may be submitted in lieu of an actual weight.
The equipment list need include no more than the following:
(a) Required equipment as defined under “Equipment” above.
(b) Additional items as may be reasonably considered removable and are so located or of such weight that their
removal or addition could noticeably affect the weight and balance of the aircraft. Items built into the aircraft
structure need not be listed. The equipment list must be prepared by the applicant for the approval of the
certificating C.A.A. representative, and in such form that it can be attached to the C.A.A. Operation Limitations.
NOTE 2. The following placards must be prominently displayed in the positions indicated:
(a) In full view of passengers: "This is a military type aircraft and under the Civil Air Regulations shall not be used
for the carriage of passengers or cargo for compensation or hire."
(b) In the cockpit in full view of the pilot:
Wing Flaps - Recommended do not lower above 150 mph.
Landing Gear - Recommended do not lower above 172 mph.
Maneuvers Prohibited: (a) Inverted flight,
(b) With external wing tanks: Loops, snap rolls, chandelle, Immelman turn, spins.
NOTE 3. The following statement must appear on the Operation Limitations:
"This airplane must be operated at all times within the limitations set forth in the Pilots Operating Handbook,
Technical Order No. 01-190FB-1, 9/15/45, except for limitations specifically called out in Aircraft Specification
AL-25 in which case the values given in the Specification must be observed. A copy of Navy Technical Order 01-
190FB-1 and Aircraft Specification AL-25 must be carried during flight."
In all cases it will be the responsibility of the applicant to secure copies of the Technical Orders. The C.A.A. does
not have these documents available for distribution.
NOTE 4. If any repairs or modifications are made prior to and/or subsequent to NL certification, it is the responsibility of the
owner to furnish sufficient evidence to a C.A.A. representative to show that the modified airplane maintains the
same degree of airworthiness as the original. The C.A.A. can give no technical assistance on such matters since
complete structural data for NL aircraft are not required by Part 9 and therefore are not available in the C.A.A.
NOTE 5. Prior to obtaining certification for "Night Flying" the following modifications to the exterior lighting must be made
to comply with CAR, Part 15.2 and 3.538:
(a) Position Lights
(1) Wing Tip - If AN-3032 or AN-3033 light assemblies are not installed the wing lights should be replaced
with type certificated lights.
(2) Tail - The AN-3091 or AN-3092 light assemblies are unsatisfactory and must be replaced with a type
certificated tail unit.
(b) Position Light Circuit and Control
The position lights (wing tips and tail) shall be controlled by one SPST switch. The circuit shall be protected by its
own fuse or circuit breaker. The individual wing tip and tail light switches with dim and bright positions and the
dimming resistors, presently installed, shall be removed.
(c) Other Exterior Lights
Any other exterior lights are not required and may be removed, if so desired.
NOTE 6. On July 29, 2015 a search of all FAA files and records was conducted and no type design records were found.
No original NL airworthiness certificates may be issued after 8/31/48. The list of mandatory changes required prior to original
certification may be obtained from CAA Aircraft Service, Washington 25, D.C. Attn: A-298.
…END…